Nordson ColorMax Bedienungsanleitung

Color Chan

e Procedures

ColorMax®Powder Booth with Powder Port Feed Center

and Prodigy®HDLV®Powder Transfer System

1093876A

WARNING:

Allow only qualified personnel to

WARNING:

Allow

only

qualified

personnel

perform the following tasks. Follow the safety

instructions in your powder coating

equipment manuals.

Operator A

1 2

Close the booth doors.

Move the booth offline if it is a

Move

the

booth

offline

Roll On/Roll Off booth. Turn all automatic spray guns off.

Wait until the Gun Blow Off/Purge Cycle is

complete. Go to page 10.

Operator B

1 2

Press the Color Change Start button to

start the automatic gun purge cycle.

Remove the powder lance from the hopper and

insert it into the purge chute.

Rotate the hold-down latch over the lance to

secure it in the chute.

Operator B

345

Disconnect the transfer hoses

from the sieve deck. Connect the transfer hoses to the

purge ports on the back wall of the

feed center.

Turn off the Reclaim and

Virgin Transfer Pumps.

Unclamp the sieve and

rotate the pan so that the

rotate

the

pan

that

the

pan chute dumps into the

waste chute.

Reclamp the sieve and

ttthRli

res

transfer pump.

Operator B

Disconnect the fluidizin

air

line and remove the level

sensor from the feed hopper.

Remove the feed hopper

m th

eed

o e eed ce e

Install a lid on the hopper.

Blow down the lance, purge

chute and hold

down latch

chute

and

hold

down

latch

lance guide, walls, and floor.

Operator B

Turn off the Reclaim

rans

er pump.

Disassemble and clean the

sieve assembly.

Remove the screen gasket

and clean it thoroughly.

Blow off the feed center

walls and floor.

Re-assemble the sieve.

Turn on the Reclaim

transfer pump.

transfer

pump.

Leave the transfer hoses

connected to the purge

ports.

Operator B

WHEN OPERATOR A FINISHES

CLEANING THE BOOTH AND EXITS:

Purge the Virgin

Transfer Pump at the

Bulk Feed Unloader

Bulk

Feed

Unloader

Press the Reclaim

Transfer Purge Start

Transfer

Purge

Start

button to purge the

reclaim pump.

Operator B

Install the new color feed

hopper in the feed center.

Connect the fluidizing air

line to the hopper.

Install the level sensor on

the feed hopper.

Remove the lance from

the purge chute and

the

purge

chute

and

install it through the lance

guide and into the

powder.

Operator A

123

Blow off the inlet duct at the

end of the booth.

Starting from the open end of the

booth, blow off the ceiling, walls, and

floor, working from top to bottom and

When Gun Blow

Off/Purge Cycle is

complete:

Open the vertical duct door and

blow off the duct.

floor,

working

from

top

bottom

and

toward the closed doors.

Swing open the Aerodecks after

blowing them off.

complete:

Blow off doors at

entry end of the

booth. For Hard-to-Clean Powders:

e down the booth interior

inlet duct, and vertical duct with

damp cotton towels.

Andere Handbücher für ColorMax

Inhaltsverzeichnis

Andere Nordson Spritzpistole Handbücher

Nordson

Nordson Encore Series Referenzhandbuch

Nordson

Nordson Kinetix 334593-04 Referenzhandbuch

Nordson

Nordson Encore XL Powder Bedienungsanleitung

Nordson

Nordson Encore LT Automatic Referenzhandbuch

Nordson

Nordson Encore XT Referenzhandbuch

Nordson

Nordson Mastic Gun Referenzhandbuch

Nordson

Nordson WM-1 Referenzhandbuch

Nordson

Nordson Encore Referenzhandbuch

Nordson

Nordson Encore PE Bedienungsanleitung

Nordson

Nordson ColorMax Bedienungsanleitung

Nordson

Nordson Trilogy Bedienungsanleitung

Nordson

Nordson Encore HD Referenzhandbuch

Nordson

Nordson Universal Series Referenzhandbuch

Nordson

Nordson Tribomatic 500 Bedienungsanleitung

Nordson

Nordson Encore LT Bedienungsanleitung

Nordson

Nordson HORIZON 200 Bedienungsanleitung

Nordson

Nordson Encore Bedienungsanleitung

Nordson

Nordson A7A Referenzhandbuch

Nordson

Nordson kinetix Bedienungsanleitung

Nordson

Nordson Trilogy AS Bedienungsanleitung

Nordson

Nordson Vantage Referenzhandbuch

Nordson

Nordson ColorMax3 Bedienungsanleitung

Nordson

Nordson Encore HD Bedienungsanleitung

Nordson

Nordson FP-200 Bedienungsanleitung

Beliebte Spritzpistole Handbücher anderer Marken

SNOWJOE

SNOWJOE Sunjoe 24V-GS-LTW-RM Bedienungsanleitung

Graco

Graco 246737 Gebrauchs- und Pflegehandbuch

Binks

Binks SV100 Bedienungsanleitung

Fimco

Fimco LG-4-3-1 Bedienungsanleitung

AG SPRAY

AG SPRAY FS-ATV-25BL Bedienungsanleitung

Bonide

Bonide 051 Bedienungsanleitung

zogics

zogics Z-DAS Bedienungsanleitung

KISANKRAFT

KISANKRAFT KK-KBS-165 Bedienungsanleitung

Matrix

Matrix SG 650 Bedienungsanleitung

Anest Iwata

Anest Iwata SGA-3 Kurzanleitung

paasche

paasche VV Datenblatt

Carlisle

Carlisle DeVilbiss JGA-510 Bedienungsanleitung

Gardena

Gardena 11120 Bedienungsanleitung

Conrad

Conrad Hobby Airbrush K3 Bedienungsanleitung

wiwa

wiwa 14025 R/F Bedienungsanleitung

Graco

Graco EM 390 Bedienungsanleitung

DeVilbiss

DeVilbiss LUNA2i Bedienungsanleitung

Graco

Graco HydroShield WMBH00 Stücklistenhandbuch