Okina LTV15RS Bedienungsanleitung
Copyright © 2012. All Rights Reserved. M-101_M-102
www.okinausa.com R201202-V08
LTV15RS 15” LED Backlight LCD Monitor
LTV19RS 19” LCD Monitor
HDMI, BNC In, BNC Loop Out & RS485
USER MANUAL
FEATURES
Compatible with VGA (640 x 480), SVGA (800 x 600), XGA (1024 x 768), SXGA (1280 x
1024) resolution -- SXGA for 19" LCD only
Built-in RS485 function to operate PTZ dome or camera / DVR and monitor group
management by remote controller
Video input HDMI x1 / BNC x 1 / VGA x 1 ; Video output BNC x1
Audio input RCA x2 / phone jack x 1
Eco-friendly concept with LED backlight: Saves energy & power - *Only available for LTV15RS
Picture-In-Picture feature that allow multi-picture display
High brightness level and contrast ratio with super wide viewing angle
Built-in speaker x 2
Built-in 3D comb filter and 3D de-interlace for crisp picture quality
Fast response time and refresh rate without time lagging
Provides 6500°K and 9300°K color temperature selection for user's preference
Video looping Output supports 75ohm auto termination
VESA standards (100mm x 100mm) bracket
2
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
PRODUCT TO RAIN OR MOISTURE.
DO NOT INSERT ANY METALLIC OBJECT THROUGH VENTILATION GRILLS.
Disposal of Old Electrical & Electronic Equipment (Applicable in the
European Union and other European countries with separate collection
systems).
This symbol on the product or on its packaging indicates that this product shall not be treated as household
waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential
negative consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. The recycling of materials will help to conserve natural
resources. For more detailed information about recycling of this product, please contact your local city
office, your household waste disposal service or the shop where you purchased the product.
CAUTION
1. READ AND RETAIN INSTRUCTIONS
All the safety and operating instructions should be read before the unit is operated. The
safety and operating instructions should be retained for future reference. All operating and
usage instructions should be followed.
2. CLEANING
Unplug this unit from the wall outlet before cleaning. Do not use liquid cleaners or aerosol
cleaners. Clean only with a dry cloth.
3. ATTACHMENTS
The manufacturer of this unit does not make any recommendations for attachments, as
they may cause hazards.
4. WATER AND MOISTURE
Do not use this unit near water. For example, near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement, or near a swimming pool.
Please read the Manual before attempting to use this product.
Specifications and appearance are subject to change without notice.
3
5. ACCESSORIES
Do not place this unit on an unstable cart, stand, tripod, bracket, or table. The unit may fall,
causing serious injury, and serious damage to the unit. An appliance and cart combination
should be moved with care. Quick stops, excessive force, and uneven surfaces may cause
the appliance and cart combination to overturn.
6. VENTILATION
Slots and openings at the rear cabinet and bottom are provided for ventilation, these are to
ensure reliable operation of the unit, and to protect it from overheating. These openings
must not be blocked or covered. The openings should never be blocked by placing the unit
on a bed, sofa, rug, or other similar surface. This unit should never be placed near or over
a radiator or heat source. This unit should not be placed in a built-in installation such as a
bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions
have been adhered to.
7. POWER SOURCE
This unit should be operated only from the type of power source indicated on the rating
plate. If you are not sure of the type of power supply to your home, consult your appliance
dealer or local power company.
8. POWER-CORD PROTECTION
Power-supply cords should be routed so that they are not likely to be walked on or pinched
by items placed upon or against them, paying particular attention to cords at plugs,
convenience receptacles, and the point where they exit from the appliance.
9. LIGHTNING
To protect your unit from a lightning storm, or when it is left unattended and unused for long
periods of time, unplug it from the wall outlet and disconnect the antenna or cable system.
This will prevent damage to the unit due to lightning and power line surges.
10. POWER LINES
An outside antenna system should not be located in the vicinity of overhead power lines or
other electric light or power circuits, or where it can fall onto or against such power lines or
circuits. When installing an outside antenna system, extreme care should be taken to keep
from touching such power lines or circuits, as contact with them might be fatal.
11. OVERLOADING
Do not overload wall outlets and extension cords, as this can result in a risk of fire or
electric shock.
12. OBJECT AND LIQUID ENTRY
Do not push objects through any openings in this unit, as they may touch dangerous
voltage points or short out parts that could result in fire or electric shock. Never spill or
spray any type of liquid into the unit.
13. HEAT
The product should be situated away from heat sources such as radiators, heat registers,
stoves, or other products (including amplifiers) that produce heat.
14. CONNECTING
When you connect the product to other equipment, turn off the power and unplug all of the
equipment from the wall outlet. Failure to do so may cause a product damage. Read the
owner's manual of the other equipment carefully and follow the instructions when making
any connections.
15. LCD
Do not press on or jolt the LCD panel. Doing so may cause the LCD panel glass to break
and injury may occur. Should the LCD panel be broken and liquid leaks out, do not inhale
or swallow it. Doing so may cause poisoning. If you have got it into your mouth, wash it out
and consult your doctor. If your hands or clothes have touched it, wipe them with alcohol
and a cleaning cloth and then wash them well.
