MTX Chevy Colorado Crew Cab Bedienungsanleitung

CHEVY COLORADO CREW CAB

And

GMC Canyon Crew Cab

Vehicle Specific Subwoofer Enclosure

Made in the USA

READ ALL DIRECTIONS CAREFULLY BEFORE BEGINNING

MOUNTING LOCATION:

The enclosure mounts under the rear seat, firing

down,

Chevy Colorado/GMC Canyon Crew Cab Trucks.

TOOLS REQUIRED FOR INSTALLATION:

Powered Screwdriver

Wire Cutters

Bit Holder Extension

18mm Deep Socket

3/8" Socket Wrench

INSTALLATION:

Follow the steps below

#2 Phillips Head Bit

5/16" Wrench

3" Socket Extension

18mm Wrench

Slide front seats to full forward position. This will give you more room to work

with.

Remove the four 18mm nuts that hold the rear seat

place.

You

may want someone to help you for this step. Lift out rear seat and set

aside.

Place enclosure on the floor behind the front seats with woofer firing down.

If externally amplified, make speaker connections to the enclosure from the

amplifier. Connect speaker wires from amplifier to enclosure, positive to red ter-

minal and negative to black terminal.

AMPLIFIED THUNDERFORM

Routing Power Wire; we recommend a connection directly to the battery.

Remove drivers side threshold trim; pull up on trim, it will remove easily.

Using furnished wiring harness route 1

Oga

red

power wire starting at pre-amp

location. Route wire

drivers side, over to threshold and under carpet to the

front of vehicle.

Open hood.

9. Drill a hole through the fire wall. Locate a spot low

the fire wall on the pas-

senger side. You should always look to find a clear path. Drill a hole from inside

of the vehicle into engine compartment and insert grommet.

You

may also find a

pre-existing, unused rubber grommet

this location that you can pass the wire

through.

Drill Hole

for Grommet

Firewall

Note:

avoid any damage to parts inside engine compartment, drill from

inside of vehicle using a short bit.

10. Route 1

Oga

red power wire through a grommet into the engine compart-

ment.

11. Route 1

Oga

red power wire through engine compartment safely away from

any moving or hot parts that could damage the wire.

12. Cut 1

Oga

red power wire to length, connect the supplied fuse holder from the

wire kit to the end of the wire.

13. Remove 20amp fuse from MTX fuse holder. Connect furnished ring terminal

to positive side of battery. Remove 5/16" bolt from factory battery terminal. Place

ring terminal on battery post and retighten nut.

Ignition OFF When Disconnecting Battery

Always turn the ignition OFF when connecting or disconnecting battery cables.

Failing to do so may damage electronic components.

14. Ground amplifier to chassis of vehicle; connect the terminal provided to the

Oga

black wire from furnished wiring harness. A good ground is as important as

the power connection. The ground should be as short as possible and the contact

point should be free of paint and debris.

As always, before screwing

drilling check to make sure you will

not

damage

any wires, hoses

cause damage to the vehicle.

Factory Speaker Wire Colors

15.

the channel on drivers' side threshold, locate the left rear speaker wires

twisted together and wrapped

black tape. Wire colors for the left rear speakers

are: brown (positive) and yellow (negative).

the channel on the passenger side

threshold, locate the right rear speaker wires twisted together and wrapped

black tape. Right rear speaker wire colors are: dark blue (positive) and light blue

(negative).

Tap

into wires with the supplied RCA High Level input wires and route

over to passenger side threshold and to pre-amp of enclosure

Although,

MTX

has made eve!}' effort to assure proper wiring colors,

MTX

is not

responsible for

any

changes made

the vehicle manufacturer which sometime

occur.

wiring colors do

not

match then physical verification is required.

CONNECTION TO ENCLOSURE

16.

Connect speaker wire RCA's to the inputs of pre-amp.

Note: PatentedBTL tum on circuit!}'- amplifiersenses

offsetprovided

"high

powered"

BTL type

head

units. This feature turns the amplifieron automatically

you are using high level inputs.

20 Amp Fuse

17. Plug power wire harness into amplifier pre-amp.

0 0

18.

Replace 20amp fuse under hood.

19. When amp turns on, LED will display

red

during diagnostic mode,

and

then

green, signaling amp is

and functioning. Amp will only turn

when radio

on.

20.

Adjust gain and crossover.

Setting Gain

Turn gain knob

ThunderForm pre-amp

minimum, counter clockwise. Play

a favorite tape or compact disc that contains consistent music and bass. Turn

the source unit to maximum listening level.

You

may want to turn down the

bass slightly

the source unit. You should know that some source units will

produce distortion or "clip" before the unit reaches maximum volume. Reduce

volume to the loudest listening level before distortion. Turn the gain knob

the

ThunderForm pre-amp clockwise until the speaker starts to distort

and

reduce

gain to loudest listening level before distortion.

Optional- The

EBC,

or Electronic Bass Control, allows a remote bass control

be adjusted from the driver's seat.

Setting Crossover

You should set the crossover to your own personal listening taste. The cross-

over is adjustable to any frequency between 50Hz (counterclockwise)

150Hz

(clockwise).

a guideline, the goal is to create the illusion of bass

front. The

higher the crossover point the more "audibly visible" your sub

going to

be.

Take

your time and really listen to your system, grab a soda and a few of your favorite

tunes and have fun.

