NiceRF SA818 Bedienungsanleitung
SA818 MANUAL
Key operation:
1 key SET
Press it to setting mode, the data on LED nixie tube will be flickering, you can change it by key UP or
DOWN; Press key SET again, the item flickering will shift. If the item flickering is the last one, it will quit
setting mode.
2 key UP
When in setting mode, pressing key UP will increase the flickering value.
3 key DOWN
When in setting mode, pressing key DOWN will decrease the flickering value. Otherwise it will move
down the light LED.
4 key PTT
Pressing it will make the module into sending mode, when loosen the module into receiving mode.
5 Dial switch
When sending mode, switch to HIGH will send with high power, switch to LOW will send with low
power.
Set TX frequency
After power on, the LED close to “TXF” is on, indicates that LED nixie tube is displaying TX
frequency. Press key SET, the highest order of frequency will flicker, and can be changed by key UP or
DOWN. Press key SET to set the next order.
Set bandwidth
Press key DOWN, the LED close to “BW” is on, indicates that LED nixie tube is displaying
bandwidth, pressing key SET to setting mode and press key DOWN to change bandwidth.
Set RX subaudio.
Press key DOWN, the two LEDS close to “RXF” and “CTCS” are light up, it indicates that LED nixie
tube is displaying receiving subaudio. Press key SET to change receiving subaudio. If the LED nixie tube
display “00”, it means that no subaudio in receiving mode. If display “tcs”, it means that receiving subaudio
is analog, and if display “cds”, it means that receiving subaudio is digital.
Set volume
Press key DOWN, the LED close to “VOL” is on, press key SET to setting mode, and can be changed
by key UP or DOWN.
Set SQ
Press key DOWN, the LED close to “SQ” is on, press key SET to setting mode, and can be changed
by key UP or DOWN.
Set TX subaudio.
Press key DOWN, the two LEDS close “TXF” and “CTCS” are on, indicates that LED nixie tube is
displaying sending subaudio. Press key SET to change sending subaudio. If the LED nixie tube display “00”,
it means that no subaudio in sending mode. If display “tcs”, it means that sending subaudio is analog, and if
display “cds”, it means that sending subaudio is digital.
Set RX frequency
Press key DOWN, the LED close to “RXF” is on, indicates that LED nixie tube is displaying RX
frequency. Press key SET, the highest order of frequency will flickering, and can be changed by key UP or
DOWN.
Press key SET to set the next order.
Press key UP, it will start to scan frequency and subaudio, the frequency displayed on the LED nixie
tube will increase quickly and check the module whether receive the frequency and the subaudio, it will stop
when there is any signal or press key DOWN.
Inhaltsverzeichnis
Andere NiceRF Steuereinheit Handbücher
Beliebte Steuereinheit Handbücher anderer Marken
Festo
Festo Compact Performance CP-FB6-E Stücklistenhandbuch
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung
JS Automation
JS Automation MPC3034A Bedienungsanleitung
JAUDT
JAUDT SW GII 6406 Series Kurzanleitung
Spektrum
Spektrum Air Module System Bedienungsanleitung
BOC Edwards
BOC Edwards Q Series Bedienungsanleitung
