Oricom DTX4200 Bedienungsanleitung

Keep this user guide for future reference. Always retain your proof of purchase in case of

Warranty service and register your product on line at:

AUSTRALIA: www.oricom.com.au NEW ZEALAND: www.oricom.co.nz

Operating Instructions

DTX4200 80 Channel UHF Citizen Band Radio

This unit complies with all relevant Australian

and New Zealand approval requirements

AS/NZS 4365:2011

The ACMA increased the number of available UHF CB channels.

To provide additional channel capacity within the UHF CB Band, the ACMA has increased the number of available

channels by changing from wideband to narrowband channels and adding the additional channels to the existing

40 channels. Some of the new channels are locked and cannot be used, see channel chart later in this user guide

for more information.

When did this take place?

Early in 2011, new AS/NZS Standards came into effect allowing operators to use additional narrowband channels and

also use narrowband transmissions on some current wideband channels. This increased the number of channels up

to 80, 75 of which are useable voice channels.

What issues may users experience during the transition phase?

When a new narrowband radio receives a transmission from an older wideband radio, the speech may sound loud

and distorted – simply adjust your radio volume for the best listening performance. When an older wideband radio

receives a signal from a new narrowband radio, the speech may sound quieter – simply adjust your radio volume

for best listening performance. When operating a narrowband radio or Channel 41 - 80 interference is possible from

wideband radios transmitting on high power or on adjacent frequency.

The issues described above are not a fault of the radio but a consequence of mixed use of wideband and narrowband

radios.

It is expected that as older wideband radios are removed from service that this issue will be resolved. Most radios in

use will be narrowband eliminating this issue.

This information is current at time of printing. For further up to date information please visit

www.acma.gov.au

Table of contents

Introduction ..................................................................................4

Important information ...................................................................5

Installation of your Oricom Radio...................................................6

Controls and Indicators .................................................................8

Operations..................................................................................12

UHF CB channels and frequencies ..............................................27

Express Warranty (Australia) .......................................................31

Need Help?

If you need assistance setting up or using your Oricom product now or in

the future, call Oricom Support.

Australia 1300 889 785 or (02) 4574 8888

www.oricom.com.au

Mon-Fri 8am – 6pm AEST

New Zealand 0800 67 42 66

www.oricom.co.nz

Mon-Fri 10am – 8pm NZST

Introduction

Thank you for choosing the Oricom DTX4200 5 watt UHF CB Radio.

Key Features

Dual receive

IP54 dust and splash resistant

12/24 volt operation

3 memory groups of 16 channels per group

96 Multi-colour backlit display

Backlight brightness (5 pre-set levels plus auto)

Fast scanning 80 channels within 3 seconds

Rotary volume/channel and squelch control

Duplex

38 CTCSS & 104 DCS codes

Heavy duty diecast metal chassis

Slide-in mounting bracket

Auto power off (off/1h/2h/4h)

3.5mm external jack (for optional external speaker or PA adaptor)

Optional Accessories

External speaker

PA adaptor jack

PC programming cable and software to allow programming of memory

location

Important information

Please read before installing or operating your

Oricom Radio

The operation of your UHF radio in Australia and New Zealand is subject

to conditions in the following licenses:

In Australia the ACMA Radio communications (Citizen Band Radio

Stations) and in New Zealand by MED the General User Radio License

for Citizen Band Radio.

Safety Information and Warnings

WARNING

Potentially Explosive Atmospheres

Turn your radio OFF when in any area with a potentially

explosive atmosphere. Sparks in such areas could cause an

explosion or re resulting in injury or even death.

NOTE: Areas with potentially explosive atmospheres are often,

but not always clearly marked. They include fuelling areas such

as below deck on boats; fuel or chemical transfer or storage

facilities; areas where the air contains chemicals or particles,

such as grain, dust, or metal powders; and any other area where

you would normally be advised to turn off your vehicle engine.

Blasting Caps and Areas

To avoid possible interference with blasting operations, turn

your radio OFF near electrical blasting caps or in a “blasting

area” or in areas posted: “Turn off two way radios.” Obey all

signs and instructions.

Electromagnetic Interference/Compatibility

Nearly every electronic device is susceptible to electromagnetic

interference (EMI). To avoid the possibility of electromagnetic

interference and/or compatibility conicts, turn off your radio

in any location where posted notices instruct you to do so such

as health care facilities.

Installation of your Oricom Radio

CAUTION

When installing your radio in your vehicle, check that during

installation you do not damage any wiring or vehicle components

that may be hidden around the mounting position. Ensure

the installation does not interfere with the operation of the

vehicle and meets all regulatory and safety requirements for

accessories tted to your vehicle.

For optimum performance your radio needs to be installed

correctly. If you are unsure about how to install your radio, we

suggest you have your radio professionally installed by a UHF

specialist or Auto electrician. When installing the radio, avoid

mounting it close to heaters or air conditioners. Never press

the PTT or CALL button before connecting the antenna to the

radio.

Wiring Methods

There are two possible wiring congurations for connecting to the

vehicles power supply.

A. Radio stays ON when the ignition is switched OFF

Connect the radio’s negative (black) lead to the vehicle chassis, or

directly to the battery’s negative terminal.

Connect the radio’s positive (red) lead via the 2 Amp fuse to the

battery’s positive terminal. Alternatively, the positive lead could be

connected at the fuse box at a point that has DC Power continuously

available (preferably the battery side of the ignition switch) via the 2

Amp fuse.

