Morse KONTROL-KARRIERS 185 Series Bedienungsanleitung

OPERATORS MANUAL FOR MORSE 185 Series Kontrol-Karriers

Serial # 0285-0693 (MMYY)

Model 185A for 55 gallon standard steel drums (22½” diameter)

Model 185B for 30 gallon standard steel drums (19” diameter)

Model 185C for steel or fibre drums (21-23” diameter)

Model 185D for steel or fibre drums (19-20½” diameter)

A. IMPORTANT:

1. Review the Material Safety Data Sheet(s) for the material(s) in the drum(s) and take all necessary precautions. Safety

shoes, work gloves, hard hat and other personal protective devices are recommended.

2. Please read all instructions

thoroughly

before attempting to operate your new MORSE drum handler.

3. The model 185A, B, C, or D hava a maximum capacity rating of 800 Lb. FULL drum and 500 Lb. HALF-FULL drum and are

designed to lift, move and pour

drums of size and type noted above.

DO NOT

exceed these ratings. Exceeding these

ratings or handling drums other than those mentioned above is unsafe and could result in equipment damage, excessive

wear or awkward handling.

4. When loading, unloading, operating, or maintaining your MORSE drum handler, always use care and good judgment.

Maintain secure footing and a firm hold. Keep hands and loose clothing away from all moving parts. Never allow anyone

to be below any part of a raised drum handler or drum. Read operating instructions and review the pictures in the sales

brochure before operation.

B. OPERATING INSTRUCTIONS:

1. With Kontrol-Karrier standing on the floor, lower hoist and engage hoist hook into the lifting eye.

2. Raise hoist to lift Kontrol-Karrier clear of floor and move it to the drum.

3. Position Kontrol-Karrier at a height which aligns the saddle band with the center of the drum.

4. With the cinch chains hanging freely, push Kontrol-Karrier against the drum so that saddle will encircle the drum.

5. Drape the cinch chain across the front of the drum and insert one link into the slot on the ratchet handle .Turn the ratchet

handle clockwise to tighten the cinch chain around the drum (see detail).

6. Raise hoist and position the drum at the pouring station.

7. Pour the drum by pulling on the pull chain and rotating the drum to a suitable pouring angle. For best control of drum

pouring angle, pay out one side of the loop while pulling in the other side, thus being able to hold back the drum rotation

after the load shifts.

8. After pouring is completed, rotate the drum back to vertical position and lower hoist to return drum to floor.

9. To remove drum: Pull ratchet handle to relieve pressure on ratchet teeth. Lift pawl handle to release teeth engagement and

rotate ratchet to loosen chain and allow its removal from notch.

CAUTION:

DO NOT allow drum to impact on floor,ground,or dumping station,etc.

CAUTION:

DO NOT exceed weight capacity of 800 Lb. for FULL drum, 500 Lb. for HALF-FULL drum.

C. MAINTENANCE:

1. Lubricate gear teeth and roller chain.

2. Clean and oil ratchet, pawl, saddle hinge, and other moving parts periodically. (Clean & lubricate more often in environments

where dust, dirt or other foreign particles will effect the performance of moving parts.)

3. Periodically inspect all moving parts, framework, and contact areas for signs of wear, fatigue, or loosening. Tighten adjust or

replace parts as necessary to prevent failure and maintain proper function.

MORSE MFG. CO., INC. • 727West Manlius Street • P.O. Box 518 • East Syracuse, NY 13057-0518

Phone: 315-437-8475 • Fax: 315-437-1029 • Email: service@MORSEmfgco.com • Website: www.MORSEmfgco.com

185 SERIES

KONTROL-KARRIERS

The Specialist In Drum Handling Equipment

PARTS LIST

Website: www.MORSEmfgco.com

185 SERIES

KONTROL-KARRIERS

TheSpecialistIn Drum HandlingEquipment

MORSE MODEL 185 SERIES KONTROL-KARRIERS

Serial Number 0285 - 0693 (MMYY)

MODELS 185A, 185B, 185C, 185D

ITEM # LETTERSUFFIX

see note#1 QUANTITY PART # DESCRIPTION

1 1 1-P CHAIN WHEEL #1-1/2 W/ GUIDE

2 12 2-P PULL CHAIN,1/0, PER FT

3 1 2-185-P PULL CHAIN, 1/0,12' LENGTH

4 1 3-P TRIANGLE & SHAFT W/ BOLTS

5 2 735-P KEY, WOODRUFF, SIZE 9, ASA606

6 3 35-P 5/16 - 18 X1 HHCS GR 2

7 1 19-P BEARING, 3/4"ID X2-1/2"

8 1 15-P COLLAR,3/4"ID

9 1 7-P BEARING, 3/4"ID X1-1/2"

10 1 16-P COLLAR,1" ID

11 1 18-P BEARING, 1"ID X2-1/2"

12 3 33-P ALEMITE GREASE FIT

13 2 55-P WASHER,3/4 SAE FL 1-1/2 OD

14 1 11-P SPROCKET,#35 12T, 3/4"BORE

15 1 12-P CHAIN,ROLLER,#35 W/ MLINK

16 1 795-P LINK,MASTER, #35 CHAIN

17 1 13-P SPROCKET#35 36T,3/4" BORE

18 1 14-P GEAR,PINION,7 TOOTH

19 1 29-P SPACER,SPUR GEAR .15"

