Oceanic Proplus 4.0 Bedienungsanleitung

PROPLUS 4.0 OPERATING MANUAL

PROPLUS 4.0

DIVE COMPUTER

OPERATING MANUAL

PROPLUS 4.0 OPERATING MANUAL

CONTENTS

NOTICES 3

GETTING STARTED 5

BASICS 6

ACTIVATION 6

BUTTONS 8

DIVE FEATURES 10

DTR (DIVE TIME REMAINING) 11

NO DECOMPRESSION 11

O2 MIN (OXYGEN TIME REMAINING) 11

BAR GRAPHS 11

VARIABLE ASCENT RATE INDICATOR 12

TISSUE LOADING BAR GRAPH 12

DUAL ALGORITHM®12

CONSERVATIVE FACTOR 12

DEEP STOP 12

SAFETY STOP 13

LOW BATTERY 13

AUDIBLE ALARM 14

NORM SURFACE MODE 15

ON THE SURFACE BEFORE A DIVE 16

NORM MAIN MENU 16

ALT 1 (LAST) 16

ALT 2 17

ALT 3 17

FLY/DESAT 17

PLAN 18

LOG 18

SET GAS 19

SET ALARMS 20

1: AUDIBLE 20

2: DEPTH 21

3: EDT (ELAPSED DIVE TIME) 21

4: TLBG (TISSUE LOADING BAR GRAPH) 21

5: DTR (DIVE TIME REMAINING) 22

6: TURN PRESS 22

7: END PRESS 22

SET UTILITIES 23

1: WATER TYPE 23

2: UNITS 23

3: DEEP STOP 24

4: SAFETY STOP 24

5: ALGORITHM 24

6: CONSERVATIVE FACTOR 25

7: GLO (BACKLIGHT) DURATION 25

8: SAMPLE RATE 25

9: BLUETOOTH 26

SET TIME 26

SET MODE 27

HISTORY 27

SN (SERIAL NUMBER) 27

NORM DIVE MODE 28

INITIATING A DIVE 29

NO DECOMPRESSION DIVE MAIN 29

ALT 1 29

ALT 2 29

ALT 3 30

DEEP STOP PREVIEW 30

DEEP STOP MAIN 30

SAFETY STOP MAIN 30

SURFACING 31

DECOMPRESSION 32

DECOMPRESSION ENTRY 32

DECOMPRESSION STOP MAIN 32

CONDITIONAL VIOLATION 32

DELAYED VIOLATION 1 33

DELAYED VIOLATION 2 33

DELAYED VIOLATION 3 33

VIOLATION GAUGE MODE DURING A DIVE 34

VIOLATION GAUGE MODE ON THE SURFACE 34

HIGH PO234

HIGH O2SAT (OXYGEN SATURATION) 35

GAUGE MODE 37

ON THE SURFACE BEFORE A DIVE 38

GAUGE SURF MAIN MENU 38

INITIATING A DIVE 38

REFERENCE 39

UPLOADING/DOWNLOADING DATA 40

CARE AND CLEANING 40

INSPECTIONS AND SERVICE 40

BATTERY REPLACEMENT 40

ALTITUDE SENSING AND ADJUSTMENT 42

TECHNICAL DATA 43

PROPLUS 4.0 OPERATING MANUAL

LIMITED TWO-YEAR WARRANTY

For details, refer to the Product Warranty Registration Card provided. Register on line at www.OceanicWorldwide.com

This operating manual is copyrighted, all rights are reserved. It may not, in whole or in part, be copied, photocopied, reproduced, translated, or

reduced to any electronic medium or machine readable form without prior consent in writing from either Oceanic or Pelagic.

ProPlus 4.0 Operating Manual, Doc. No. 12-5669

San Leandro, CA USA 94577

TRADEMARK, TRADE NAME, AND SERVICE MARK NOTICE

Oceanic, the Oceanic logo type, ProPlus 4.0, and the ProPlus 4.0 logo are registered and unregistered trademarks, trade names, and service marks

of Oceanic. The Graphic Diver Interface, Tissue Loading Bar Graph (TLBG), Pre-Dive Planning Sequence (PDPS), OceanLog, and Dual Algorithm are

all registered and unregistered trademarks, trade names, and service marks of Pelagic. All rights are reserved.

