Nintendo PCHU-MG5 Bedienungsanleitung

PloffC/wcce

UPRIGHT NO: PCHU-MG5

(Nintendtf)

OPERATION MANUAL

WARNING

This equipment generates, uses and can radiate radio frequency

energy, and if not installed and used in accordance with the in-

structions manual, may cause interference to radio communica-

tions. It has been tested and found to comply with the limits for a

Class Acomputing device pursuant to Subpart Jof Part 15of FCC

Rules, which are designed to provide reasonable protection

against such interference when operated in acommercial environ-

ment. Operation of this equipment in aresidential area is likely to

cause interference in which case the user at his own expense will

be required to tal<e whatever measures may be required to correct

the interference.

WARNING

Use of non-Nintendo parts or modifications of your Nintendo game

circuitry may adversely affect the safety of your game, and may

cause injury to your players.

TABLE OF CONTENTS

I. Location Setup 1

A. Game Installation 1

B. Voltage Selection 1

C. Power On/Off Switch 2

D. Grounding of Game 2

II. Adjustments 3

A. Adjustments of Video Monitor 3

III. Maintenance and Repair 4

A. Fuse Replacements 4

B. Cleaning 4

C. Operation Panel 4

1. Operation Panel Removal 4

2. Micro-Switch Replacement 4

3. Lubrication of 8-way Controller 5

D. Front Screen and Video Monitor Removal 6

E. Game PCB Removal and ROM PCB Exchange 8

IV. Radio Frequency Interface 8

V. Parts List 9-23

PCHU-MG-5 Game Cabinet Assembly 9- 12

PCHU-MG5 Operation Panel Assembly 13- 14

Power Supply Schematic/Parts 15 -17

PCHU-MG5 Wiring Harness 18

PCK1-CPU PCB Assembly 19-21

LED PCB Assembly 22

K7000 Video Monitor 23

Wiring Diagram -Harness 24

Audio Power Supply/Audio Amplifier 25

INSERTS:

PCK1-CPU Schematics A-F

PCHU-MG5 Wiring Diagram/PCK-01-LED Schematic

Monitor Schematics

Self Test and Bookkeeping

WARNING

Check before plugging the game in.

I. LOCATION SETUP

Playchoice- Upright is shipped ready for operation. Please check the following to

insure proper operation.

)

Check the exterior of the game for shipping damage, dents, chips, or

broken parts.

(2) Remove the screws on the rear door panel.

(3) Unlock and open the rear door panel, as well as the service door, and

inspect the interior of the ganne as follows:

a) Check that all the plug-in connectors are firmly connected.

b) Check all main subassemblies (monitor, power supply,

control panel, etc.) to ensure they are securely mounted.

A. Game installation

(1) Requirements

Amperage: 1.2 AMPS

Temperature: to 38 degrees Celsius (32 to 100 degrees Fahrenheit)

Humidity: Not over 95% relative

Space required: 323/8 x233/4

Height: 683/8

B. Voltage selection for the Video Monitor

Before plugging in your game, make sure the terminal block of the power

transformer is correct for your location's line voltage. See figure 1

Orange 125v

Red

Black

1l5v

Brown 105v

White

Black

Fig. 1

C. Power on/off switch

Apower on/off switch is located in the rear of the game at the bottom center

of the cabinet.

WARNING

Please be sure you use agrounded outlet for this game. Failure to

do so may result in destruction of electronic components.

D. Grounding of Game (Use only if 3wire outlet is unavailable.) See Fig. 2

)

Agrounding wire should be connected to agrounding bar or ametal

pipe which is firmly inserted into the ground.

(2) Do not connect the grounding to awater pipe, because polyvinyl-

chloride pipes are sometimes used in water lines, and the electronic

continuity to the ground may be interrupted.

(3) Absolutely do not connect the grounding wire to agas pipe, as this can

be extremely dangerous.

I1C3

Fig. 2

II. VIDEO MONITOR ADJUSTMENTS

HORIZ

GREE

CUT

GREEN DRIVE

BLU CUT OFF

RED DRIVE

RED

CUT OFF HORIZ RASTER

POSITION

DOWN

SCREEN

HORIZ VIDEO

SHIFT

HORIZ HOLD

VERT RASTER POS

VERT SIZE

VERT HOLD

BRIGHTNESS

Fig. 3

D(3not touch the insid(

-WARNING

3of the Video Monitor.

It contains many parts supplied with high volt age.

III. MAINTENANCE AND REPAIR

A. Fuse Replacements

This game contains 2fuses. Replace fuses only with the same type as

listed below.

Specification of Fuses

(1) Main Fuse U.S. :5A 125v/250v

(2) Video Monitor Fuse 2.0A 125V SB

B. Cleaning

The exterior of the game, ail metal parts and all glass parts can be cleaned with

anonabrasive cleanser.

C. Operation Panel

(1) Operation Panel Removal

Before repairing or replacing any switches or 8way Controllers on the Operation

Panel, unplug the game. Open the Service Door, and reach through the opening,

and unlock the Clamps, located at each end on the underside of the Operation

Panel.

