Norsat Element C-Band BUC Bedienungsanleitung

Operator Manual for Element

C-Band 10W BUC

2022-06-01 DOC-001803 Rev A 2

TABLE OF CONTENTS

1.1 Overview.................................................................................................................. 5

Introduction of BUC........................................................................................... 5

Physical Description.......................................................................................... 5

1.2 Safety....................................................................................................................... 6

2.1 Intermediate Frequency (IF)/ 10MHz Reference Input.............................................. 7

2.2 Torque Value............................................................................................................ 8

2.3 RF Output................................................................................................................. 8

2.4 AC/DC Connector..................................................................................................... 8

3.1 Element BUC Installation.........................................................................................10

Check packing list ............................................................................................10

Installation of mounting bracket........................................................................10

Connecting coaxial cable and DC.....................................................................11

Installation of OMT to CPR137G......................................................................11

Waterproof .......................................................................................................11

4.1 Maintenance............................................................................................................13

4.2 Troubleshooting.......................................................................................................13

2022-06-01 DOC-001803 Rev A 3

LIST OF FIGURES

Figure 2-1: F-Type female connector.............................................................................................................................7

Figure 2-2: N-Type female connector.............................................................................................................................7

Figure 2-3: CPR137G RF Output Port ...........................................................................................................................8

Figure 2-4: MS 5pin for AC ............................................................................................................................................9

Figure 2-5: MS 2pin for DC ............................................................................................................................................9

Figure 3-1: Location of mounting bracket holes ...........................................................................................................10

Figure A-4- 1: Element 10W BUC (DC Power).............................................................................................................14

Figure A-4- 2: Element 10W BUC (AC Power).............................................................................................................15

2022-06-01 DOC-001803 Rev A 4

LIST OF TABLES

Table 2-1: Torque Value ................................................................................................................................................8

Table 3-1: Torque Value ..............................................................................................................................................11

Table 3-4: Torque Value ..............................................................................................................................................11

Table B-4- 1: Acronyms and Abbreviations..................................................................................................................16

2022-06-01 DOC-001803 Rev A 5

Introduction

1.1 Overview

The purpose of this document is to provide instruction for installation, operation, and maintenance of the

10W C-band Block Upconverter (BUC).

We recommend that the users familiarize themselves with the product by reading through this manual

before installation to reduce the possibility of incorrect installation and operation.

Introduction of BUC

The BUC is designed to use for VSAT application. Norsat BUC has high linearity and gain stability over the

full operating temperature range. The standard output operating frequency range is 5.850GHz to 6.425GHz.

Other frequency options are also available ranging from 5.850GHz to 7.025GHz. The BUC requires a

reference signal (10MHz) either externally or internally to maintain the correct transmit frequency. The BUC

has either a F-type or N-type female connector for input and CPR137G waveguide with a grooved flange

for output.

Physical Description

AC Picture DC Picture

2022-06-01 DOC-001803 Rev A 6

1.2 Safety

The BUC should be handled with care to avoid potential safety risks. Read the following instructions prior

to using the BUC. Norsat is not responsible for damages occurred by unsafe handling of the product.

1. Do not disassemble the BUC. It may cause malfunction and electrical shock.

2. Input a voltage within the range indicated in the specification.

3. Do not operate the BUC without a load or termination attached to the RF signal output.

4. Do not expose the BUC to standing water. Failure to follow this precaution could result in electric

shock and injury to persons.

5. The BUC should be installed in an electrically stable situation because it may cause serious

injuries to persons as well as damage to the BUC.

6. Do not perform maintenance to the BUC when the power supply is connected.

7. Do not look into the waveguide opening when the BUC is powered on.

8. Do not touch the body during operation of the BUC.

9. Do not operate the BUC out of the operating temperature range, -40C to +55C.

2022-06-01 DOC-001803 Rev A 7

Interfaces

2.1 Intermediate Frequency (IF)/ 10MHz Reference Input

Intermediate Frequency (IF) and 10MHz reference signal are provided through F or N type connector. F or

N type connector is used for the input port as shown in Figure 2-1 and Figure 2-2.

Figure 2-1: F-Type female connector

Figure 2-2: N-Type female connector

CONFIDENTIAL AND PROPRIETARY

2022-06-01 DOC-001803 Rev A 8

2.2 Torque Value

The torque value to connect the coaxial cable is shown in Table 2-1.

Table 2-1: Torque Value

Connector

Torque value (N/m)

F-type

0.39 - 0.49

N-type

0.68 - 1.13

*1 [kg f/cm] = 0.0980 [N/m]

2.3 RF Output

CPR137G waveguide (Grooved) is used for the RF output port as shown in Figure 2-3.

2.4 AC/DC Connector

MS 5pin connector is used for AC and MS 2pin connector is used for DC as shown in Figure 2-4 and Figure

2-5.

Figure 2-3: CPR137G RF Output Port

CONFIDENTIAL AND PROPRIETARY

2022-06-01 DOC-001803 Rev A 9

Figure 2-4: MS 5pin for AC

Figure 2-5: MS 2pin for DC

CONFIDENTIAL AND PROPRIETARY

2022-06-01 DOC-001803 Rev A 10

Installation

3.1 Element BUC Installation

The BUC must be attached to some form of a mounting structure which is usually the antenna feed horn or

the antenna support structure. Specific mounting procedures will depend on the antenna used. The BUC is

designed to be easily mounted on most of antenna produced by manufacturer. Locate and install the

antenna according to the antenna manufacturer’s instructions. Choose an area that is free of interference

from motors and electronic equipment.

Check packing list

Perform an initial inspection upon receiving the BUC as per the following instruction:

•Check that the shipping container is not damaged.

•Check that all items in the packing list are not damaged.

•Check that all items in the packing list are present.

Installation of mounting bracket

Install the mounting bracket using the two (2) M6 mounting holes at each side of BUC as shown in Figure

3-1. The BUC requires a steady flow of air. To provide sufficient airflow, the BUC shall be properly oriented

with the deepest heat sink fins facing up. The BUC has body and cover heat sinks with numerous radiator

fins for cooling. Please do not block the fins so that heat sinks are open to fresh air. Adequate cooling for

the BUC is important in providing years of top performance.

Figure 3-1: Location of mounting bracket holes

Inhaltsverzeichnis

Andere Norsat Industrieanlagen Handbücher

Norsat

Norsat ATOMBKA025 Bedienungsanleitung

Beliebte Industrieanlagen Handbücher anderer Marken

ABB

ABB Unifix AD Handbuch

Mark 7

Mark 7 Evolution Bedienungsanleitung

Husky

Husky HyPET Bedienungsanleitung

bora

bora PM-1800 Bedienungsanleitung

Grizzly

Grizzly T32428 Bedienungsanleitung

Siemens

Siemens 8MF1 Series Bedienungsanleitung

ABB

ABB HT610965 Bedienungsanleitung

ABB

ABB SafeLink Bedienungsanleitung

Phoenix

Phoenix PHX-150 Bedienungsanleitung

ABB

ABB A165-L32 Bedienungsanleitung

ABB

ABB HT842936 Bedienungsanleitung

Hermetica

Hermetica 10 Series Bedienungsanleitung

HORNER

HORNER OEE Solution Bedienungsanleitung

Hammerhead

Hammerhead HG375 Bedienungsanleitung

SCHUNK

SCHUNK VERO-S NSE-A3 138 Gebrauchsanweisung

ABB

ABB HT566657 Bedienungsanleitung

Webasto

Webasto GSE CAN Bedienungsanleitung

ABB

ABB HT614003 Bedienungsanleitung