Operation
Caution: Turn off receiver/transmitter before replacing batteries.
1. Turn power on and off by turning volume control dial located on top of unit.
Adjust volume using the same dial.
2. Select a desired channel for the receiver/transmitter by turning the channel
selector.
3. Select the desired group on the front of the receiver/transmitter using
the included tool. A light indicates a different group has been selected.
Note: The channel and group of the transmitter must match that of the receiver.
4. Connect the lavalier microphone to the transmitter by plugging it into the
3.5mm input jack located on the top of the TX unit.
5. Connect a headphone or recording device to the receiver by plugging it into
the 3.5mm output jack located on top of the RX unit.
6. The receiver and transmitter can be worn using the built-in belt clip.
Hot shoe adapter installation
1. Insert the hot shot into the belt clip as shown in image.
2. Slide the square piece into the hot shoe mount on the camera.
3. Tighten down the adapter.
4. Insert the appropriate cable into the line out and into the camera’s microphone
jack.
For tech support, email techsupport@mxlmics.com or call (800) 800-6608 or
+1 (310) 333-0606.
Operation
Caution: Turn off receiver/transmitter before replacing batteries.
1. Turn power on and off by turning volume control dial located on top of unit.
Adjust volume using the same dial.
2. Select a desired channel for the receiver/transmitter by turning the channel
selector.
3. Select the desired group on the front of the receiver/transmitter using
the included tool. A light indicates a different group has been selected.
Note: The channel and group of the transmitter must match that of the receiver.
4. Connect the lavalier microphone to the transmitter by plugging it into the
3.5mm input jack located on the top of the TX unit.
5. Connect a headphone or recording device to the receiver by plugging it into
the 3.5mm output jack located on top of the RX unit.
6. The receiver and transmitter can be worn using the built-in belt clip.
Hot shoe adapter installation
1. Insert the hot shot into the belt clip as shown in image.
2. Slide the square piece into the hot shoe mount on the camera.
3. Tighten down the adapter.
4. Insert the appropriate cable into the line out and into the camera’s microphone
jack.
For tech support, email techsupport@mxlmics.com or call (800) 800-6608 or
+1 (310) 333-0606.
C
D
A
B
CH
MIC
LINE IN
1. Power/volume control
dial
2. Mic in
3. Line in
4. Channel Selector
5. Built-in microphone
6. Channel Group Selector
1. Power/volume control
dial
2. Mic in
3. Line in
4. Channel Selector
5. Built-in microphone
6. Channel Group Selector
1. Power/volume control
dial
2. Headphone out
3. Line out
4. Channel Selector
5. Built-in microphone
6. Channel Group Selector
1. Power/volume control
dial
2. Headphone out
3. Line out
4. Channel Selector
5. Built-in microphone
6. Channel Group Selector
FR-500WT Transmitter
FR-500WR Receiver
Hot Shoe Adapter on FR-500WR
12
34 5 6
C
D
A
B
CH
LINE OUT
1 2
3 4 5 6
FR-500WR Receiver
FR-500WT Transmitter
Hot Shoe Adapter on FR-500WR
