1.After receiving the light ,please check if any damage caused by transportation. If there is damage caused by
transportation ,please do not use the light and contact with the distributor or the manufacturer ASAP.
2.Please do not mount the light directly on the surface of the common combustible material. Keep the light dry
and keep it away from wet ,hot or dusty condition ,prevent the light from water or other liquids.
3.Before installation ,please make sure the power voltage you use should be according to the voltage indicated
on the lamp ,please do not open and repair the lamp yourself when the power is on.
4.Please do not use the power cord which is with bad insulating layer, and do not pull the plug or drag the power
cord directly.
DMX IN DMX OUT
The connection between light and light,or between light and the controller should use 3 pins power
cord which the diameter is not less than 0.5mm.Please use 3 pins XLR plug to connect the DMX 512
output / input. The connection between XLR plug and the cable is showed as above photo.
Use the XLR cable from the DMX output socket of the controller to connect with the DMX input socket
of the first light, and from the DMX output of the first lamp to connect with the DMX input of the second
lamp, and so on, until finish the connection of all lights.
·Notice: the length of the XLR control cable can't be longer than 300m.
CN-1200DCHS Studio LED Light
Instruction Sheet
The lighting comes with accessoiries together,pls check carefully.
Name
XLR Signal line
Instruction sheet
Power Adapter
Filter set
Power cable
Quantity
1
Unit
PC
Remarks
English
15V
Parameters:
LED Bulbs Amount:1200 pcs Total Power:72W
AC Power:100V-240V DC Power:15V
Color Temperature:7500K-3200K
4.Channel instruction
When the LED light is mono color,the address choose 001, it will occupy the corresponding pusher
CH1 in DMX controller.
When the LED light is Bi-color,the address choose 001,and the system will occupy the corresponding
pusher CH1,CH2 in DMX controller.After choose and confirm the address,
next time it will remain the previous address as a default one.
Safety Warning:
control signal connection
General Breakdown Service
Description of Breakdown Measurements
The lamp can not start up normally
The manual function is right but can not
controlled by the controller
The screen can not display or the content disorder
The light is on but can not be operated by
manual or controller
1.Please check if the power cord is connected firmly
2.The plug of the power supply is connected well with
the lamp or not
1.Check the setting of the DMX starting address is correct or not
2.Check if the XCR signal wire damaged or not.
Turn off the power for 1 minute and restart.
Internal CPU chip damaged,please contact with the
supplier or return it back to factory.
GND 1
DATA- 2
DATA+ 3
1 GND
2 DATA-
3 DATA+
1PC
1PC
1SET
1PC
www.nglbg.com
Add:Zhanglin Section,Highway324,Dongli,Chenghai,Shantou City,Guangdong Province,China
Tel:+86-754-85751187 Fax:+86-754-85300887
E-mail:service@nglbg.com http://www.nglbg.com
Please switch off
the power button
before inserting
or removing the
power cable.
Guangdong NanGuang Photo&Video Systems Co.,Ltd
