1
ORTAL Heating Solutions Ltd.
INSTALLATION & OPERATION MANUAL
Instruction for Burner 30 Models:
Clear 40, Clear 40 RS/LS/TS, Clear 40 H
Clear 40 Tunnel, Stand Alone 40 TS
The Ortal direct vent appliances have been tested and approved by CSA for safety and
efficiency for use with either Natural Gas (NG) or Propane (LP).
1
ORTAL Heating Solutions Ltd.
INSTALLATION & OPERATION MANUAL
Instruction for Burner 30 Models:
Clear 40, Clear 40 RS/LS/TS, Clear 40 H
Clear 40 Tunnel, Stand Alone 40 TS
The Ortal direct vent appliances have been tested and approved by CSA for safety and
efficiency for use with either Natural Gas (NG) or Propane (LP).
4
WARNINGS
WARNING:
The direct vent system appliance must be installed as an OEM installation in
manufactured homes (USA only) or an aftermarket permanently located, or a mobile
home, where not prohibited by local codes and must be installed in accordance with
Manufacturer's instructions and the Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280, in the United States, or the Standard for Installation
in Mobile Homes, CAN/CSA Z240 MH Series, in Canada.
If the information in these instructions is not followed exactly a fire or explosion may
result causing property damage, personal injury or death.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
appliance.
SAVE THESE INSTRUCTIONS
Make yourself fully aware of all the following instructions and the many features of the
Ortal direct vent gas fireplace appliance.
INSTALLER: Leave this manual with the appliance.
OWNER: Keep this manual for future reference.
WARNING: Glass Handling
The glass must ONLY be removed by an authorized &/or qualified installer. The
authorized technician should ONLY remove the glass with the glass vacuum holders
supplied by the manufacturer. Lower the glass to rest in the special
wooden/polyurethane support provided, and fit the second support to the upper edge of
the glass. This is to prevent damage to the glass edges.
Step 1. Place the support on the floor below the glass to be removed.
Step 2. Remove the glass using the vacuum holder, and immediately place it in the
support.
Step 3. Place the second support on the upper edge of the glass. The glass can
now be rested safely.
WARNING: Electrical Grounding
These Direct Vent appliances must be electrically grounded in accordance with the
local codes or, in the absence of local codes, with National Electric code, ANSI/NFPA
70, or the Canadian Electric Code, CSA C22.1.
WARNING: Gas Appliance
This appliance is only for use with the type of gas indicated on the rating plate. These
appliances are not convertible for use with other gases, unless a certified kit is used
and the conversion is performed by an authorized qualified technician.
Applicable standards are Vented Gas fireplace heaters ANSI Z21.88 / CSA 2.33a and
gas-fired appliances for use at high altitudes CAN/CGA 2.17-M91.
WARNING: Installation and Service
Installation and service must be performed by an authorized qualified installer service
agency or gas supplier.
Any alteration to the product that causes soot or carbon to form and results in damage
is not the responsibility of the manufacturer.
In the case of models supplied with a door fitted in the frame of the heater, ONLY an
authorized qualified installer may open this door. The end user must NOT open the
door, as this may be unsafe and may result in voiding the manufacturer’s warranty.
5
