Night Stick 5522-BATT Bedienungsanleitung
Instructions – 5522-BATT
WARNINGS
yWARNING: It is recommended that a qualied technician perform the replacement
of the rechargeable battery pack in this light.
yWARNING: Failure to follow these instructions may impair the intrinsic safety of
this ashlight.
yWARNING: To prevent ignition of a hazardous atmosphere, do not open the lens
bezel in the hazardous environment. This task must only be performed in an area
known to be non-hazardous.
yWARNING: When exchanging the rechargeable battery pack, use only the
approved 5522-BATT rechargeable battery pack from bayco products.
yWARNING: To prevent ignition of a hazardous atmosphere, the rechargeable
battery pack must only be exchanged in an area known to be non-hazardous.
REPLACING THE LITHIUM-ION RECHARGEABLE BATTERY
yLoosen the locking screw on the side of the bezel. CAUTION: Do NOT remove
the locking screw.
yUnscrew the lens bezel from the housing in a counter-clockwise direction.
yLoosen each of the two charger contact pins located below the Floodlight Lens.
These two screws should be loosened until approximately 1/8” of thread is visible.
CAUTION: Do NOT remove these two screws.
yTurn the light upside down and remove the reector/circuit assembly. CAUTION:
Do NOT touch the reector surface with your nger. Doing so may damage the
reector surface.
yRemove the old 5522-BATT rechargeable battery pack paying attention to the
battery pack’s orientation within the handle. Please recycle the used battery.
yUsing only the approved replacement 5522-BATT rechargeable battery pack from
Bayco Products, slide the new battery pack into the handle of the light using the
directional arrow marked on the side of the pack as a guide for proper orientation.
yAlign the reector/circuit assembly so that the switches on the assembly are aligned with
the switches on the housing. Fully insert the assembly back into the ashlight housing.
yTighten both of the charger contact screws fully.
yReplace the lens bezel onto the housing in a clockwise direction until tight.
yTighten locking screw located on the side of the lens bezel. CAUTION: Do NOT
over-tighten. Doing so may damage the threads.
WARRANTY
2-Year Limited Warranty. Go to www. nightstick.com for warranty information.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098
1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
INS-5522-BATT-21
Instructions – 5522-BATT
WARNINGS
yWARNING: It is recommended that a qualied technician perform the replacement
of the rechargeable battery pack in this light.
yWARNING: Failure to follow these instructions may impair the intrinsic safety of
this ashlight.
yWARNING: To prevent ignition of a hazardous atmosphere, do not open the lens
bezel in the hazardous environment. This task must only be performed in an area
known to be non-hazardous.
yWARNING: When exchanging the rechargeable battery pack, use only the
approved 5522-BATT rechargeable battery pack from bayco products.
yWARNING: To prevent ignition of a hazardous atmosphere, the rechargeable
battery pack must only be exchanged in an area known to be non-hazardous.
REPLACING THE LITHIUM-ION RECHARGEABLE BATTERY
yLoosen the locking screw on the side of the bezel. CAUTION: Do NOT remove
the locking screw.
yUnscrew the lens bezel from the housing in a counter-clockwise direction.
yLoosen each of the two charger contact pins located below the Floodlight Lens.
These two screws should be loosened until approximately 1/8” of thread is visible.
CAUTION: Do NOT remove these two screws.
yTurn the light upside down and remove the reector/circuit assembly. CAUTION:
Do NOT touch the reector surface with your nger. Doing so may damage the
reector surface.
yRemove the old 5522-BATT rechargeable battery pack paying attention to the
battery pack’s orientation within the handle. Please recycle the used battery.
yUsing only the approved replacement 5522-BATT rechargeable battery pack from
Bayco Products, slide the new battery pack into the handle of the light using the
directional arrow marked on the side of the pack as a guide for proper orientation.
yAlign the reector/circuit assembly so that the switches on the assembly are aligned with
the switches on the housing. Fully insert the assembly back into the ashlight housing.
yTighten both of the charger contact screws fully.
yReplace the lens bezel onto the housing in a clockwise direction until tight.
yTighten locking screw located on the side of the lens bezel. CAUTION: Do NOT
over-tighten. Doing so may damage the threads.
WARRANTY
2-Year Limited Warranty. Go to www. nightstick.com for warranty information.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098
1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
INS-5522-BATT-21
Inhaltsverzeichnis
Andere Night Stick Taschenlampe Handbücher
Night Stick
Night Stick NSR-9614XL Bedienungsanleitung
Night Stick
Night Stick NSR-9744XL Bedienungsanleitung
Night Stick
Night Stick XPP-5418GX-01 Bedienungsanleitung
Night Stick
Night Stick NSP-4608B Bedienungsanleitung
Night Stick
Night Stick XPP-5412G Bedienungsanleitung
Night Stick
Night Stick XPP-5422GMX Bedienungsanleitung
Night Stick
Night Stick VIRIBUS BY-XPR-5580G Bedienungsanleitung
Night Stick
Night Stick Intrant XPP-5566GX Bedienungsanleitung
Night Stick
Night Stick Xtreme Lumens TWM-850 Bedienungsanleitung
Night Stick
Night Stick XPR-5522GM Bedienungsanleitung
Night Stick
Night Stick NSR-2070 Bedienungsanleitung
Night Stick
Night Stick NSP-9842XL Bedienungsanleitung
Night Stick
Night Stick XPR-5561G Bedienungsanleitung
Night Stick
Night Stick XPR-5572 Bedienungsanleitung
Night Stick
Night Stick USB-320 Bedienungsanleitung
Night Stick
Night Stick XPP-5411GX Bedienungsanleitung
Night Stick
Night Stick TAC-660 Bedienungsanleitung
Night Stick
Night Stick NSP-4604B Bedienungsanleitung
Night Stick
Night Stick XPP-5420B Bedienungsanleitung
Night Stick
Night Stick XPR 5572G Bedienungsanleitung
