OSIM uJolly 2 Smart Bedienungsanleitung
uAlpine Smart 2
OS-6211 Operation Manual
Designed & Developed in Singapore by OSIM International Pte. Ltd. (A Subsidiary of V3 Group)
© 2022 All rights reserved. www.OSIM.com
Rev E
uAlpine Smart 2
1) English
2) Simplified Chinese 简体中文
3) Traditional Chinese 繁體中文
1
Contents
OS-6211 uAlpine Smart 2
Thank you for purchasing the OSIM uAlpine Smart 2. Please read the operation
manual thoroughly for the correct methods of usage and take special notice of the
safety section before you start.
This manual should be kept on hand for easy reference. It is your guide to a safe and
efficient operation.
Safety 2
Names of parts and functions 5
Preparation before use 8
Operation 9
Pairing smart devices with OSIM uAlpine Smart 2 11
Product care and storage 13
Troubleshooting 14
Specifications 16
ENGLISH
2
IMPORTANT SAFETY INSTRUCTIONS
When using the product, please take special notice of the following basic precautions:
Read all instructions before using the product.
DANGER – To reduce the risk of electric shock:
Always unplug this product from the electrical outlet immediately after use and before cleaning.
WARNING – To reduce the risk of fire, burns, electric shock, or injury to persons:
1) Use this product only for its intended use as described in this manual. Do not use attachments not
recommended by the manufacturer.
2) The product should never be left unattended when plugged in. Unplug from electrical outlet /power
source when the product is not in use, and before putting on or taking off parts.
3) Do not operate the product under a blanket or pillow. Excessive heating may occur and cause fire,
burns, electric shock, or injury to persons.
4) Do not use the product if the electrical outlet /power source is loose.
5) Do not connect or disconnect the power plug /USB cable from the electrical outlet /power source
with wet hands.
6) When disconnecting the power plug /USB cable, remove it by holding the plug /USB cable head, and
not by the cord /cable.
7) Do not operate the product if it has a damaged cord or plug /USB cable, a malfunction, a power
failure, or it is dropped into the water. Injury may occur when power is restored unexpectedly. Return
the product to OSIM Service Centre for examination and repair.
8) If the power plug /USB cable or power cord is damaged, it must be replaced by OSIM Service Centre
or its authorized service agents.
9) Do not carry this product by the power cord /USB cable or use the power cord /USB cable as a handle.
10) Keep the product power cord /USB cable away from heated surfaces.
11) Do not place the power cord /USB cable under the product or any other heavy objects.
12) Do not wind the power cord /USB cable around the product.
13) Do not operate the product with the air openings blocked. Keep the air openings free of lint, hair, and
the like.
14) Remove power plug /USB cable from the electrical outlet /power source immediately should liquid be
spilled onto the product as this may result in electric shock.
15) Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
16) To stop using the product, turn off all controls and remove the power plug /USB cable from the
electrical outlet /power source.
3
17) Do not drop or insert any object or flammable material into any openings of the product.
This may result in electric shock, malfunction or risk of fire.
18) Children should be supervised to ensure that they do not play with the product.
19) This product can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Keep children away when the product is in
operation.
20) Cleaning and user maintenance of the product shall not be made by children.
21) Do not use or operate the product when your body or hands are wet.
22) Do not use this product outdoors.
23) Do not use the product in an excessively humid or dusty environment as it may result in
malfunction.
24) Do not use the product in temperatures higher than 40˚C.
25) Do not expose the product to heaters, stoves or direct sunlight.
26) Do not cover the product during operation. This may result in a rise in motor temperature and
subsequent malfunction or fire.
27) Do not use the product in the event of a lightning storm.
28) If you should use the product in a cold room, do not increase the room temperature abruptly. It
is recommended that you increase the temperature gradually to a normal level.
29) If the product is brought into a warm environment from a cold place where it was stored, wait
for an hour before use as there may be water droplets on mechanical parts due to condensation.