4
Federal Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
LIMITED WARRANTY
This device complies with Part 15 FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received including interference that may
cause undesired operation
LIMITED ONE (1) YEAR WARRANTY AND EXCLUSIONS
Manufacturer warrants to the original consumer purchaser and not for the benefit of anyone else
that this product at the time of its sale by Manufacturer is free of defects in materials and
workmanship under normal and proper use for one (1) year from the purchase date.
Manufacturer's only obligation is to correct such defects by repair or replacement, at its option, if
within such one (1) year period the product is returned prepaid, with proof of purchase date, and
a description of the problem. This warrant excludes and there is disclaimed liability for labor for
removal of this product or reinstallation. This warranty is void if this product is installed
improperly or in an improper environment, overloaded, misused, opened, abused, or altered in
any manner, or is not used under normal operating conditions or not in accordance with any
labels or instructions. There are no other implied warranties of any kind, including
merchantability and fitness or a particular purpose, but if any implied warranty is required
by the applicable jurisdiction, the duration of any such implied warrant, including merchantability
and fitness of or a particular purpose, is limited to one (1) year. Manufacturer is not liable for
incidental, indirect, special, or consequential damages, including without limitation,
damage to, or loss of use of, any equipment, loss sales or profits or delay or failure to
perform this warranty obligation. The remedies, provided therein are the exclusive remedies
under this warranty, whether based on contract, tort or otherwise.
5
TABLE OF CONTENTS
Features………………………………………………………..………………………….. 1
Warnings & Cautions………………………………………………….…………………. 2-4
Limited Warranty…………..……………………………………………………………… 4
Table of Contents………………………………………………….…………….……….. 5
List of Components…………………………………….…………………………………. 5
Dimensions……………………………………………….………………………….……. 6
Exploring Your New Monitor…………………………………………………………….. 6-7
Rear Connections…….……………………………………………………………….…. 7
Monitor Setup…………………………………………………………………….………. 8
RS485 Remote Controller………………………………………………………….……9-12
Video/HDMI Setting………………………………………………………….…….……. 13
VGA Setting………………………………………………………………………………. 14
Audio Setting………………………………………………………………………………15
PIP Setting…………………………………………………………………………….….. 16
System Setting……………………………………………………………………..……… 17
Information…………………………………………………………………………………. 18
Troubleshooting………………………………………………………………..………….. 19
Applicable Timing………………………………………………………………….……19-20
Specification………………………………………………………….…………………… 21
LIST OF COMPONENTS
A. One (1) LCD Color Monitor
B. One (1) Power Cord
C. One (1) VGA Cable
D. One (1) PC Audio Cable
E. One (1) Adapter
F. One (1) Remote Controller
G. One (1) User Manual
For any returns, please include all components listed above with original packaging in
Resalable Condition. Absolutely No Returns will be accepted if any component is
missing/damaged.
6
DIMENSIONS
EXPLORING YOUR NEW MONITOR
You can operate your monitor by using the buttons on the front panel. The side panels provide
the inputs to connect other equipment to your monitor.
Front Panel
LTV15RS LTV19RS
Light
sensor
IR receiver
LED indicator
LTV15RS
13.38” / 339.9mm
11.22” / 284.9mm
13.56” / 344.5mm
15”
19”
LTV19RS
16.54” / 420mm
14.15” / 359.5mm
15.73” / 399.5mm
7
Rear Side
REAR CONNECTIONS
1. Power in :DC 12V input
2. HDMI: HDMI input(1080p)
3. VGA: VGA input
4. RS485 jack. Camera, P/T/Z dome or DVR connect
DC5V/GND power out.(DC5V/500mA/GND)
5. AUDIO IN: PC audio input
6. AUDIO IN: Audio input. RCA jack.
7. VIDEO IN: BNC input
VIDEO OUT: BNC Video looping output
RS485 A+
RS485 B-
RS485
1
2
3
4
5
6
7
8
MONITOR SETUP
AUTO: Auto-optimize displaying picture under PC mode.
Enter: This “Auto”Button can be either “Enter”function in OSD Menu)
MENU: OSD menu ON / OFF control.(EXIT Item)
ADJUST: Increase or decrease the value on OSD menu.
►Up: Increase value or turn ON / OFF function.
◄Down: Decrease value or turn ON / OFF function
SOURCE: Select input signal from AV1 or VGA (PC).
POWER: Monitor power ON / OFF. At OFF mode, monitor will be at standby mode.
Green Light: ON Mode
Red Light: OFF Mode
Light
sensor
IR receiver
LED indicator
9
RS485 Remote Controller
Before device control, please set the RS485 setup.
Press RS485 set button in to RS485 menu.
Press to change control mode
LCD mode
User operates the function by control remote. See LCD key define
DVR mode
User operates the function by control remote. See DVR key define
PTZ mode
User operates the function by control remote. See Cam key define
Key
Define
LCD power on / off
RS485 menu setup
LCD / DVR / CAM OSD item select up/down/left/right key
DVR playback status
CAMERA ID 1
DVR ID 1
Protocol Pelco D
Baud Rate 9600
Speed Normal
10
LCD / DVR / CAM control mode switch
Call desire LCD / DVR / CAM Device Menu
Displays the LCD source information
LCD volume setup
LCD audio soundless
VGA mode auto adjust
Quit desire DVR OSD setup or number wrong typing
LCD
Direct to select the AV1 source input
N/A
Direct to select the VGA source input
For HDMI
Jump to Picture in picture of screen display
Picture in picture of screen source select
Picture in picture of screen source exchange
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Okina Monitor Handbücher
