FEATURES AND SPECIFICATIONS
1. LEVEL CONTROL
2. PHASE SWITCH
3.VARIABLE HIGH-PASS FREQUENCY CONTROL
4.HIGH OUTPUT LEVEL CONTROL
5.VARIABLE LOW-PASS FREQUENCY CONTROL
6.BAND PASS/HIGH PASS SELECTOR
7.VARIABLE HIGH-PASS FREQUENCY CONTROL
8.MID OUTPUT LEVEL CONTROL
9.VARIABLE LOW-PASS FREQUENCY CONTROL
10. PHASE CONTROL
11.SUB/REAR OUTPUT LEVEL CONTROL
12.SUBSONIC FILTER
13.BASS BOOST CONTROL
14.FLAT OUTPUT LEVEL CONTROL
15.SUB/REAR/FRONT INPUT SWITCH
16.STEREO/MONO INPUT SWITCH
17.SUB/REAR INPUT PORT
18.FLAT OUTPUT PORT
19.SUB/REAR OUTPUT PORT
20.MID OUTPUT PORT
21.HIGH OUTPUT PORT
22.FRONT INPUT PORT
23.REMOTE CONTROL JACK
24.POWER TERMINALS
This control sets the sub/rear gain control.
Shift allows 0 degree to 180 degrees.
By turning the selector you can choose the high-pass crossover points from 1.2KHz-14KHz.
For adjusting the high output level.
By turning the selector you can choose the low-pass crossover points from 2KHz-8KHz.
When this switch is in high pass mode, the low pass filter cannot be used. it can convert rear
channel to band pass in tri amp system.
By turning the selector you can choose the high-pass crossover points from 90Hz-1.1KHz.
For adjusting the mid output level.
By turning the selector you can choose the low-pass crossover points from 50Hz-500Hz.
Shift allows 0 degree to 180 degrees.
For adjusting the sub/rear output level.
Use this control to filter out low frequency noise and rumble.
This control adjusts the bass boost gain(0 to12dB)
For adjusting the flat output level.
For selection of independent input or input from front RCA
For selection of stereo or mono mode front inputs.
To be connected to the sub/rear outputs of the source unit.
To be connected to the amplifier left/right inputs.
To be connected to the sub channel amplifier left/right inputs.
To be connected to the rear channel amplifier left/right inputs.
To be connected to the front channel amplifier left/right inputs.
To be connected to the front outputs of the source unit.
Plug the modular telephone style cord connected to the remote control unit into this jack
Use these connectors to deliver power, ground, and remote turn-on control to the unit
0dB-12dB
1.2KHz-14KHz
90Hz-1.1KHz
2KHz-8KHz
50Hz-500Hz
20Hz-40Hz
-High Pass
-Mid High Pass
-Mid Low Pass
-Sub/rear(Low Pass)
-Subsonic Filter
more than 90dB
11V
5.9˝x12.7˝x1.8˝
150 x 322 x 45.5
This control sets the sub/rear level control.
