L
N
DANGER OF ELECTROCUTION
Installation procedure
BEFORE ANY INSTALLATION MAKE SURE THE POWER SUPPLY IS
DISCONNECTED TO AVOID ANY RISK OF ELECTROCUTION.
Directly cut the power supply from the breaker box to avoid any risk of electrocution. This DIN Rail
Box is designed to be used power up, a wrong installation can create a re or an electric shock. The
DIN Rail Box must be installed and connected carefully following the instructions of this user guide.
NodOn® will not be responsible for any loss or damage resulting from a non-respect of the instructions
of this user guide. Cut the power supply before any operation and don’t do any modication if the relay
switch LED located into the Rail DIN Box is ON.
1Cut the power supply of the electrical panel.
2 Unscrew the relay switch terminals you want to connect.
3 Insert the module on the DIN Rail Box while respecting
the direction of insertion of the relay switch, the terminal
block must be located on the left (see gure 1). Make sure
the terminals are well unscrewed and take care to not fold
the pins located inside the box.
INSTALLATION
gure 1 Connection example with
a SIN-2-RS-XX Module
8Turn the power supply back on.
9 For pairing, push 3 times on button of the box
and refer to the relay switch user guide according
to its reference: SIN-2-2-XX, SIN-2-1-XX, SIN-2-RS-XX.
4 Screw the 4 screws of the relay switch to x both elements together.
5Install the box with the relay switch on the DIN Rail of the electrical panel.
6Connect the box to the power supply of your electrical
panel on terminals L and N.
7 Cable relay switch terminals 1 and 2 following
the table below.
Ref. Module 1 2
SIN-2-1-XX ES
SIN-2-2-XX S1S2
SIN-2-RS-XX
