User manual
7
www.newhank.com
8. OSD OPERATING INSTRUCTION
Before setting the menu functions, please make sure the device is connected correctly. Power
switch(at the back of the unit) dial to ON position. The monitor enter into working state. Please dial to
OFF position ,when need to close the unit. After enter into working state, press the "mode" button on
the unit, according to the input video signal to switch signals (under NO menu state, using the shortcut
button on the panel to operate).
Press "MENU" button on the unit, then enter into OSD menu operation. Operate “▲”or“▼”on the unit
to select or adjust the needed options: (color), (menu), (function), (sound). After select options, press
“◄”or“►”on the unit to confirm, then using “▲”or“▼”to select or adjust the value of Analog. After
confirm the needed adjust parameters, using “◄”or“►”to adjust. If need to exit OSD menu, press
“MENU” button again.
a) COLOR menu
Enter into "Color" OSD, press “◄”or“►”button to confirm, then enter to adjust the color parameters,
use ““▲”or“▼”to select adjustment item, then use“◄”or“►”adjust the parameters.
Brightness: To adjust the image's brightness
Contrast: To adjust the brightest and darkest ratio of the image, please note the sense of
picture when adjust, proportion too large or small, will make the picture lose the color of
showy.
Tint: On NTSC Video mode, the image color tint difference is adjustable by tint.
Saturation: To adjust color concentration
Color temperature: Enter into (color)menu, press“◄”or“►” on the unit to confirm, press
“▲”or“▼” to select the form of color temperature, then press “◄”or“►”on the unit to confirm,
then use “▲”or“▼” to select color temperature such as: 9300 K, 7500K, 6500K or USER.(the
monitor leave the factory defaults 6500K)