PATENT NOTICE

U.S. patents have been issued to protect design features of our products. The list of patents issued and pending are available at dive-patent.com.

DECOMPRESSION MODEL

The programs within the ProPlus 4.0 simulate the absorption of nitrogen into the body by using a mathematical model. This model is merely a way

to apply a limited set of data to a large range of experiences. The ProPlus 4.0 dive computer model is based upon the latest research and experi-

ments in decompression theory. Still, using the ProPlus 4.0, just as using the U.S. Navy (or other) No Decompression Tables, is no guar-

antee of avoiding decompression sickness, i.e. “the bends.” Every diver’s physiology is different, and can even vary from day to day. No

machine can predict how your body will react to a particular dive prole.

NOTICES

PROPLUS 4.0 OPERATING MANUAL

Welcome

OCEANIC

and

THANK YOU

for choosing the

ProPlus

4.0

PROPLUS 4.0 OPERATING MANUAL

GETTING STARTED

PROPLUS 4.0 OPERATING MANUAL

BASICS

The ProPlus 4.0 is an easy to use dive computer utilizing a two button interface. Divers may choose between either Dive or Gauge Mode. Though

the ProPlus 4.0 is easy to use, you will get the most out of your new ProPlus 4.0 if you take some time to familiarize yourself with its displays and

operation. Information has been organized into easy to follow sections to aid you in learning all you need to know. There is also a glossary at the

end of this guide for any terms that may sound unfamiliar to you.

ACTIVATION

To activate the ProPlus 4.0, press and release either button. The ProPlus 4.0 will also turn on if its metal contacts become wet and you descend

greater than 1.5 m (5 ft) for 5 seconds. The H2O ACT (water activation) feature may be disabled if that is your preference. Disabling the H2O ACT

feature is described in the Dive Surface Mode chapter, p. 26.

• Upon activation the unit will enter a Diagnostic Mode. The ProPlus 4.0 checks the display and voltage at this time to ensure that everything is

within tolerance.

• It will also check ambient barometric pressure, and calibrate present depth as 0 ft (m). When at 3001 ft (916 m), or higher, it will adjust depth for

the higher altitude.

• After the Diagnostic check, the ProPlus 4.0 will display the surface screen in Dive Mode.

NOTE: The ProPlus 4.0 has no off button or command. If no buttons are pressed or dives made within 10 minutes the computer

will enter Sleep Mode. The screen and Bluetooth (if set ON) shut down, to save battery life, while in Sleep Mode. To wake the

computer press any button. Additionally, the unit will completely shut itself off after 2 hours of inoperation. However, the ProPlus

4.0 will stay on, in Sleep Mode, for a 24 hour period after the dive, counting down FLY (time to fly) and SAT (desaturation time) if

a dive has been made.

PROPLUS 4.0 OPERATING MANUAL

DISPLAY ICONS

1 Depth ID (units)

2 Low Battery

3 Partial Pressure of Oxygen

4 Gas Time Remaining

5 Dive Number

6 Bluetooth (on)

7 Tissue Loading Bar Graph

8 Log

9 History

10 Surface Time

11 Time To Fly

12 Oxygen Saturation

13 Variable Ascent Rate Indicator

14 Algorithm

15 Gas #

16 Value is Maximum

17 Safety Stop

18 Descend, Ascend, or Stop

19 Deep Stop

20 Time To Surface

21 Temperature

22 Saturation

23 Fraction of Oxygen

24 Dive Time

25 Value is Pressure

8 9 10 11 12

116

19 20 21 22

23 25

PROPLUS 4.0 OPERATING MANUAL

SELADV

BUTTONS

The ProPlus 4.0 utilizes 2 control buttons called the ADV (Advance) and SEL (Select) buttons. They allow you to select

mode options and access specic information. They are also used to enter settings, activate the backlight, and acknowl-

edge the audible alarm. Throughout this manual they will be referred to as the ADV and SEL buttons.

