NEC SV8500 Benutzerhandbuch

FP85-104 S1

PCPro Setup Manual

NWA-041691-001

ISSUE 1.0

LIABILITY DISCLAIMER

NEC Infrontia Corporation reserves the right to change the specifica-

tions, functions, or features, at any time, without notice.

NEC Infrontia Corporation has prepared this document for use by its

employees and customers. The information contained herein is the

property of NEC Infrontia Corporation, and shall not be reproduced

without prior written approval from NEC Infrontia Corporation.

All brand names and product names on this document are trade-

marks or registered trademarks of their respective companies.

NEC Infrontia Corporation

PL- 1

PRODUCT LIABILITY

1. USING THE EQUIPMENT SAFELY

The following safety information describes how to avoid injuries while working with the equipment and how to

prevent damage to the equipment. Learn the meaning of the following symbols and then read this section

carefully before using the equipment.

SYMBOL DESCRIPTION

DANGER

Incorrect use of the equipment may cause personal injury or death.

WARNING

Incorrect use of the equipment may cause personal injury or a serious

system fault.

ATTENTION

Incorrect use of the equipment may limit the system performance or

cause the system to fail.

The telephone system can only be used in NEC-designated countries.

If a system-down, malfunction, defect or external factor such as an electrical failure indirectly causes a loss of profit, the

company (or affiliates) will not be held responsible.

The goal is to produce a comprehensive and accurate manual. However, if errors or omissions are found in this manual,

please notify NEC Infrontia Corporation.

If the system requires installation or repair, contact the dealer or its service technician.

Carefully read all the manuals that relate to the system.

PL- 2

PRODUCT LIABILITY

2. SAFETY CONSIDERATIONS

2.1 PBX, Power-related Equipment and Peripheral Equipment

The following describes the safety considerations that must be observed before using the PBX, the power-

related equipment and the peripheral equipment, such as consoles, the Main Distribution Frame (MDF), the

Digital Remote Unit/Distributed Access Unit (DRU/DAU), telephones, PCs, printers, etc.

DANGER

If the system emits smoke or a burning, acrid odor, immediately turn off the system power.

Operating the system in this state might cause a fire, an electrical shock, or a system failure. After

turning off the power and confirming that the smoke has disappeared, contact the dealer.

If any equipment, such as the PBX, the main power source, a cabinet or peripheral equipment tips

over, turn off the power and contact the dealer.

If liquid reaches the inside of the PBX or the main power source, turn off the power. Operating the

system in this state might cause a fire, an electrical shock, or a system failure.

Do not touch the internal parts of the main power source to disassemble or configure it. This action

may cause a fire, an electrical shock or a system failure.

NEC Infrontia Corporation does not take any responsibility for disassembled or reconfigured

equipment.

Do not put any container objects (such as a vase or a cup) on the main power source or any

peripheral equipment. It might cause a fire, an electrical shock or a system failure.

Do not tamper with, modify, forcefully bend, forcefully remove or twist an electrical cord or any

wiring to or from the PBX, the main power source or any peripheral equipment. It might cause a

fire, an electrical shock, or a system failure. If the wiring is damaged, contact the dealer.

Correctly insert all of the electrical plugs into the electrical outlets. Before inserting a plug into an

electrical outlet, ensure that there is no dust on the plug’s blades. If there is dust on a blade, it might

cause a fire.

Do not use power other than the power that was designated for the system when it was installed.

PWR

dust

PWR

PL- 3

PRODUCT LIABILITY

DANGER

Do not attempt to repair or move the main power source without assistance from the dealer.

Do not put any metal or combustible objects into a vent of the PBX, the main power source, or any

peripheral equipment. Operating the system in this state might cause a fire, an electrical shock, or

a system failure. If this occurs, turn off the power and contact the dealer.

Be careful when using any peripheral equipment’s Liquid Crystal Display (LCD). If the liquid

leaks, it can be harmful to the user and to the system.

Before connecting any non-NEC, customer-provided equipment, check with the supplier to ensure

that the equipment is compatible. If the supplier cannot confirm the compatibility, do not connect

the equipment. Connecting incompatible equipment might cause a fire or an electrical shock.

PWR

PL- 4

PRODUCT LIABILITY

WARNING

Do not place any object on the PBX or the main power source. If the object falls, it might cause

personal injury or damage to the equipment.

When removing a plug from an outlet, be sure to grip the plug, not the cord. Gripping the cord to

remove the plug could cause a fire or an electrical shock to occur.

If lightning causes a fault, contact the dealer.

Provide the appropriate temperature, humidity, and ventilation on an around-the-clock basis. For

example, at a height that is one meter (3.28 feet) above the floor, the temperature should be between

20° C and 25° C (68° F to 77° F) and the humidity should be approximately 50%.

