Nuvoton ISD15D00 Programmierhandbuch

FAQ

2012.11 Ver.00

ISD15D00/3800 trouble shooting manual

1 Description

This document describe troubleshooting steps and methods of ISD15D00 and ISD3800. User

can check problems with check list or reference the check steps of chapter3: VPE + Dongle +

Demo board.

2 Check list:

Environment1: VPE + Dongle + Demo board

①Check clock(3.2)：Check CLK CFG by VPE & check J9 Jumper* if use EXT_RES or XTAL

②Check CFG(3.1)

③Already burn device(3.4)?

Environment2: VPE + Dongle + User’s board with ISD15D00/3800

①Check clock(3.2)：Check CLK CFG by VPE & check crystal or resistor for EXT_RES

②Check CFG(3.1)

③Already burn device(3.4)?

Environment3: User’s MCU + Demo board

①Check SPI commands sequence(5.1) and reset signal

②Check SPI waveform by scope(3.6). Also check if SSB pull high after command.

③Already burn device(3.4)?

④Check clock(5.4)：Check CLK CFG & check J9 Jumper* if use EXT_RES or XTAL

⑤Check CFG(5.5)

⑥Check status byte(5.6)

General check: for any ISD3800 application environment

⑦Check if Flash is empty. Check system VMs: POI VM, PU VM and Wakeup VM. Check

Schematic.

⑧Understand timing

⑨Know how to unlock a device which is locked by bad flash content.

⑩Know how to solve the programming difficulty under certain configurations.

※J9’s printing “Ext_Res”and “XTAL”are reversed. Be careful Jumper’s position.

FAQ

2012.11 Ver.00

3 VPE + Dongle + Demo board:

Hardware：①Dongle：ISD-ES-MINI-USB

②Demo Board：ISD-DEMO3800 or ISD-DEMO15D00

③Speaker

Software：ISD-VPE15D00

Example project：C:\ProgramFiles\ISD-VPE15D00\ISD15D00example_1\ISD15D00example_1.prj

FAQ

2012.11 Ver.00

3.1 Check CFG : Check by VPE, click “Read CFG” at page “Configuration Registers”.

By example1：CFG02：0x48

CFG05：0x80

CFG18：0xAB

If need to modify CFG, type in value and click “Write CFG”.

※For detailed configuration register, reference Section 12.3 of design guide.

FAQ

2012.11 Ver.00

3.2 Check Clock: Check by VPE, click “Read CLK CFG” at page “Audio Cmds”.

By example1：CLK CFG：0x34

Table 12-1 of Design Guide：Clock Configuration Register Description

Table 12-2：Clock Configuration source

※For detailed clock configuration, reference Section 12.1 of design guide.

FAQ

2012.11 Ver.00

3.3 Play Voice Prompt：choose a sound and click “Play to device”.

“Play to device”will transfer sound data through SPI to Demo board and play it immediately. It does

not play VP in Flash.

FAQ

2012.11 Ver.00

3.4 Burn Device: will download .mem file into flash. Before executing SPI commands, be sure

already “Burn Device”.

Before “Burn Device”, execute “Create Programming File”and will generate .mem file. (Example1：

C:\Program Files\ISD-VPE15D00\ISD15D00example_1\ISD15D00example_1.mem)

FAQ

2012.11 Ver.00

3.5 Execute by SPI commands:

①choose a VP and click “Play VP”.

②choose a VM and click “Execute VM”

Just send SPI commands but without sound data. Play VP and VM in Flash, programmed by “Burn

Device”before.

FAQ

2012.11 Ver.00

③“Send SPI Cmd”：With proper ①configuration and ②burn device and ③PU(Power Up), send

SPI command Play VP(0xA6) should be played.

By example1, to play VP of index C：A6000C

Section 13.1.1 of design guide：Play Voice Prompt

※For detailed SPI commands, reference Chapter 13 of design guide.

FAQ

2012.11 Ver.00

3.6 Check SPI waveform:

Measure waveforms of SCLK, SSB, MISO, MOSI.

FAQ

2012.11 Ver.00

Waveform1 of whole 0xA6000C by 50us：

Check if SSB pull high after each command.

Waveform2 of detailed 0xA6000C by 10us：

MISO response：0x60 0x60 0x60

Dieses Handbuch passt für folgende Modelle

Andere Nuvoton Hauptplatine Handbücher

Nuvoton

Nuvoton NAU82011WG Bedienungsanleitung

Nuvoton

Nuvoton NuMicro 8051 Series Bedienungsanleitung

Nuvoton

Nuvoton NuTiny-SDK-120 Bedienungsanleitung

Nuvoton

Nuvoton NuMaker-Server-NUC980 Bedienungsanleitung

Nuvoton

Nuvoton NuMicro NuTiny-SDK-NANO100 Bedienungsanleitung

Nuvoton

Nuvoton NuMicro series Bedienungsanleitung

Nuvoton

Nuvoton NuMicro NUC126 Series Bedienungsanleitung

Nuvoton

Nuvoton NuMaker-M071MD Bedienungsanleitung

Nuvoton

Nuvoton NuMaker-M030GTD Bedienungsanleitung

Nuvoton

Nuvoton NuMaker N9H26K Series Bedienungsanleitung

Nuvoton

Nuvoton NuMicro NuMaker-IoT-MA35D1-A1 Bedienungsanleitung

Nuvoton

Nuvoton NuMicro M480 Series Bedienungsanleitung

Nuvoton

Nuvoton NuMicro NuMaker-HMI-MA35D1-S1 Bedienungsanleitung

Nuvoton

Nuvoton CODEC 8812 series Bedienungsanleitung

Nuvoton

Nuvoton NuMicro NuMaker-IoT-M467 Bedienungsanleitung

Nuvoton

Nuvoton ISD-DEMO15100 Bedienungsanleitung

Nuvoton

Nuvoton NuMicro NuMaker-NUC029L Bedienungsanleitung

Nuvoton

Nuvoton NuMicro NuMaker-M0A23EC Bedienungsanleitung

Nuvoton

Nuvoton NuMaker-M0A23OC Bedienungsanleitung

Nuvoton

Nuvoton NuMaker NUC1262SE Bedienungsanleitung

Nuvoton

Nuvoton NuMicro series Bedienungsanleitung

Nuvoton

Nuvoton NuMicro M252 Series Bedienungsanleitung

Nuvoton

Nuvoton NuMicro NuMaker-NUC029SGE Bedienungsanleitung

Nuvoton

Nuvoton ISD93 Series Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Biostar

Biostar M7VIT Bravo Bedienungs- und Montageanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

EPOX

EPOX MU-8KHA0010 Bedienungsanleitung