TROUBLESHOOTING TIPS IF AMP DOES NOT TURN ON

Check all connections

battery

and

that fuse is installed

Check speaker wire connections

Check ground

Check fuse on pre-amp

21. Reinstall threshold trim. Locate and align holes

vehicle with pins on trim;

and snap back into place.

22. Using the supplied hardware, secure the enclosure to floor of vehicle as

shown below.

23. Carefully reinstall rear seat over enclosure and bolt into place.

For technical assistance call 1-800-CALL MTX.

These instructions are guidelines

only

and

way are intended

replace a

professionalinstallation.

always before screwing

drilling check to make sure

you will

not

damage

any

wires

hoses

cause damage to the vehicle.

Warning: Batteries normallyproduce explosive gases which can cause personal

injury. Therefore, do notallowflames, sparks

lighted substances

come near

the battery. When charging

working

near

a battery, alwaysshield

your

face

and

protectyour eyes. Always provide ventilation.

Conventional Wiring

Aftermarket Radio

Amp

Fuse

_0_

0 0

Low Level

Signal-

Optional EBC

(Electronic Bass Control)

.M!'i

;f;:;j

Q!.Ol.:-

<=CJ

J:(

••

•

-<=CJ

··

'ol

O•

-:-

0 0 0

Turn On Lead

Warranty Statement

ThunderForm Loaded Enclosures purchased

the United States from

authorized MTX dealer

are guaranteed against defects

material and workmanship for a period of two years from the date

purchased by the end user, and limited to the original retail purchaser of the product.

Amplified ThunderForm Enclosures purchased in the United States from an authorized MTX dealer

are guaranteed against defects

material and workmanship for a period of one year from the date

purchased by the end user, and limited to the original retail purchaser of the product.

Product found

be defective during that period will be repaired or replaced by MTX at no charge.

This warranty is void if it is determined that unauthorized parties have attempted repairs or altera-

tions of any nature. Warranty does not extend to cosmetics or finish. Before presuming a defect is

present

the product, be certain that all related equipment and wiring is functioning properly. MTX

disclaims any liability for other incurred damages resulting from product defects. Any expenses

incurred

the removal and reinstallation of products are not covered by this warranty. MTX's total

liability will not exceed the purchase price of the product.

a defect is present, your authorized MTX

dealer may be able to effect repairs.

Proof of purchase is required when requesting service, so please retain your sales receipt and take

a moment to register your product online at mtx.com.

One Mitek Plaza, Winslow, IL. 61089

1-800-225-5689 mtx.com

21A8251

Dieses Handbuch passt für folgende Modelle

Andere MTX Subwoofer Handbücher

MTX

MTX CXP10 Bedienungsanleitung

MTX

MTX CT8SW Bedienungsanleitung

MTX

MTX T684 Gebrauchsanweisung

MTX

MTX Coustic PRO10-44 Bedienungsanleitung

MTX

MTX T4158A Gebrauchsanweisung

MTX

MTX PROXP-20-SW Bedienungsanleitung

MTX

MTX Thunder T8512-04 Bedienungsanleitung

MTX

MTX Thunder T9515-04 Bedienungsanleitung

MTX

MTX T812-44 Bedienungsanleitung

MTX

MTX Thunder TR7515-44 Bedienungsanleitung

MTX

MTX Thunder T8515-44 Bedienungsanleitung

MTX

MTX JackHammer Bedienungsanleitung

MTX

MTX Thunder TS8512-44 Bedienungsanleitung

MTX

MTX Thunder T9512-44 Bedienungsanleitung

MTX

MTX Thunder TR7515-22 Bedienungsanleitung

MTX

MTX Thunderform CTYSD07FB10 Bedienungsanleitung

MTX

MTX ThunderLink XT110P Bedienungsanleitung

MTX

MTX JACKHAMMER T9922-22 Bedienungsanleitung

MTX

MTX Thunder TS8510-22 Bedienungsanleitung

MTX

MTX Thunder TR7512-22 Bedienungsanleitung

MTX

MTX RFL152 Bedienungsanleitung

MTX

MTX Thunder T9510-44 Bedienungsanleitung

MTX

MTX MTX Thunder 8000 T8154A Bedienungsanleitung

MTX

MTX Thunder TR7510-44 Bedienungsanleitung

Beliebte Subwoofer Handbücher anderer Marken

Sony

Sony XS-AW8 Bedienungsanleitung

Sony

Sony XS-L836 Bedienungsanleitung

B&C Speakers

B&C Speakers 15 HPL 76W Bedienungsanleitung

Velodyne

Velodyne DD-18+ Bedienungsanleitung

Sonance

Sonance Cinema Series SUB 10-150 Bedienungsanleitung

Hifonics

Hifonics HW-12 Kurzanleitung

Magnat Audio

Magnat Audio ADR 130 BP Bedienungsanleitung

Blitz

Blitz BZP106 Bedienungsanleitung

Technics

Technics SB-AS500 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-2 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-3 Bedienungsanleitung

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Bedienungsanleitung

REL Acoustics

REL Acoustics Q Series Bedienungsanleitung

Pioneer

Pioneer Elite S-W1EX Bedienungsanleitung

L-Acoustics

L-Acoustics KIVA SB15M Kurzanleitung

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Bedienungsanleitung

KEF

KEF KUBE 200 Bedienungsanleitung

Yamaha

Yamaha SW500 Bedienungsanleitung