20 2 22-P 3/8 - 24 x5/8"SHCS

21 1 23-P GEAR,SPUR,72T,1"HOLE

22 1 47-P OVERHEAD LIFT YOKE 185AW/BRG

23 A 1 112A-P SADDLE ASM, 185A

23 B 1 112B-P SADDLE ASM, 185B

23 C 1 112C-P SADDLE ASM, 185C

23 D 1 112D-P SADDLE ASM, 185D

24 A 1 113A-P SADDLE WELD, 185A

24 B 1 113B-P SADDLE WELD,185B

24 C 1 113C-P SADDLE WELD, 185C

24 D 1 113D-P SADDLE WELD, 185D

25 1 155-P 3/8 - 16 X2-1/2 HHCSGR 2

26 A,B 1 180-P CHAIN,CINCH,3/16 ALLOY33 LK

27 C,D 1 E14 FIBRE DRUMSTRAP 14"

28 1 64-P ROLL PIN,3/16 X1-1/4

29 1 136-P HANDLE GRIP,7/8" X4-3/4"

30 1 169-P PAWL SPRING

31 1 170-P 3/8" DIAX5/8"SHOULDER SCREW

32 1 168-P PAWL,WITH DRILLED HOLE

33 1 710-P RETAINER,RATCHETPUSH ON 3/4"

34 1 165-P RATCHET,MALLEABLE,SADDLE

35 1 165KIT-P KIT, RATCHET CHAIN TIGHTENER

36 B,D 1 720-P HINGE BOLT & NUT, 1/4"

37 B,D 1 731-P RATCHETHINGE PLATE ONLY1/4 A

38 B,D 1 726-P RATCHETHINGE PLATE CPT1/4" A

Note #1: If

no letter is shown

, the part is for Models 185A, 185B, 185C, or

185D. If a letter is shown, the part is for the model with that letter suffix only.

Note #2: "Saddle Assembly" includes the saddle weld and appropriate

attached moving parts, such as 25, 26 or 27, 35 or 36 and 38. "Saddle Weld"

has no moving parts.

PARTS DIAGRAM FOR

MORSE 185 Series Kontrol-Karriers

Serial # 0285-0693 (MMYY)

For replacement parts, please contact

your Morse dealer.

When ordering parts, please specify:

- Part number and description,

- Model number

- Serial number

Find model number and serial number on

metal name plate attached to frame.

185 SERIES

KONTROL-KARRIERS

TheSpecialistIn Drum HandlingEquipment

Website: www.MORSEmfgco.com

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere morse Lagerung Handbücher

morse

morse 400AM-60-124 Bedienungsanleitung

morse

morse 410-124 Bedienungsanleitung

morse

morse 400A-96-110 Bedienungsanleitung

morse

morse 185G Bedienungsanleitung

morse

morse 400A-60-114 Bedienungsanleitung

morse

morse 400A-60-124 Bedienungsanleitung

morse

morse 400A-72 Bedienungsanleitung

morse

morse 400A-96-115 Bedienungsanleitung

morse

morse 0409 Bedienungsanleitung

morse

morse 515-N-124 Bedienungsanleitung

morse

morse 287-2H Bedienungsanleitung

morse

morse 185HD SERIES Bedienungsanleitung

morse

morse MORCINCH 4556-P Bedienungsanleitung

morse

morse 400A-96-125 Bedienungsanleitung

morse

morse Omni-Lift Karrier Bedienungsanleitung

morse

morse 400A-96-124 Bedienungsanleitung

morse

morse 185R Bedienungsanleitung

morse

morse 400A-96SS Bedienungsanleitung

morse

morse MORCINCH 4556SS-P Bedienungsanleitung

morse

morse 82A-SS Bedienungsanleitung

morse

morse 400AM-96 Bedienungsanleitung

morse

morse 400A-72 Bedienungsanleitung

morse

morse Hydra-Lift 400A-60 Bedienungsanleitung

morse

morse 0409 Bedienungsanleitung

Beliebte Lagerung Handbücher anderer Marken

QNAP

QNAP TS 32PXU Series Bedienungsanleitung

LaCie

LaCie RUGGED RAID Bedienungsanleitung

Freecom

Freecom CLS DOCK Bedienungsanleitung

PNY

PNY Attache P-FD64MBATT3 Bedienungsanleitung

HP StorageWorks MSL2024 Bedienungsanleitung

OLT

OLT 6x6 Maximizer Bedienungsanleitung

Transcend

Transcend JetFlash 160 Bedienungsanleitung

LaCie

LaCie RUGGED MINI Bedienungsanleitung

Thunderbolt

Thunderbolt 600 Bedienungsanleitung

Panasonic

Panasonic LB-DH8 series Handbuch

Intel

Intel RAID High Availability Bedienungsanleitung

LaCie

LaCie 12big Thunderbolt 3 Bedienungsanleitung

Spectra Logic

Spectra Logic T-Series Spectra T50e Bedienungsanleitung

Panasonic

Panasonic LKM-F931-1 Bedienungsanleitung

Tabernus

Tabernus Enterprise Erase E2400 Bedienungsanleitung

Rocstor

Rocstor COMMANDER 3F series Bedienungsanleitung

HP P9000 Bedienungsanleitung

Western Digital

Western Digital Ultrastar Data60 Bedienungsanleitung

morse KONTROL-KARRIERS 185 Series Bedienungsanleitung

Beliebte Lagerung Handbücher anderer Marken