(2) Micro-switch Replacement

Whenever you replace any micro-switch on the Operation Panel, aswitch gap

adjustment is needed as shown in Fig. 4. This adjustment is not necessary for

the player option buttons.

Press

ISwitcti Button Ass'y.

.^^

\Micro-switcti

Ga():0.2~0.5mm( 1/128 ~5/256 inc

3=3= ^

Fig. 4Switch gap adjustment

(3) Lubrication for 8way Controller

To maintain the 8way Controller in good condition, lubricate the ball socket and

8way Guide Plate approx. every 3months. See Fig. 5.

Lubricate here"

Fig. 5Lubrication points

D. Front Screen and Video Monitor Removal

(1) Front Screen Removal

To remove the Front Screen, first remove the Control Panel by reaching

through the Service Door and releasing the Control Panel Clasps. Pull the

bottom of the Front Screen toward you allowing it to drop into the slots. Then pull

out toward center of game. See Fig. 6

(2) Video Monitor Removal

If you need to remove the Video Monitor, follow the instructions listed below. But

the following procedure should only be performed by an experienced service

technician.

WARNING

It is recommended the game be left unplugged for at least one hour

before removing the Video Monitor. This will probably discharge the

CRT, but extreme caution is still necessary.

(a) Make sure game is unplugged.

(b) Remove back door and unplug all the harnesses and cables from the Video

Monitor.

machine screws and flat washers. See Fig. 7.

(d) Carefully lift the Video Monitor and pull out toward you.

WARNING

Use extreme caution and do not touch electrical parts

of the yoke area with your hands or with any metal object

in your hands.

Remove the four mounting bolts

and flat washers

Fig. 7

Inhaltsverzeichnis

Andere Nintendo Spielkonsole Handbücher

Nintendo

Nintendo Wii U Bedienungsanleitung

Nintendo

Nintendo 3DS XL Bedienungsanleitung

Nintendo

Nintendo Pokemon Mini Bedienungsanleitung

Nintendo

Nintendo 2DS XL JAN-001 Bedienungsanleitung

Nintendo

Nintendo Super NES Bedienungsanleitung

Nintendo

Nintendo 2DS Bedienungsanleitung

Nintendo

Nintendo Wii U Bedienungsanleitung

Nintendo

Nintendo Switch Con-Jo 6400266L Bedienungsanleitung

Nintendo

Nintendo Wii U Bedienungsanleitung

Nintendo

Nintendo 3DS Bedienungsanleitung

Nintendo

Nintendo Game Boy Advance Bedienungsanleitung

Nintendo

Nintendo Wii U Bedienungsanleitung

Nintendo

Nintendo 3DS XL Bedienungsanleitung

Nintendo

Nintendo 3DS Bedienungsanleitung

Nintendo

Nintendo Switch Carrying case & screen protector Bedienungsanleitung

Nintendo

Nintendo Switch Bedienungsanleitung

Nintendo

Nintendo 1504166 - Game Boy Advance SP Edition... Betriebsanleitung

Nintendo

Nintendo N64 Rumble Pak Bedienungsanleitung

Nintendo

Nintendo TWL-001 Bedienungsanleitung

Nintendo

Nintendo Wii U Bedienungsanleitung

Nintendo

Nintendo Switch Bedienungsanleitung

Nintendo

Nintendo Nintendo Switch Joy-Con HAC 001 Installations- und Benutzerhandbuch

Nintendo

Nintendo RHYTHM HEAVEN Bedienungsanleitung

Nintendo

Nintendo 3DS Bedienungsanleitung

Beliebte Spielkonsole Handbücher anderer Marken

Atari

Atari 2600 Bedienungsanleitung

PLAYNETIC

PLAYNETIC GameNetic Bedienungsanleitung

Sony

Sony SCPH-50008 Bedienungsanleitung

Saitek

Saitek Alchemist Plus Bedienungsanleitung

Sears

Sears Tele-Games 637.99743 Bedienungsanleitung

AYANEO

AYANEO 2 Bedienungsanleitung

Sony

Sony PlayStation 3 (Uncharted: Drake's Fortune Limited Edition... Bedienungsanleitung

Mattel

Mattel My Meebas N2214 Bedienungsanleitung

Entex

Entex PacMan2 Bedienungsanleitung

Sega

Sega 32X Bedienungsanleitung

Saitek

Saitek Cougar Bedienungsanleitung

View-Master

View-Master Interactive Vision Verdrahtungsschema

Sony

Sony SCPH-35003 GT Bedienungsanleitung

Sony

Sony PSP go Bedienungsanleitung

Sony

Sony PSVITA Bedienungsanleitung

Excalibur

Excalibur ABC Wide 333 Bedienungsanleitung

Microsoft

Microsoft XBOX Betriebsanleitung

LEXIBOOK

LEXIBOOK JL2700 Bedienungsanleitung