will go off after 5 seconds, and Z309 will remain in the working mode.
4-3 Join the ZigBee Network
After Z309 is turned on, it will search for an existing ZigBee network and send a request to join the
network automatically. While Z309 is under the coverage from a coordinator or a router whose
permit-join feature is enabled, Z309 will be permitted to join the network.
Step1. Enable the permit-join function (valid for 60 seconds) of a coordinator or a router.
Step2. After long pressing the emergency button for 3 seconds to enter the power on state, it will
actively search for the network and ask to join the network of its channel After long
pressing the emergency button for 3 seconds to enter the power on state, it will actively
search for the network and ask to join the network of its channel
Step3. If the network is successfully added, the green indicator flashes for 5 times, otherwise the
indicator does not act. If the network time exceeds 3 minutes, the device will shut down
automatically; If you want to request for additional screening, just press and hold the
emergency button for 3 seconds again.
Note:
After joining a network, Z309 would try to enroll in the ZigBee security system. Please make
sure Z309 and CIE (Control and Indicating Equipment) device have enough power.
4-4 Enroll in the ZigBee Security System
Z309 is a Zone device in the ZigBee security system. Right after Z309 join the ZigBee network, it
will automatically find out a CIE (Control and Indicating Equipment) device and send a registration
request to the CIE device to enroll in the security system. The enrollment has these 3 situations:
A. There is no CIE device or no compatible CIE device in the network
→ the indicator flashes red twice.
B. There is a compatible CIE device in the network, but it is failed to enroll
→ the indicator flashes red 4 times. Users can reboot Z309 to initiate the registration.
C. The enrollment is completed → the indicator flashes red 6 times.
