Oase Vitronic 11 W Bedienungsanleitung

Vitronic

11 W, 18 W, 24 W, 36 W, 55 W

Operating instructions

Downloaded from www.watergardeningdirect.com

Original operating manual.

WARNING

Disconnect all electrical units in the water from the power supply be-

fore reaching into the water. Otherwise there is a risk of injuries or

death by electrocution.

This unit can be used by children aged 8 and above and by persons

with reduced physical, sensory or mental capabilities or lack of expe-

rience and knowledge if they are supervised or have been instructed

on how to use the unit in a safe way and they understand the hazards

involved. Do not allow children to play with the unit. Only allow chil-

dren to carry out cleaning and user maintenance under supervision.

Safety information

Electrical connection

•Special regulations apply to electrical installation in outdoor areas. Only allow a qualified elec-

trician to perform the electrical installation.

– The qualified electrician has the required professional training, knowledge and skills to per-

form electrical installations in outdoor areas. The qualified electrician can detect potential

risks and adheres to regional and national standards, regulations and directives.

– For your own safety, please consult a qualified electrician.

•Only connect the unit if the electrical data of the unit and the power supply match.

•Only plug the unit into a correctly installed outlet. Ensure that the unit is fused for a rated

fault current of max. 30 mA by means of a fault current protection device.

•Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use

(splash-proof).

•Protect open plugs and sockets from moisture.

Downloaded from www.watergardeningdirect.com

Safe operation

•Do not use the unit, if electrical lines or the housing are damaged.

•A damaged connection cable cannot be replaced. Dispose of the unit.

•Do not carry or pull the unit by its power cable.

•Route lines so that they are protected from damage and nobody can trip over them.

•Never make technical modifications to the unit.

•Only carry out work on the unit that is described in this manual.

•Only use original spare parts and accessories.

Intended use

Only use the product described in this manual as follows:

•For cleaning garden ponds.

•For operation with clean water.

•Operate the product in compliance with the technical data. (→ Technical data)

The following restrictions apply to the unit:

•This product is not suitable for general lighting, but is only intended for the purpose described

here.

•Never operate the UVC lamp outside the casing or use it for any other purpose. The UVC radia-

tion is harmful to the eyes and skin even in small doses.

•Do not use for commercial or industrial purposes.

•Never run the unit without water.

•Never use the unit with fluids other than water.

•Not to be used for sterilizing drinking water or other fluids.

•Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.

Downloaded from www.watergardeningdirect.com

Product description

Scope of delivery

VTC0001

Vitronic

11 W

18 W, 24 W, 36 W, 55 W

Description

Quantity

Unit head

Casing

Transparent stepped hose adapter with O

-ring

•

For hose diameter 19 … 38 mm

–

Transparent stepped hose adapter with union nut and flat seal

•For hose diameter 25 … 38 mm

–

UVC lamp

•

Vitronic 11 W: pre-installed at factory

–

Hose clip 20

… 32 mm

–

Hose clip 35

… 50 mm

–

Downloaded from www.watergardeningdirect.com

Properties

The UV radiation of the UVC clarifier removes suspended algae, bacteria and germs. The UVC

clarifier is integrated in the water circuit, ideally upstream of a pond filter.

Symbols on the unit

The unit is protected against splash water and against contact with dangerous

compo-

nents.

Dangerous UVC radiation.

Protect the unit from direct sunlight.

The lamp is suitable for direct fastening to normally flammable mounting surfaces.

Protect the unit from freezing temperatures.

Do not dispose of the unit with normal household waste.

Read the operating instructions.

Installation and connection

Vitronic 11 W

•It is not necessary to remove the unit head in order to fasten the casing on the ground.

•The UVC lamp has been pre-installed at the factory.

Vitronic 18 W, 24 W, 36 W, 55 W

•It is necessary to remove the unit head before fastening the casing on the ground.

(→ Dismantling the unit head)

•The UVC lamp was not pre-installed at the factory. Insert the UVC lamp in the unit head before

reinstalling the unit head. (→ Cleaning the quartz glass / Replacing the UVC lamp)

Downloaded from www.watergardeningdirect.com

Installing the unit

•Install the unit at least 2 m from the edge of the pond.

•Only install the unit in the permitted positions. This ensures fault-free operation.

•Allow sufficient space for carrying out maintenance work.

VTC0016

VTC0006

Downloaded from www.watergardeningdirect.com

Establishing the connections

•Use hoses that are suitable for a pressure of at least 1 bar.

•Shorten the stepped hose adapters according to the hose diameter in use.

•Secure the hose with a hose clip.

•Hand-tighten the union nut of the stepped hose adapter.

•Screw the stepped hose adapter with the flat seal or O-ring onto the connection so that the

connection is leak-tight.

