OKLAHOMA SOUND CORPORATION
INTRODUCTION
Congratulations! You are now the owner of
the unique Dual Hand-Held Wireless
Microphone System from Oklahoma Sound
Corp.
The two wireless microphones can be used
at the same time, Karaokee-style or for
speaker/audience participation. Just follow
the instructions in this booklet and you are
ready to go.
This state-of-the-art microphone system
should provide trouble free usage for years
to come. If you experience any difficulty with
our product, or have questions, please call
our customer service at (201) 261-4111.
OKLAHOMA SOUND CORP.
149 Entin Road, Clifton, NJ 07014
Tel 973-594-9000 • Fax 973-594-9339
www.oklahomasound.com • e-mail: info@oklahomasound.com
2
Dual Hand-Held Wirless Mic System
7
OKLAHOMA SOUND CORPORATION
6
Dual Hand-Held Wirless Mic System
3
TABLE OF CONTENTS
Introduction ..............................................................2
Package Contents & Specifications ....................4
Product Features......................................................5
Assembly Instructions ..............................................6
Operating Instructions .......................................... 7
Manufacturer’s Warranty ...................................... 8
ASSEMBLY
Before you begin using the unit:
1. Remove microphone housing from MIC A and also from
MIC B.
2. Insert 9 VOLTbattery (not included) into battery cham-
ber of both mic Aand mic B . Make sure to connect the
positive (+) and negative (-) prongs of battery as per
diagram within chamber.
3. Plug one adapter of cable into jack labeled "AUDIO
OUTPUT" — located on rear side of receiver unit and
plug other adapter of cable into your existing sound sys-
tem. Note: If your system does not havea1/4" input, you
must purchase an adapter.
4. Attach included 110V prong to power cord
5. Connect the antenna labeled "A" to upside of receiver
unit on the left side and antenna labeled "B" to the
upside of receiver unit on the right side.
6. Plug power cord into outlet.
OPERATION
A.Turn switch on microphones to the on position. Switch
is located on underside of microphones. Turning on
MIC A should illuminate green lamp on underside of
microphone (next to switch). Turning on MIC B should
illuminate red lamp on underside of unit (next to
switch).
B. When receiver is plugged into outlet power light on
receiver unit should illuminate.
C. When MIC A is in operation lamp labeled A on front
of receiver should illuminate.
D. When MIC B is in operation liamp labeled B on front
of receiver unit should be illuminated.
TROUBLESHOOTING
In event you experience problems with either MIC try
to replace batteries with new fresh batteries. If prob-
lem persists feel free to call our customer service at
201-261-4111.
