Netum NT-LP110C Bedienungsanleitung
QUICK START GUIDE
NT-LP110C
THERMAL LABEL PRINTER
Congratulatons on your label printer purchase.
The NetumScan printer you have purchased is a high-effciency thermal
printer and does not require any ink or toner.Prints will be made by
instantly heatng compatble labels.Please take a moment to thoroughly
review this user guide.lncorrect operaton may result in damage or injury.
www.netum.net
You can also download the latest driver here:
Windows：
https://cdn.shopify.com/s/files/1/2144/8019/files/LabelPrinter20210603.exe?v=
1628670954
Mac：
https://cdn.shopify.com/s/files/1/2144/8019/files/MACOS.zip?v=1628671000
QUICK START
③ Power Button① Connect the
USB cable
② Connect the
power cable
Browse support CD, You can choose Windows or MacOS driver for label
printer. Note: Your computer may prompt that there is a virus in the driver
installation, but this is safe, please don't worry
If the printer is USB interface,click the "Get USB Port" to automatically
identifythe USB port other interfaces, click "Install Driver"
Windows
PRINTING SETUP
- 1 -
How to use the LAN port of printer
Get the local IPaddress from Self-test page. The method of printing Self-test
page: Hold down the FEED button in the shutdown state,and then press and
hold the POWER button to power on, when you see the "ERROR" Red right is
ON, then release the FEED button.You can get the IPaddress from the self-test
page (Default IPaddress:192.168.1.100）
If Label printer driver installation is successful, it will automatically pop up
printer properties interface as shown below:
Click "Print Test Page", ifthe printer prints a nommal page, itindicates that the
installation was ucessul.
Note: Ifthe printer prompts "Printing Error", retum to the "Port" option,select
USB0001,or USB002, or USB003... and test it again.
- 2 -
Open the printer properties interface and select"port",as shown in the figure
below Select "Add Port', as shown below:
- 3 -
Select Standard "Generic Nextwork Card"and Next
- 4 -
After"Finish",and then click"Apply：
You can click the"Print Test Page"to have a test:
- 5 -
How to install LABEL driver
1.Double click the LABEL .dmg
2.Double click LABEL_V1.0_signed .pkg to install the driver.
3.Click “continue” button.
Mac
PRINTING SETUP
- 6 -
4.click “Install”
5.Use Touch ID or Enter your password.
- 7 -
6.Click “Close” to finish.
7.Open “System Preferences”,and click “Printers and Scanners”.
- 8 -
Inhaltsverzeichnis
Andere Netum Etikettendrucker Handbücher
