Warning
MRC PWR-3030 Power Supply has been tested and found to comply
with the limits for the CE regulation.Also, PWR-3030 Power Supply series is
RoHS compliant to deliver confident product which meets the environmental
directive. These limits are designed to provide reasonable protection against
harmful interference when the instrument series is operated in a commercial
environment. This instrument series used together with power supply unit
generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this instrument series in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at their expense. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. It is strongly
recommended for the user to read the following points carefully before
operating this equipment.
1. Read and follow the manual instructions carefully.
2. Do not alter the equipment. Failure to follow these directions could result
in personal and/or laboratory hazards, as well as invalidate equipment
warranty.
3. Use a properly grounded electrical outlet with correct voltage and current
handling capacity.
4. Disconnect from power supply before maintenance and servicing. Refer
servicing to qualified personnel.
5. Never use this instrument series without having the safety cover correctly
in position.
6. Do not use the unit if there is any sign of damage to the external tank or
cover. Replace damaged parts.
7. Do not use in the presence of flammable or combustible material; fire or
explosion may result. This device contains components which may ignite
such materials.
8. Refer maintenance and servicing to qualified personnel.
9. Ensure that the system is connected to electrical service according to
local and national electrical codes. Failure to make a proper connection
may create fire or shock hazard.
10. Use appropriate materials and operate correctly to avoid possible hazards
of explosion, implosion or release of toxic or flammable gases arising from