Pressing different combinations of these buttons will navigate through different menus and options of the ProPlus 4.0. The

symbols in the table below will illustrate how to proceed through the menus.

SYMBOL MEANING

PRESS BUTTON LESS THAN 2 SECONDS

HOLD BUTTON GREATER THAN 2 SECONDS

PROPLUS 4.0 OPERATING MANUAL

BUTTON FUNCTIONS

ACTION FUNCTION

Press Any Button •to activate the ProPlus 4.0

SELADV

•to access Alt screens

•to advance or step through menus

•to toggle or change setpoints

SELADV

•to scroll quickly, changing setpoints

•to scroll quickly through menu lead-in screens

(selections)

SELADV

•to select, access, step forward through selections, or

save a setting

•to activate the backlight

SELADV

•to step back through selections in a submenu

SELADV

•to exit a menu directly to the main screen

PROPLUS 4.0 OPERATING MANUAL

DIVE FEATURES

Inhaltsverzeichnis

Andere Oceanic Tauchinstrument Handbücher

Oceanic

Oceanic BUD Bedienungsanleitung

Oceanic

Oceanic JETPACK Bedienungsanleitung

Oceanic

Oceanic Personal Dive Computer Veo 100Nx Bedienungsanleitung

Oceanic

Oceanic VEO 250 Bedienungsanleitung

Oceanic

Oceanic GEO Bedienungsanleitung

Oceanic

Oceanic versa Bedienungsanleitung

Oceanic

Oceanic Dive Computer Pro Plus 2 Bedienungsanleitung

Oceanic

Oceanic BioDry Suit Bedienungsanleitung

Oceanic

Oceanic Veo 180Nx Bedienungsanleitung

Oceanic

Oceanic DELTA 2 Handbuch

Oceanic

Oceanic AIR XS II Bedienungsanleitung

Oceanic

Oceanic VEO 2.0 Bedienungsanleitung

Oceanic

Oceanic VT 4.0 Bedienungsanleitung

Oceanic

Oceanic DataMax Sport Bedienungsanleitung

Oceanic

Oceanic Dive Computer Pro Plus 2 Bedienungsanleitung

Oceanic

Oceanic PROPLUS X Bedienungsanleitung

Oceanic

Oceanic versa Pro Bedienungsanleitung

Oceanic

Oceanic Data 100 Bedienungsanleitung

Oceanic

Oceanic GEO Bedienungsanleitung

Oceanic

Oceanic VEO 100 Nx Bedienungsanleitung

Oceanic

Oceanic OCS Bedienungsanleitung

Oceanic

Oceanic OC1 Bedienungsanleitung

Oceanic

Oceanic Personal Dive Computer Veo 100Nx Bedienungsanleitung

Oceanic

Oceanic GEO Bedienungsanleitung

Beliebte Tauchinstrument Handbücher anderer Marken

Sherwood

Sherwood Amphos Bedienungsanleitung

Zeagle

Zeagle N2ition Bedienungsanleitung

Tusa

Tusa Q 1203 CE Leitfaden

Sherwood Scuba

Sherwood Scuba Insight Montageanleitung

OCEANS

OCEANS S1 Supersonic Bedienungsanleitung

SUBMERSIBLE SYSTEMS

SUBMERSIBLE SYSTEMS Spare Air 600 Bedienungsanleitung

heinrichs weikamp

heinrichs weikamp OSTC 2 Bedienungsanleitung

Omer

Omer SP2 Bedienungsanleitung

Apeks

Apeks BLACK SAPPHIRE Bedienungsanleitung

Waterproof

Waterproof DRYSUIT Bedienungsanleitung

Dräger

Dräger PAS AirPack 1 Bedienungsanleitung

Dive Lab

Dive Lab KIRBY MORGAN KMB 18 Bedienungsanleitung

Ratio Computers

Ratio Computers iDive Bedienungsanleitung

CFA

CFA MSA G1 Bedienungsanleitung

Genesis

Genesis Centauri Bedienungsanleitung

TREND

TREND GAUGE/60 Bedienungsanleitung

Tusa

Tusa B.C.J. Bedienungsanleitung

Dräger

Dräger Panorama Nova Dive Bedienungsanleitung