•You can choose from the two connections arranged opposite each other to ensure that the

hose is routed optimally.

– Use the closing cap to close the connection that is not in use.

– Vitronic 55 W: The closing cap has an inspection glass for function checks.

VTC0007

Downloaded from www.watergardeningdirect.com

Connecting the unit to the flow-through filter.

Vitronic 18 W, 24 W, 36 W

The unit is suitable for connection to flow-through filters. Both outlet sockets are screwed to

the inlet nozzles on the flow-through filter. Adhere to the instructions for use of the flow-

through filter.

How to proceed:

1. Unscrew the closing cap.

2. Guide the two outlet sockets with the flat seal through the two holes in the container wall of

the flow-through filter.

3. Screw the inlet nozzle with the O-ring onto the outlet socket and hand-tighten the inlet noz-

zle.

4. Connect the supply hose to the inlet socket. (→ Establishing the connections)

VTC0011

Commissioning/start-up

Start-up sequence:

1. Switch on the pump and wait until the casing of the UVC clarifier is filled with water.

2. Switch on the UVC clarifier.

– Never run the UVC clarifier without water flowing through.

3. Check the UVC clarifier function.

4. Check all connections for leaks.

Downloaded from www.watergardeningdirect.com

Switching ON/OFF

•Switching on:Plug the power plug into the outlet.

– The unit switches on immediately.

•Switching off: Pull the power plug from the outlet.

Checking the function

Function check

Vitronic

11 W

18 W, 24 W, 36 W

55 W

The function display is lit when the UVC lamp is

switched on.



The UV light shines through the transparent

stepped hose adapter when the UVC lamp is

switched on.





The UV light shines through the closing cap

when the UV lamp is switched on.





VTC0010

Maintenance and cleaning

NOTE

Do not use aggressive cleaning agents or chemical solutions. These agents can damage the

housing, impair the function of the device and harm animals, plants and the environment.

Only clean the unit from the outside with clear water and a soft brush.

•Recommended cleaning agent for removing stubborn limescale deposits:

– Pump cleaning agent PumpClean from OASE.

– Vinegar- and chlorine-free household cleaning agent.

Downloaded from www.watergardeningdirect.com

Dismantling the unit head

CAUTION

The ultra-violet radiation of the UVC lamp can burn your eyes and skin.

Never operate the UVC lamp outside out the casing or in a damaged casing.

Disconnect the unit from the power grid before starting any maintenance work or before re-

placing the UVC lamp.

CAUTION

The quartz glass and UVC lamp could break and cause cuts.

Act with caution when performing work on the UVC clarifier in order to avoid cuts.

Avoid shocks, impacts and abrupt movements to prevent the glass from breaking.

For safety reasons, the UVC lamp can only be turned on when the UVC clarifier is properly

installed in the unit.

Vitronic 11 W

How to proceed:

•Turn the unit head counter-clockwise up to the stop and carefully pull it out of the casing to-

gether with the O ring.

Vitronic 18 W, 24 W, 36 W, 55 W

How to proceed:

•Push down the snap-fit hook, then turn the unit head counter-clockwise up to the stop and

carefully pull the unit head out of the casing.

VTC0003

Downloaded from www.watergardeningdirect.com

Andere Handbücher für Vitronic 11 W

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Oase Sterilisator Handbücher

Oase

Oase Bitron Gravity Bedienungsanleitung

Beliebte Sterilisator Handbücher anderer Marken

Dust Free

Dust Free LightStick Bedienungsanleitung

Euronda

Euronda E9 Next 18L Bedienungsanleitung

UVPLUS

UVPLUS ALS UVP201R Bedienungsanleitung

SterileLight

SterileLight Illumicide SL-UVC-IDC-01-B Bedienungsanleitung

Norka

Norka BUENOS AIRES UV-C 997 100 02 Series Bedienungsanleitung

CertoClav

CertoClav Vacuum Pro 45 Bedienungsanleitung

Chicco

Chicco SterilNatural 2in1 Bedienungsanleitung

Market Forge Industries

Market Forge Industries Sterilmatic Bedienungsanleitung

Philips AVENT

Philips AVENT SCF271/20 Bedienungsanleitung

Easypix

Easypix SteriBox SB1 Bedienungsanleitung

ASP

ASP sterrad NX Bedienungsanleitung

Vital Baby

Vital Baby NURTURE advanced pro UV mini Bedienungsanleitung

NUK

NUK 10.256.444 Bedienungsanleitung

Chicco

Chicco SterilNatural Bedienungsanleitung

Philips

Philips SCF276/01 Bedienungsanleitung

Reverberi

Reverberi BABY S Bedienungsanleitung

Technaxx

Technaxx TX-151 Bedienungsanleitung

Memmert

Memmert SF PLUS Series Bedienungsanleitung