equipped with an appropriate PE terminal.
protection
class IP54
type Directly connected to the system, without an outer supply cable - the heater is
connected by means of an installation box mounted under the decorative panel.
Intended use
The appropriately assembled appliance is for drying/heating towels or bathrobes
in such places as shower rooms, bathrooms, kitchens etc. The appliance should be
assembled in rooms of normal humidity conditions, where there are no agents
increasing corrosion rate.
Functionality
a. The dryer is designed for permanent operation.
b. While the dryer is covered with towels, the operation temperaure of the
working surface reaches 55oC.
c. The operation temperature of the working surface is likely to decreas to 40oC,
in case the dryer is not covered with any towels (empty dryer), and demand
for heat in a room is high.
d. The temperature rise is no further than 60oC on the uncovered surface.
e. The dryer has an on/off switch.
f. A blue LED indicator located on the front part of the dryer shows the
appliance operation.
g. The intelligent systems of operation control result from an additional time
programming controller - surface mounted or flash mounted.
Assembling
The dryer is to be assembled only by qualified persons holding the appropriate
valid licence.
The dryer is designed to be assembled on the wall. The surface for the assembling
must be stable in order to place the mounting parts precisely.
Where to assemble the dryer:
a. The appliance operates vertically with the hooks located upwards,
b. The appliance must be assembled no closer than 60cm to a bath, a sink,
a washbasin, a shower cabin, a pool etc.
c. The assembled power supply cable must not touch any heating surface,
