- 4 -
14. BEFORE USING TOOL, carefully check if
there is any part damaged to obtain ideal results. Do
not use the tool if the tool has any air leaks,
uncompleted, damaged parts and needs repairing.
15. NEVER USE TOOL if safety, trigger or spring
is inoperable, missing or damaged. Do not alter or
remove safety, trigger or springs Make daily
inspections for free movement of trigger and safety
mechanism.
16.ONLY USE PARTS AND FASTENERS
recommended by us.
17. CONNECT TOOL TO AIR SUPPLY
BEFORE loading fasteners to preventa fastener
from being fired during connection. The tool
driving mechanism may cycle when tool is
connected to the air supply. When not in use
remove all fasteners from the nail housing.
18. ALWAYS ASSUME THE TOOL CONTAINS
FASTENERS. Keep the tool pointed away from
yourself and others at all times. No horseplay.
Respect the tool as a working implement.
19. DO NOT LOAD FASTENERS with trigger or
safety depressed to prevent unintentional firing of a
fastener.
20. REMOVE FINGER FROM TRIGGER when
not driving fasteners. Never carry tool with finger
on trigger: tool will fire fastener if safety is bumped
while trigger is depressed.
21. DON'T OVER REACH. Keep proper footing
and balance at all times when using or handling the
tool.
22. FIRE FASTENERS INTO WORK
SURFACE ONLY: NEVER into materials too hard
to penetrate.
PROBLEM CAUSE SOLUTION
Skipping
fasteners/ feeding
intermittently
1.Having the foreign matters
between the small piston and
small cylinder.
2.O-ring on the small piston is
worn and damaged.
3.Tool dry and lack lubrication.
4.The spring on the small piston is
damaged.
5.Air pressure is lower.
6.Connecting screw of nose and
body is loose.
7.Stopped hook can't stop the
fasteners.
8.Bent fasteners.
9.Wrong size fasteners.
10.Small piston bumper is worm
and damaged.
11.Feed hook is binding.
12.Nail length is not correct with
loading space of nail housing.
13.Weld wires in nail coil is broken.
1.Disassemble/ clean/lubricate.
2.Check/replace O-ring/lubricate
3.Use pneumatic tool oil.
4.Replace small piston the spring.
5.Increase the air pressure, but
don't exceed 120 PSI (8.3 bar).
6.Tighten all screw.
7.Replace taper spring of the
stopped hook.
8.Use recommended fasteners.
9.Use recommended fasteners
10.Replace bumper and lubricate
small piston.
11.Clean feed hook and torsion
spring.
12.Adjust adjuster plate at the nail
housing tail portion according to
the recommended nail length to
make arrow on the nail housing
tail pointing to correct direction.
13.Stop using.
Runs slowly or has
power loss 1. Tool dry, lacks lubricate ion
2. The spring in the cylinder cap is
damaged.
3.Having foreign matters between
piston assembly and cylinder.
4.Have not assembled the cylinder to
home position.
5.O-ring on the valve is dry after
disassembly.
6.Air pressure is too low.
7.Driver is worn (sort)
8. Inner diameter of hose is small.
1.Use pneumatic ic tool oil.
2.Replace the spring in the cylinder
cap.
3.Disassemble/clean/lubricate.
4.Reassemble af ter disassembling.
5.Reassemble af ter lubricating
6. Increase the air pressure, but don't
exceed 120 PSI (8.3 bar).
7.Replace piston assembly.
8.Use bigger inner diameter of the
hose.
Fasteners are jammed 1.Fasteners are wrong size.
2.Weld wires in nai l coil are broken. 1.Use recommended fasteners.
2.Stop using.
