CBT3126_2 © NXP B.V. 2008. All rights reserved.
Product data sheet Rev. 02 — 23 October 2008 4 of 15
NXP Semiconductors CBT3126
Quad FET bus switch
7. Limiting values
[1] The input and output negative voltage ratings may be exceeded if the input and output clamp current ratings are observed.
[2] The package thermal impedance is calculated from JESD51-7.
[3] For SO14 package; Ptot derates linearly with 8 mW/K above 70 °C.
[4] For SSOP14, SSOP16 and TSSOP14 packages; Ptot derates linearly with 5.5 mW/K above 70 °C.
8. Recommended operating conditions
9. Static characteristics
Table 4. Limiting values
In accordance with the Absolute Maximum Rating System (IEC 60134).
Symbol Parameter Conditions Min Max Unit
VCC supply voltage −0.5 +7.0 V
VIinput voltage [1] −0.5 +7.0 V
ICC supply current continuous current through each VCC or GND pin - 128 mA
IIK input clamping current VI<0V −50 - mA
Tstg storage temperature −65 +150 °C
Ptot total power dissipation Tamb = −40 °C to +125 °C[2]
SO14 package [3] - 500 mW
SSOP14 and SSOP16 package [4] - 500 mW
TSSOP14 package [4] - 500 mW
Table 5. Operating conditions
All unused control inputs of the device must be held at V
CC
or GND to ensure proper device operation.
Symbol Parameter Conditions Min Max Unit
VCC supply voltage 4.5 5.5 V
VIH HIGH-level input voltage 2.0 - V
VIL LOW-level input voltage - 0.8 V
Tamb ambient temperature operating in free-air −40 +85 °C
Table 6. Static characteristics
T
amb
=
−
40
°
C to +85
°
C.
Symbol Parameter Conditions Min Typ[1] Max Unit
VIK input clamping voltage VCC = 4.5 V; II=−18 mA - - −1.2 V
Vpass pass voltage VI=V
CC = 5.0 V; IO=−100 µA - 3.8 - V
IIinput leakage current VCC = 5.5 V; VI= GND or 5.5 V - - ±1µA
ICC supply current VCC = 5.5 V; IO= 0 mA;
VI=V
CC or GND --3µA
∆ICC additional supply current control pins; per input;
VCC = 5.5 V; one input at 3.4 V,
other inputs at VCC or GND
[2] - - 2.5 mA
CIinput capacitance control pins; VI= 3 V or 0 V - 1.7 - pF
Cio(off) off-state input/output capacitance VO=3Vor0V;OE = VCC - 3.4 - pF
