Page 7 of 9
3 Wiring diagram
S hemati ally diagrams below shows an example of the onne tions between used modules.
The pi ture shows the full onfiguration that an be built up.
Ant.
Ant.
Ant.
Ant.
Ant.
Figure 2 Example full onfiguration
The onne tions for a full onfiguration are:
1. Datacom cable for NCC to Unit XQMK2
Conne ts Data ommuni ation and power from NCC [9203508] to a Unit XQMK2 Tx [8018464] or Unit
XQMK2 Rx [8018472].
NOTE: The distan e between the NCC and the transmitter antenna shall 4 meters or more.
2. Datacom cable for NCC to Unit XQMK2
Conne ts the data and power between the XQMK2 Tx or Rx Units.
3. Tx or Rx coax cable
Conne ts the antenna input/output XQMK2 Tx [8018464] or Rx [8018472] to the EAS antenna loops PG27,
PG39, FL30, FL45.
4. Rx or Tx cable for Metal detection
Conne ts the metal dete tion antenna input/output from XQMK2 Tx [8018464] or Rx [8018472] to the
Metal dete tion antenna loop PG27, PG39, FL30, FL45.
5. Cable for Customer counting and lighting unit PG27/PG39
Conne ts the XQMK2 Tx [8018464] or Rx [8018472]to the Customer Counter and lighting unit [7833342].
6. Cable for Cusomer counting and lighting unit FL30/FL45
Conne ts the XQMK2 Tx [8018464] or Rx [8018472] to one of the Customer ounter units [9923373,
9928529, 9936114, 9935207].
7. Cable for lighting module FL30/FL45
Conne ts the XQMK2 Tx [8018464] or Rx [8018472] to the lighting module.
8. DC cable from Power adapter to NCC electronics
Conne ts the Power-adapter [9651543] to the NCC main board [7824785] and arries 33V DC power.
9. Mains cable
Conne ts the Mains power to the Power-adapter [9651543].
10. Coax cable for GSM antenna
Conne ts the GSM module to the GSM external antenna to onta t the GSM network.
11. Datacom cables to slave NCC’s
Conne ts a NCC with the behavior “Master” to NCC devi es with the behavior “Slave”.
12. Datacom cables for system expansion
Conne ts more antenna strings up to 16 devi es with the same fun tion as Wire 1 and 2.
