MyTek MWL-6200D Bedienungsanleitung

Wireless LAN USB
Adapter
USER’S MANUAL
VERSION 1.1
2008/02/28

This manual provides the necessary information for first -time users to successfully
install the Atheros network driver interface specification (NDIS) driver, for the purpose of
evaluating and / or operating the Atheros WLAN 11n ISM Band Dongle STA Reference Design
in a Microsoft Windows environment and the Atheros Client Utility (ACU) .
This guide describes the steps required to install NDIS drivers for the WLAN 11n ISM
Band Dongle in Windows 2000, Windows XP, Windows XP 64, Windows Vista, Windows Vista
64. This guide also includes the detailed instructions for configuring the network adapter to
interact with an access point (AP) in infrastructure mode. Read this before installing the
Atheros WLAN 11n ISM Band Dongle and NDIS driver in the targeted operating system (OS)
environment.
© All rights reserved.
All trade names are registered trademarks of respective manufacturers listed.
This manual may not be copied in any media or form without the written consent of original maker.

Information To User ..................................................…… .. I
1. Introduction .........................................................… .. 1
2. Wireless LAN Basics ................................................…… ..3
3. IP ADDRESS ..........................................................…… ..4
4. Install Driver/Utility ...............................................…… ..5
5. Wireless Network Conf iguration in Station Mode .................. 9
5.1 TRAY ICON ................................………… .……………………9
5.2 GENERAL CONNECTION SETTING .............................. 11
5.2.1 Current Status . . . ………………………………………………… 11
5.2.2 Profile Management ………………………………………… . 15
5.2.3 Diagnostics ……………………………………………………… ….17
5.3 SECURITY ...............................................…………… 19
5.3.1 WPA/WPA2 …………………………………………………………… ..19
5.3.2 802.1x ………………………………………………………………… .30
5.3.3 WPA Pass phrase ……………………………………………………… .30
5.3.4 Pre -Shared Key (Static WEP) …………………………………… 31
5.3.5 None ……………………………………………………………………… 31
5.4 JumpStart for Wireless …………………………………………………… ..31
6. Install VISTA Driver ............................................... ....…. 37
7. Technical Specifications ...........................................… .. 41
8. Troubleshooting ....................................................…… . 42
9. Glossary ..............................................................… . 43

INFORMATION TO USER
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communi cations. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different fr om
that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the use r's authority to
operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
* This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
* This transmitter must not be co -located or operating in conjunction
with any other antenna or transmitter.
i

REGULATORY INFORMATION
WLAN Mini USB Adapter must be installed and used in strict
accordance wit h the instructions. This device complies with the
following radio frequency and safety standards.
USA - Federal Communications Commission (FCC)
This device complies with Part 15 of FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may cause undesired
operation.
Europe - R&TTE Directive
This device complies with the specifications listed below
EN 300 328 V1.6.1 (2004 -11)
EN 301 489 -1 V1.4.1 (20 02-08), EN 301 489 -17 V1.2.1 (2002 -08)
EN 60950-1: 2001
The channel identifiers, channel center frequencies, and regulatory domains
of each 22-MHz-wide channel are shown in following Table.
Regulatory Domains
Channel
Identifier
Center
Frequency
(MHZ)
Japan
ETSI
North
America
Israel
France
Mexico
1
2412
ˇ
ˇ
ˇ
2
2417
ˇ
ˇ
ˇ
3
2422
ˇ
ˇ
ˇ
ˇ
4
2427
ˇ
ˇ
ˇ
ˇ
5
2432
ˇ
ˇ
ˇ
ˇ
6
2437
ˇ
ˇ
ˇ
ˇ
7
2442
ˇ
ˇ
ˇ
ˇ
8
2447
ˇ
ˇ
ˇ
ˇ
9
2452
ˇ
ˇ
ˇ
ˇ
10
2457
ˇ
ˇ
ˇ
ˇ
ˇ
11
2462
ˇ
ˇ
ˇ
ˇ
ˇ
12
2467
ˇ
ˇ
ˇ
13
2472
ˇ
ˇ
ˇ
14
2484
ˇ
ii

