Nilfisk-Advance SC351 Benutzerhandbuch

Nilﬁsk A/S

Kornmarksvej 1

DK-2605 Brøndby

Denmark

Tel.: +45 43 23 40 50

Fax: +45 43 43 77 00

mail.com@nilﬁsk.com

www.nilﬁsk.com

If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this this

procedure may cause damage to the batteries. Charging the batteries after every use is recommended.

PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS

Use and Maintenance

- SC351

ATTENTION! Do not use the machine before you have read and understood the User Manual

3. Always follow the dilution instruc-

tions on the label of the chemical

product used to prepare the

solution. The solution temperature

must not exceed 40°C and be none

foaming

2. Fill the tank with a solution suitable

for the work to be performed.

4. Place the brushes or the pad-holders

under the deck. Use the appropriate

brushes to clean the ﬂoor.

5. Turn the knob on one of the

indicated programs

1. Disconnect the battery charger cable

from the electrical main.

18. Park the machine with the recovery

tank cover open.

16. Clean the machine using a damp

cloth and where needed use a neu-

tral cleaning product.

17. Charge the batteries: Connect the

battery charger cable from the elec-

trical main.

13. Remove the brushes and clean

them.

11. Wash with clean water the recovery

tank.

12. Wash with clean water the vacuum

grid.

14. Take the squeegee off and remove

debris.

15. Check and clean the squeegee

blades.

8. Press the enabling push-button to-

gether with the brush levers for start-

ing ﬂoor cleaning. If solution applied

ﬂows outside the brush housing dur-

ing use, reduce the ﬂow of solution.

6. Press the enabling push-button to-

gether with the brush levers to en-

gage the brush/pad-holder and then

release it.

7 . Press the solution ﬂow control

switches as necessary, depending

on the type of cleaning to be

performed.

9. Turn the knob to “0” position to

switch off the machine.

10. At the end of the work. Empty the

recovery. Then empty the solution

tank.

Nilﬁsk A/S

Kornmarksvej 1

DK-2605 Brøndby

Denmark

Tel.: +45 43 23 40 50

Fax: +45 43 43 77 00

mail.com@nilﬁsk.com

www.nilﬁsk.com

The machine

doesn’t work

as it should?

The suction

doesn’t work

as it should?

The machine

doesn’t clean

as it should?

The brush

don’t work as they

should?

Troubleshooting

- SC351

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual

1Check if the fuse has triggered. 2Check if there are external materials

avoiding brush rotating.

1Check if the power cable is correctly

connected.

2Check if the battery is charged. 3Check if the fuse isn’t burnt out. 4Check if the programs selector is

damaged or has the right function

selected.

1Check if the suction hose is

correctly installed and cleaned.

2Open the recovery tank and check

if the vacuum grid and gasket are

cleaned.

3Check if squeegee blades are dam-

aged or dirty.

4Check if the fuse isn’t burnt out.

1Check if the programs selector has

the right function selected.

2Check if the solution valve is dirty/

clogged.

3Check if the solution reduction

ﬁtting is dirty/clogged.

4 Check brush/pad condition

Andere Handbücher für SC351

Inhaltsverzeichnis

Andere Nilfisk-Advance Schrubber Handbücher

Nilfisk-Advance

Nilfisk-Advance MX 307 H Betriebsanleitung

Nilfisk-Advance

Nilfisk-Advance SC500 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 5321 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance CA 551 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC530 53 BD GO Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance 1300 LPG Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Warrior ST Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advance SC400 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance HSC 585 Betriebsanleitung

Nilfisk-Advance

Nilfisk-Advance Spintec 551 UH Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Captor 5400 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Liberty SC50 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Focus II Rider Installations- und Benutzerhandbuch

Nilfisk-Advance

Nilfisk-Advance Scrubtec 334 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Cr 1100 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance PS 333 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SW4000 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 430S Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SR 1101 B Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance BA 450 Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance CA 430 S Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance Advenger BR 855 Benutzerhandbuch

Nilfisk-Advance

Nilfisk-Advance MX 107 C Bedienungsanleitung

Nilfisk-Advance

Nilfisk-Advance SC6500 40C Bedienungsanleitung

Beliebte Schrubber Handbücher anderer Marken

Olympus

Olympus M200H Bedienungsanleitung

Clarke

Clarke BEXT 100H Installations- und Betriebsanleitung

JOHNY VAC

JOHNY VAC JVC70BCT Bedienungsanleitung

RCm

RCm Elan Series Handbuch

Kärcher

Kärcher B 120 W Bedienungsanleitung

Truvox

Truvox Orbis MotorScrubber 20 Bedienungsanleitung

Numatic

Numatic TTB 4045/100 Bedienungsanleitung

U.S. Products

U.S. Products PEX 500-C-TICK Betriebsanleitung

Mclennan

Mclennan C510 Bedienungsanleitung

Tennant

Tennant T20 LPG Bedienungsanleitung

Columbus

Columbus ARA 66 BM 100 Bedienungsanleitung

Numatic

Numatic TTV 678G / 300T Bedienungsanleitung

American-Lincoln

American-Lincoln 505-945 Bedienungsanleitung

FIORENTINI

FIORENTINI ET 65-75 Bedienungsanleitung

Floorpul

Floorpul ruby 48 blt Benutzerhandbuch

Onyx

Onyx RX-34 Bedienungsanleitung

Dustbane

Dustbane Hurricane 400 Bedienungsanleitung

Sana

Sana EUJ-702 Bedienungsanleitung