Motorola V3 Bedienungsanleitung

Motorola GmbH, CSS Center, Mobile Devices

Doc. No: TSG_V3

Version: 1.1

Date: 09.06.2005

Title: Troubleshooting-Guide V3 Page: 1 / 11

Motorola internal use

Motorola GmbH, CSS Center, Mobile Devices

Doc. No: TSG_V3

Version: 1.1

Date: 09.06.2005

Title: Troubleshooting-Guide V3 Page: 2 / 11

Motorola internal use

Table of contents

1.0 Preamble

2.0 Some basic tips

3.0 Top 10 defective parts

4.0 Most frequent failure codes and root causes

Troubleshooting

5.0 U700

5.1 U50

5.2 Keyboard Flex Assy

5.3 U900

5.4 U800

5.5 Display

5.6 J 41

5.7 J-Keyboard

Modified Date By

9. June 2005 L. Heide

Motorola GmbH, CSS Center, Mobile Devices

Doc. No: TSG_V3

Version: 1.1

Date: 09.06.2005

Title: Troubleshooting-Guide V3 Page: 3 / 11

Motorola internal use

1.0 Preamble

This document was created to assist analyzers when fixing problems on Motorola

GSM Phones. All information was collected during the repair in the Repairentitlement

Group Flensburg.

Motorola GmbH, CSS Center, Mobile Devices

Doc. No: TSG_V3

Version: 1.1

Date: 09.06.2005

Title: Troubleshooting-Guide V3 Page: 4 / 11

Motorola internal use

2.0 Some basic tips

2.1Software upgrade

- always use the latest Software available for the phone (Software- bugs are

excluded)

2.2Visual inspection

- check for liquid damage (water indicator)

- check for missing, broken or unsoldered parts

- check for mechanical damage (board twisted, tracks defect etc.)

2.3Cross check

- before beginning to replace/change parts or soldering anything

try to consider the failure from all sides.

2.4Solder process

- the soldering process of lead-free products always must be done with the aid

of a bottom-heater and flux for lead-free soldering

- always cover sensitive parts with shields

Motorola GmbH, CSS Center, Mobile Devices

Doc. No: TSG_V3

Version: 1.1

Date: 09.06.2005

Title: Troubleshooting-Guide V3 Page: 5 / 11

Motorola internal use

3.0 Top 10 Defects

- Fig. 1 shows a analysis-summary of the phones repaired in NPI- process

related to the first repair works at all.

Fig. 1

Motorola GmbH, CSS Center, Mobile Devices

Doc. No: TSG_V3

Version: 1.1

Date: 09.06.2005

Title: Troubleshooting-Guide V3 Page: 6 / 11

Motorola internal use

4.0 Most frequent failure-codes - related root causes

TON -

U700, U800 ,U900, Keyboard Flex Assy ,J Keyboard, Y900, Y805

MKP -

Keyboard Flex Assy, J Keyboard

CHG

U900

CPR -

U50, U800

DIM -

Display, Keyboard Flex Assy, J Keyboard

DIS -

Display

ALT -

U900

AUD -

J41, U900

BAT -

U50

Motorola GmbH, CSS Center, Mobile Devices

Doc. No: TSG_V3

Version: 1.1

Date: 09.06.2005

Title: Troubleshooting-Guide V3 Page: 7 / 11

Motorola internal use

5.0 U700 Flash-Part / EE-Prom / SRAM

Customer complaint

- TONxx

1. Check the phone with a test battery. When the phone turns on, check the

customers charger and battery.

2. Disassemble the phone and try to boot the PCB with EMU connector if the

phone starts up, check the customers housing.

3. If the phone starts in flash-mode (yellow status) when connecting with the

EMU connector, try to reflash with 1FF-flash file. If this is not successful

replace U700.

4. When the phone starts in blank- mode (yellow status)when connecting with the

EMU connector, try to make a reflash with an Image-flash file. If is this not

successful replace U700

5. If the phones current drain is ~55mA (red status) and decreases after a few

seconds to ~6mA when connecting with the EMU connector also replace

U700.

5.1 U50 Power-Amplifier (Eagle-IC)

Customer complaint

- CPRxx / TONxx

1. Connect the phone with the EMU connector while monitoring the current

drain. If U50 (PA) is defect, you could have a short to ground (board does not

start/disconnects immediately). Occasionally the PA draws slightly more than

the nominal current (check nominal current with a reference-board ~40mA). If

the PA gets hot, replace the PA (U50).

2. Check TX-output spectrum by setting the phone in TX-mode using the

spectrum-analyzer. Compare level and shape of the spectrum with a

reference-board if the level is to low or the spectrum looks bad replace U50.

3. Also check to the time mask with a GSM-Test-Set. If the signal does not

conform to specifications, replace U50.

Motorola GmbH, CSS Center, Mobile Devices

Doc. No: TSG_V3

Version: 1.1

Date: 09.06.2005

Title: Troubleshooting-Guide V3 Page: 8 / 11

Motorola internal use

5.2 Keyboard Flex Assy

Customer complaint

- MKPxx / DIMxx / TONxx / DISxx

1. If some or all keys are not working or power up is impossible with the on/off

key, then perform a cross check with reference-housing. When all keys are

working, replace the Keyboard Flex Assy.