1
Thank you for your purchase of the WLAN 11n ISM Band Dongle .
Featuring wireless technology, this wireless networking solution has
been designed for both large and small businesses, and it is scalable
so that you can easily add more users and new network features
depending on your business scale.
FEATURES
Support Microsoft Windows 2000 ,XP , Vista.
Indoor up to 100 meters, Outdoor up to 280 meters .
270/240/180/120/90/60/54 /48/36/30/24/22/18/12/11/6/5.5/2/1
Mbps selectable Data Rate and maximum of 300Mbps.
Support USB 2.0 interface.
64-bit, 128-bit or WEP, TKIP, AES.
2.400GHz ISM Frequency Band.
Modulation Method : BPSK/QPSK/16 -QAM/64-QAM
Spread Spectrum :
IEEE 802.11b : DSSS (Direct Sequence Spread Spectrum).
IEEE 802.11g / n: OFDM (Orthogonal Frequency Division Multiplexing).
Easy operation and setting up.
SYSTEM REQUIREMENTS
Windows System : Windows 2000 , XP , Vista
PCs must have a device driver installed . It allows you to communicate
with WLAN Mini USB Adapter.

2
BEFORE YOU START
1. Confirm Box Contents
CONNECTING YOUR WLAN USB ADAPTER TO PC
Quick Start Guide
Connect your WLAN USB dongle to
your PC.
Install driver.
GETTING TO KNOW WIRELESS LAN USB ADAPTER
LED
LED turns on when POWER is applied to the WLAN Mini USB Adapter.
LED is blinking when PC is sending data through WLAN Mini USB Adapter.

3
Wireless LAN network defined by IEEE 802.11 n/b/g standard committee
could be configured as :
Ad Hoc wireless LAN, or
Infrastructure wireless LAN.
Ad Hoc network is a group of PCs installed with wireless LAN cards, this
group of PCs is called a BSS (Basic Service Set). PCs in this group can use
their wireless LAN cards to comm unicate with each other, but can not
connect to the Internet.
Ad Hoc Wireless Network Infrastructure Wireless Network
The most obvious difference between Infrastructure wireless network
and Ad Hoc wireless network is that the PCs in Infrastructu re wireless
network can access the resource in the Internet through Access Point.
Depending on your requirement, you can easily set up your PC’s
network to be a “ Ad Hoc” or “Infrastructure ” wireless network. Generally
speaking, if in your network, there is an Access Point in it, we recommend
you to set your network as an “ Infrastructure ”, so it can connect to
the Internet.

4
To use the WLAN Mini USB Adapter with a computing device, the WLAN
Mini USB Adapter must be equipped with an USB 1.1 or 2.0 In terface. All
drivers and supporting software for the WLAN Mini USB Adapter must be
installed and configured first.
Ask your system administrator for the following information, which you
may need to provide during driver installation :
using a DHCP server.
Any computer on a network is identified by a unique network address.
There are two methods to assign a network address to a computer on a
TCP/IP network :
In network with static IP addressing, the netwo rk administrator manually
assigns an IP address to each computer. Once a static IP address is
assigned, a computer uses the same IP address every time it reboots and
logs on to the network. You may manually change the IP address in the
Network Properties d ialog box. Network using static IP address is easy to
set up and do not require additional network management software.
In network with dynamic IP addressing, a DHCP server in the network
dynamically assigns IP addresses to all clients every time they log on to
the network. Network using dynamic IP address requires setting up and
running a DHCP Server.

5
The installation driver CD will automatically activate the autorun
installation program after you insert the disk into your CD drive.
Step 1 :
Insert the installation driver
CD into your CD-ROM, chose
your language and click Next to
continue.
Step 2 :
Click Next to continue.
Inhaltsverzeichnis
Beliebte Modem Handbücher anderer Marken

Davicom
Davicom DM562AP Bedienungsanleitung

EpiValley
EpiValley TATA indicom SXC-1080 Bedienungsanleitung

Zte
Zte WiMAX Bedienungsanleitung

Intelimax
Intelimax MA-2060 Bedienungsanleitung

SMC Networks
SMC Networks D3CM1604V Gebrauchs- und Pflegehandbuch

Telstra
Telstra Wi-Fi 4G Advanced Pro X Bedienungsanleitung

US Robotics
US Robotics 3453C Bedienungsanleitung

MaxTech
MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Bedienungsanleitung

Zte
Zte MF823 Bedienungsanleitung

Four-Faith
Four-Faith F1403 Bedienungsanleitung

Sierra Wireless
Sierra Wireless AIRLINK MP595W Bedienungsanleitung

Gemtek
Gemtek WiMAX WIXFBR-103 Bedienungsanleitung