Using the product under such condition may result in malfunction.
30) Do not dismantle, drop, or subject the product to shock or vibration.
31) Do not rest or place heavy objects on the product as this may result in malfunction.
32) The product must only be serviced or repaired by the OSIM Service Centre. Do not attempt to
disassemble or repair the product.
33) Some noise may be heard from the product while in use. This is due to the structure of the
product and is normal.
34) This product is not intended for self-diagnosis or self-treatment of conditions that should be
managed by a qualified health care provider.
35) If you are under any medication or have any medical conditions, please consult your health care
provider first before use.
36) Type certified qualified low-power RF motor, without permission, companies, companies or users
may not change the frequency, increase power or change the original design characteristics and
functions.
4
37) The use of low-power RF motors shall not affect the safety of flight and interfere with
legitimate communications, and should be deactivated immediately if interference is detected
and improved to the point where there is no interference. The legal communication in the
preceding item refers to radio communications operating in accordance with the provisions
of the Telecommunications Law. Low-power RF motors are subject to interference with legal
communications or industrial, scientific and medical radiometry motor equipment.
SAVE THESE INSTRUCTIONS
This product is intended for household use only.
Warranty is subjected to cancellation if the product is used for commercial purposes.
5
uAlpine
Smart
2
1. Air outlet
2. Control panel
3. LED screen
4. Air inlet
5. Rear cover
6. Power plug*
7. uAlpine Smart 2 Filter
8. Pull tab
Main unit
Names of parts and functions
*Power plug will vary according to country
4
1
5
*Product images are for illustrative purposes only and are not drawn to scale.
2
3
4
8
6
7
6
5. Auto mode
6. [ ] + [ ] Filter reset button
7. [ ] + [ ] Ionizer On/Off button
8. [ ] + [ ] Child lock On/Off button
9. [ ] + [ ] Wi-Fi button
Control panel
Names of parts and functions
1. UV On/Off button
2. Timer selection button
(1/2/4/8 hrs and off)
3. On/Off button
4. Fan speed selection button
(Sleep mode, I, II, III)
6
12 3 54
7 8 9
7
Names of parts and functions
LED screen
1. Air quality light indicator
(Green, Yellow, Red)
2. PM2.5/VOC value display
3. Child lock indicator
4. Ionizer indicator
5. UV indicator
6. Wi-Fi indicator
7. Filter replacement indicator
1
23 4 65 7
8
Preparation before use
Placing the uAlpine Smart 2
• Make sure there is an allowance of at least
30 cm from the wall when in use.
• Ensure that the power cord is not placed
under the uAlpine Smart 2.
Removing plastic cover from
filter before use
Moving the uAlpine Smart 2
• Make sure rear cover is closed properly
before switching on the product.
• Only reset the filter usage time after
replacing the filter.
Note
• Open up the rear cover.
• Pull out the filter.
• Remove the outer plastic cover from filter.
• Place the filter with the pull tab facing
outwards in order to pull the filter out
easily for replacement.
• Close the rear cover.
• Lift the uAlpine Smart 2 by holding both side
of the product as shown.
• Do not lift the product by the rear cover as it
may open up causing product to drop.
• When moving product, always lift it up and
avoid dragging it.
• Do not drop or put anything into the top
air outlet as it could cause product to
malfunction.
30 cm Replacement of filter
• The red filter replacement icon indicator
[ ] will be turned on with 1 long ‘beep’
sound when the filter needs to be
changed.
• After replacing the filter, press and hold
[ ] + [ ] buttons 5 secs. There will be 1
‘beep’ sound to indicate filter usage time
has been reset. The red filter replacement
icon indicator will then be turned off.
u
A
l
p
i
n
e
S
m
a
r
t
2
uAlpine
Smart
2
Andere Handbücher für uJolly 2 Smart
1
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Sprachen:
Andere OSIM Luftreiniger Handbücher