2. When the keyboard backlight is defect or intermittent, make a cross check

and if necessary change Keyboard Flex Assy.

3. If the display shows strange symbols or nothing at all also make a cross

check and replace Keyboard Flex Assy if it is necessary.

5.3 U900 PCAP 3

Customer complaint

- TONxx / ALTxx / CHGxx

1. If the multi-media ring tones are not working, replace U900.

2. When the charging process is not working, U900 could be defect.

3. Check these voltages, if the phone has a power up problem. Connect PCB

with EMU Connector and check the current drain. If the current drain is only

~ 0.6 mA, measure following voltages:

VBoost ~ 5.8V at C921

VBuck ~ 1.9V at L920

RF 5V REG ~ 5,0V at C933

Please refer to Fig. 2

Motorola GmbH, CSS Center, Mobile Devices

Doc. No: TSG_V3

Version: 1.1

Date: 09.06.2005

Title: Troubleshooting-Guide V3 Page: 9 / 11

Motorola internal use

If these Voltages are not present change U900.

Fig. 2

5.4 U800 Processor (Neptune)

Customer complaint

- TONxx

1. If all the voltages of PCAP 3 are present, the crystals

(Y805 and Y900) begin to oscillate and the flash-part has previously been

replaced, a defect U800 could cause the problem too.

VBuck ~ 1.9 V

RF 5V REG ~ 5 V

VBoost ~ 5.8 V

Motorola GmbH, CSS Center, Mobile Devices

Doc. No: TSG_V3

Version: 1.1

Date: 09.06.2005

Title: Troubleshooting-Guide V3 Page: 10 / 11

Motorola internal use

5.5 Display

Customer complaint

- DISxx / DIMxx

1. If the display has missing pixels or a missing line replace it.

2. If the secondary display shows only backlight or is completely dead, change

the display.

3. If the display shows strange symbols, make a cross check with a reference-

housing and a reference-flip and act accordingly.

5.6 J41 MIC

Customer complaint

- AUDxx

1. If TX-audio is missing, buzzing or is to low set PCB in audio

loop mode and check at C1202-2 mic bias voltage ~ 2.15 V

from PCAP (Fig. 3). If the bias voltage is present, measure using an

oscilloscope measure at C1202-1 int-micp ~1V. While speaking into the

microphone check for audio signals on your oscilloscope.

Fig. 3

audio

waves

mic

bias

voltage

Andere Handbücher für V3

Andere Motorola Handy Handbücher

Motorola

Motorola V.100 Bedienungsanleitung

Motorola

Motorola EX124G Bedienungsanleitung

Motorola

Motorola W230 Bedienungsanleitung

Motorola

Motorola BRUTE i686 Bedienungsanleitung

Motorola

Motorola C330 Bedienungsanleitung

Motorola

Motorola M470 Bedienungsanleitung

Motorola

Motorola MOT00 Bedienungsanleitung

Motorola

Motorola M3288 Bedienungsanleitung

Motorola

Motorola Motokey Social Bedienungsanleitung

Motorola

Motorola D160 Bedienungsanleitung

Motorola

Motorola V3620 Bedienungsanleitung

Motorola

Motorola I412 Bedienungsanleitung

Motorola

Motorola CLIQ TM1668 Leitfaden

Motorola

Motorola Moto X Style Bedienungsanleitung

Motorola

Motorola RAZR HD Bedienungsanleitung

Motorola

Motorola XT611 Bedienungsanleitung

Motorola

Motorola V620 Bedienungsanleitung

Motorola

Motorola Moto G9 Plus Bedienungsanleitung

Motorola

Motorola FLIPSIDE Bedienungsanleitung

Motorola

Motorola ATRIX Bedienungsanleitung

Motorola

Motorola V525 Betriebshandbuch

Motorola

Motorola XT320 Bedienungsanleitung

Motorola

Motorola i90c Bedienungsanleitung

Motorola

Motorola V195s Bedienungsanleitung

Beliebte Handy Handbücher anderer Marken

Zte

Zte BLADE A520 Bedienungsanleitung

Nokia

Nokia Lumia 620 Bedienungsanleitung

Blackbe;rry

Blackbe;rry KEYone Bedienungsanleitung

Bea-fon

Bea-fon X5 Premium Bedienungsanleitung

Blackbe;rry

Blackbe;rry 8707 Series Bedienungsanleitung

Blackbe;rry

Blackbe;rry Storm Betriebsanleitung

LG LM-X420QN Bedienungsanleitung

LifeWatch

LifeWatch V Bedienungsanleitung

Bea-fon

Bea-fon SILVER LINE SL860 Bedienungsanleitung

IKI Mobile

IKI Mobile KF4.5i Bedienungsanleitung

Hitech

Hitech HT-850 Bedienungsanleitung

Yezz

Yezz Fashion F10 Bedienungsanleitung

Point Mobile

Point Mobile PM60 Bedienungsanleitung

Blackbe;rry

Blackbe;rry Q10 Bedienungsanleitung

Blackbe;rry

Blackbe;rry Bold 9900 Bedienungsanleitung

Blackbe;rry

Blackbe;rry STORM 9500 - VERSION 5.0 Bedienungsanleitung

LG LM-K420EMW Bedienungsanleitung

ISAFE MOBILE

ISAFE MOBILE IS655.2 Bedienungsanleitung