B. Radio turns OFF with the ignition switch

Connect the radio’s negative (black) lead to the vehicle’s chassis, or

directly to the battery’s negative terminal.

The radio’s positive (red) lead should connect to an accessory point in

the vehicle’s fuse box via the 2 Amp fuse.

Installation of your Oricom Radio

Antenna information

The antenna (not supplied) is of critical importance, to maximize your

output power and receiver sensitivity.

A poorly installed, inferior quality antenna or one not designed for the

correct frequency band will give poor performance. You should only

purchase an antenna designed for the 477MHz frequency band.

Antenna installation

1. Connect the antenna to the rear antenna socket using a PL259 coaxial

connector (not supplied).

2. To obtain maximum performance from the radio, select a high quality

antenna and mount it in a good location. Never press the PTT or

CALL button before connecting the antenna to the radio.

3. For best performance always mount your antenna as high as possible

and away from all other antennas or poles.

Optional External Speaker

Depending on the installation it may be necessary to use an external

speaker (not supplied) to give improved volume and clarity. This can be

plugged into the EXT –SPK socket on the rear of the unit.

Controls and Indicators

Front View

SCAN

SWP

SRX

GTS

1. Power on/off and Volume/channel/squelch selector and SVL

(sub receiver volume)

2. Scan (open scan/memory group scan)/remove memory

3. Memory recall/memory write

4. Main & Sub channel swapping/SRX on/off

5. Menu/Group tone scan

6. Microphone

7. LCD display

Controls and Indicators

Rear View

3 4

1. 3.5mm external jack for optional 8 ohm speaker and PA speaker

2. Power supply connection

3. Computer programming connector

4. Antenna Connection

Controls and Indicators

LCD Icons & Indicators

245

10 9

1. Sub receiver busy 6. Group display (A, B, C groups)

2. Sub receiver on 7. Group address channel

3. Main receiver busy 8. Status display

4. Duplex on 9. CTCSS or DCS on

5. Signal strength & TX power 10. Channel display

TO MOUNT: SLIDE

INTO UNIVERSAL

MOUNTING BRACKET

TO REMOVE:

SLIDE OUT HOLDING

BRACKETS AWAY FROM

UHF RADIO

Installation of the DTX4200 and tting optional accessories

Mounting the UHF radio

The universal mounting bracket supplied with your UHF radio allows

overhead/dash mounting.

Mount the UHF radio via the bracket, securely with the supplied screws in

the desired location, ensuring the surface is sturdy and can support the

weight of the radio.

Inhaltsverzeichnis

Andere Oricom Radio Handbücher

Oricom

Oricom PMR1310 Bedienungsanleitung

Oricom

Oricom UHF2500 Bedienungsanleitung

Oricom

Oricom UHF305 Bedienungsanleitung

Oricom

Oricom UHF350DR Bedienungsanleitung

Oricom

Oricom UHF088 Bedienungsanleitung

Oricom

Oricom UHF350DR Bedienungsanleitung

Oricom

Oricom UHF380M Bedienungsanleitung

Oricom

Oricom UHF050 Bedienungsanleitung

Oricom

Oricom DTX4000 Bedienungsanleitung

Oricom

Oricom DTX4200XDV Bedienungsanleitung

Oricom

Oricom UHF360 Bedienungsanleitung

Oricom

Oricom UHF300 Bedienungsanleitung

Oricom

Oricom UHF400R Bedienungsanleitung

Oricom

Oricom UHF390 Bedienungsanleitung

Oricom

Oricom PMR3000 Bedienungsanleitung

Oricom

Oricom UHF058 Bedienungsanleitung

Oricom

Oricom UHF098 Bedienungsanleitung

Oricom

Oricom UHF180F Bedienungsanleitung

Oricom

Oricom UHF400R Bedienungsanleitung

Oricom

Oricom PMR795 Bedienungsanleitung

Oricom

Oricom UHF300 Bedienungsanleitung

Oricom

Oricom DTX4200X Bedienungsanleitung

Oricom

Oricom DTX4200X Bedienungsanleitung

Oricom

Oricom PMR1300 Bedienungsanleitung

Beliebte Radio Handbücher anderer Marken

EisSound

EisSound KBSound iSelect Bedienungsanleitung

Midland

Midland 1001LWX Bedienungsanleitung

Konig

Konig HAV-SR41 Bedienungsanleitung

Roberts

Roberts exprssion Bedienungsanleitung

VDigi

VDigi DD3.0 Bedienungsanleitung

Radio Shack

Radio Shack 21-1863 Bedienungsanleitung

Roberts

Roberts Stream 207 Bedienungsanleitung

Sony

Sony Walkman SRF-M97 Bedienungsanleitung

Stanley

Stanley FatMax FMC770 Bedienungsanleitung

auna

auna DAB-Radio 10026947 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER UR190 Bedienungsanleitung

HYT

HYT TC-320 Bedienungsanleitung

B-Tech

B-Tech GMRS-V2 Bedienungsanleitung

Weierwei

Weierwei VEV-V8 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER DAB750 Bedienungsanleitung

Telefunken

Telefunken TF-1505 Bedienungsanleitung

Makita

Makita LXRM03 Bedienungsanleitung

PRESIDENT

PRESIDENT TEDDY R. Bedienungsanleitung