Take appropriate anti-static measures so that the other end of the anti-static kit can be connected to

the metal part of the frame.

ATT ENTION

Contents

Static Sensitive

Handling

Precautions Required

PL- 5

PRODUCT LIABILITY

WARNING

Observe the following precautions when using any optional batteries:

• The PBX’s emergency back-up battery may be a rechargeable lead battery. Check the

emergency battery for an electrical failure.

• Battery acid (electrolyte) is extremely harmful to human skin and eyes. If battery acid

contacts skin, wash the affected area with soap and water. If battery acid contacts the eyes,

flush the eyes with water. In either event, seek medical attention. If there is battery acid on a

cloth, use water to wash the battery acid from the cloth.

• Do not intentionally short batteries. Do not put the battery near a fire or in a fire. Do not

disassemble the battery, drop it or knock it against another object.

• The battery’s life expectancy is affected by its environment. The normal battery life is

approximately three years. If the battery is used in an outdoor setting and is exposed to high

temperatures, its life expectancy drops to approximately one year.

• Perform periodic diagnostic tests and maintenance procedures on the emergency battery and

its terminals to ensure their readiness. If there is a power failure and the emergency battery is

not ready, then the PBX will not work. Additionally, a damaged or dead battery, or terminals

that need replacement might cause battery acid to leak, which might cause smoke or a fire.

The battery and terminals are periodic replacement parts (the cost is chargeable to the

customer). A service contract, with the supplier or service technician, to perform routine

maintenance for the battery is recommended.

Do not touch peripheral equipment with wet hands. Do not allow any liquid to touch any of the

peripheral equipment.

Do not touch the printer’s internal components when replacing disposables such as a cartridge or a

ribbon. Ensure that the printer is turned off and that it is not hot in order to prevent burns from any

accidental contact with the internal components.

Do not drop the peripheral equipment or knock it against another object. These actions might cause

an equipment failure.

PL- 6

PRODUCT LIABILITY

2.2 Installation Environment

Consider the following items before the installation.

2.2.1 Stability

2.2.2 Floor, Wall and Ceiling

ATTENTION

Do not use benzine, thinner or alcohol for cleaning. When removing dust and dirt, put diluted, mild

detergent on a cloth and then wring out the cloth. Remove the dust and dirt with the cloth and then

wipe the cleaned area with a dry cloth.

ATTENTION

Do not place any equipment in the following environments:

• Locations that are exposed to direct sunlight

• Locations where the moisture level exceeds the allowed level

• Locations where the equipment might be exposed to water, oil, and chemicals

• Locations with very low temperatures, such as in a walk-in cooler or freezer

• Locations that are exposed to Electromagnetic Interference (EMI) from devices such as

television sets and two-way radios

• Locations that receive illegal electric waves

The life expectancies of the PBX and the main power source will be shortened if placed in a location

that is affected by hydrogen sulfide or salt, such as a seaside area.

WARNING

Install the PBX with anchor bolts to prevent constant movement or vibration, such as from a nearby

motor or automatic door, and to resist catastrophic movement from natural disasters, such as an

earthquake. If the system moves or falls, an injury could occur.

WARNING

The wall and ceiling materials must be resistant to Electrostatic Discharge (ESD) and provide heat

insulation. Since the battery’s life expectancy depends on the ambient temperature, the room where

the battery is installed must be well ventilated and vented to the outside. Check the battery

specifications to determine if the battery can or cannot be installed near a motor or a power

transformer.

The floor material that is under and around the PBX must be resistant to ESD.

Thinner

PL- 7

PRODUCT LIABILITY

2.2.3 Windows

2.2.4 Fire Extinguisher

2.2.5 Safety Environment

2.2.6 Air Conditioning Facilities

ATTENTION

Keep all of the windows closed if the location is affected by dust, sea breeze or corrosive gas.

Curtains or blinds are necessary to avoid direct sunlight.

WARNING Place a fire extinguisher for electrical fires (such as a carbon-gas fire extinguisher or a halon-gas

fire extinguisher) near the system. It is recommended that the room also be equipped with an

automatic fire-detection system. In the event of smoke and fire, turn off the main power source and

the backup battery, then use the fire extinguisher to put out the fire while trying to avoid inhaling

any smoke.

WARNING Consider measures to deal with disasters (such as fires, floods and earthquakes) and to ensure the

safety of the staff.

Regularly clean the room or rooms where the switching equipment resides.

Do not spray any insecticides directly on the equipment (insecticides can adversely affect the

switching equipment).

WARNING

The PBX and the air conditioning system must be installed separately and have separate power

sources.

