4.Set up Instruction
On/Off
Power on Insert batteries. (Users may need a screwdriver to open the cover.)
Turn on Press the function key once and the indicator flashes once meaning turning on successfully.
Turn off (Restore to original setting) Press and hold the function key for 5 seconds and the green indicator flashes 20 times.
Power off Remove Batteries.
Note
1. Remove and insert the battery; the device is at off state by default.
2. On/off interval is suggested to be about 10 seconds to avoid the interference of capacitor
inductance and other energy storage components.
3. After insert batteries and press any button, the device will be in engineering test mode.
Network Joining
Never joined the network
Turn on the device to search the network to join.
The green indicator stays on for 5 seconds: success
The green indicator remains off: fail
Had joined the network
(not at factory setting)
Turn on the device to search the previous network to join.
The green indicator stays on for 5 seconds: success
The green indicator remains off: fail
Fail to join the network Suggest to check the device verification information on the gateway or consult your platform
server provider.
Function Key
Press and hold for 5 seconds
Restore to factory setting / Turn off
The green indicator flashes 20 times: success
The green indicator remains off: fail
Press once The device is in the network: green indicator flashes once and sends a report
The device is not in the network: green indicator remains off
The time of pressing the alarm button
exceeds the default
The device is in the network: red indicator flashes once and sends a report
The device is not in the network: red indicator remains off
Note: If the button of the device is consistently pressed that leads to exceeding the set value,
the device will automatically send the data packet and flash once whether the button
is released or not.
