5
Setting the clock time
-The clock must be set with the unit switched off. Time 1 is to set the normal
time and Time 2 can be set to view an additional world time.
•A single press of the Down/minute button or Up/hour button advances the
setting by one hour or one minute. If the button is held setting will advance rapidly.
•While listening to the radio you can check TIME 1 and TIME 2 as follows:
Press Dual time button for 5 seconds, the display will show TIME 1, press the
dual time button again for 5 seconds, the display will show TIME 2.
Press the power button twice to return to the frequency display.
To set Time 1 (normal time)
1 Time 1 will be displayed when power is applied to the unit.
2Press the Memory time button (a) once, the clock display will flash. You must
adjust the time while the clock display is flashing.
3Now set the correct time with the Down/minute button
(to set minutes) Up/hour button (to set hours).
4Press the Memory time button (a) to save the setting or
wait 5 seconds, and the time display will be saved
automatically.
To set Time 2 (world time)
1Press the Dual time button (a), ‘Time 2’ will appear on
the display.
2Press the Memory time button (b) once, the clock
display will flash. You must adjust the time while the
clock display is flashing.
3Now set the correct time with the Up/hour button (c)
(to set hours).
Note : only the hour segment should be changed.
This is to comply with world time zone differences
from GMT which are always + or - hours.
•When the clock reaches midday the AM symbol will
change to PM.
a
ab
c