To prevent an electromagnetic arc from causing noise, attach a surge-limiting capacitor and resistor

on the air conditioner’s electromagnetic switch’s coil.

It might be necessary to adjust the ventilation so the air conditioning is equally effective throughout

the equipment room.

Do not place the PBX in a location where condensation might fall from an air conditioner or a duct.

Do not place the PBX in a location where hot and humid air is exhausted, as this might damage the

PBX.

PRODUCT LIABILITY

PL- 8

2.2.7 Lightning Strikes

2.3 Disposables and Periodic-replacement Parts

WARNING

The grounding system must protect the PBX, MDF, main power source, MAT, printer, modems, etc.

from damage caused by lightning strikes and electrical surges.

All the grounding conductors must have a resistance of less than one Ωto bring a zero-voltage

reference to the system components.

To achieve this, the following ground conductors must connect to the Primary Ground Bar:

• The Earth Ground (E) from the Rectifier

• The Frame Ground (FE) from the PBX

• The Power Ground (PE) from the PBX, through the Rectifier

• The Frame Ground (FE) from the MDF

• The AC service outlets, with AC 100 V plug outlets, for the MAT, printer, modems and any

measurement devices, such as a protocol analyzer.

ATTENTION

Many parts, such as fans, batteries, backup batteries, hard disks, fuses and displays need to be

replaced on a periodic basis. In the event of sudden traffic, a part that is past due for replacement

might lead to a system failure and damage to the PBX.

Replace the disposable items such as ink ribbons, printer cartridges, floppy disks, recording paper

and headsets as needed.

A service contract with the dealer or its service technician to monitor the replacement cycles and to

supply the replacement parts and the necessary disposables is recommended.

Andere Handbücher für SV8500

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere NEC Server Handbücher

NEC

NEC NEC Express5800 Series Bedienungsanleitung

NEC

NEC NECCare Gold Express5800/320Fd Bedienungsanleitung

NEC

NEC NEC Express5800 Series Bedienungsanleitung

NEC

NEC LS2400 Bedienungsanleitung

NEC

NEC Express5800/140Hb Bedienungsanleitung

NEC

NEC Express5800/R120f-1E Bedienungsanleitung

NEC

NEC Univerge SV9100 Bedienungsanleitung

NEC

NEC HX4600 Bedienungsanleitung

NEC

NEC NEC Express5800 Series Bedienungsanleitung

NEC

NEC Express5800/A2040d Bedienungsanleitung

NEC

NEC SV8500 Installationsanleitung

NEC

NEC NEC Express5800 Series Bedienungsanleitung

NEC

NEC EXP710 Bedienungsanleitung

NEC

NEC Express5800/R120d-1M Bedienungsanleitung

NEC

NEC Express5800 320La Kurzanleitung

NEC

NEC NEC Express5800 Series Betriebsanleitung

NEC

NEC UNIVERGE NEAX 2000 IPS Benutzerhandbuch

NEC

NEC NEAX2000 IVS2 Bedienungsanleitung

NEC

NEC Express5800/120Rh-2 Bedienungsanleitung

NEC

NEC Express5800/T120e Bedienungsanleitung

NEC

NEC Express5800/E120d-1 Technisches Handbuch

NEC

NEC Express5800/R120e-2E Bedienungsanleitung

NEC

NEC Express5800/320Lc Bedienungsanleitung

NEC

NEC Express5800/R320c-E4 Bedienungsanleitung

Beliebte Server Handbücher anderer Marken

HP AlphaServer ES47 Bedienungsanleitung

Dell

Dell PowerEdge R410 Bedienungsanleitung

PowerNAS

PowerNAS CMA Bedienungsanleitung

Supero

Supero FatTwin F617R3-FT Bedienungsanleitung

MSI

MSI P1-109N-L70 Bedienungsanleitung

Dell

Dell PowerEdge XE9640 Handbuch

Dell

Dell PS4100 Montageanleitung

EtroVISION

EtroVISION EV3151 Bedienungsanleitung

HP ProLiant Gen9 Bedienungsanleitung

Compaq

Compaq ProLiant 3000 Handbuch

Dell

Dell PowerEdge 3YPMN Bedienungsanleitung

iRobo

iRobo IPC2U Bedienungsanleitung

Nortel

Nortel 1000 Con?guration guide Bedienungsanleitung

Asus

Asus AP7500 Bedienungs- und Wartungshandbuch

Avid Technology

Avid Technology AirSpeed 5000 Bedienungsanleitung

HP Integrity rx2600 Installationsanleitung

Milestone

Milestone Husky IVO 350T Bedienungsanleitung

Planet

Planet NAS-7410 Bedienungsanleitung