Osram Sylvania SB378W Bedienungsanleitung

37" Bluetooth Soundbar with Wireless Subwoofer
MODEL: SB378W
Please read this instruction manual carefully and keep it for future reference.
SYLVANIA is a registered trademark of OSRAM Sylvania Inc. used under license.

2
DANGEROUS VOLTAGE: The lighting flash with arrowhead symbol within an
equilateral triangle is intended to alert the user to the presence of uninsulated
“dangerous voltage” within the product’s enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
ATTENTION: The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
FCC STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may
cause undesired operation. The antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 8 ft. from all persons and must not be co-located
or operated in conjunction with any other antenna or transmitter.
FCC NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
CAUTION: TO REDUCE THE ELECTRIC SHOCK, DO NOT REMOVE THE
COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE.REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
IMPORTANT SAFETY INSTRUCTIONS

-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To assure continued operation, follow the attached installation instructions and use only
shielded cables when connecting to other devices. Changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
WARNING:TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT
TO RAIN OR MOISTURE.
WARNING: USE UNDER SUPERVISION OF AN ADULT DUE TO LONG CORD.This
unit has a long cord that can be easily tripped on or pulled on, causing injury. Please make
sure it is arranged so that it will not drape over a tabletop, etc., where it can be pulled on
by children or tripped over accidentally.
Before using the unit, be sure to read all operating instructions carefully. Please note that
these are general precautions and may not pertain to your unit. For example, this unit may
not have the capability to be connected to an outdoor antenna.
1. Read these instructions – All the safety and operating instructions should be read
before the appliance is operated.
2. Keep these instructions – The safety and operating instructions should be kept for
future reference.
3. Heed all warnings – All warnings on the appliance and in the operating instructions
should be adhered to.
4. Follow all instructions – All operation and use instructions should be followed.
5. Do not use this apparatus near water – The appliance should not be used near water;
for example, near a bath tub, washbowl, kitchen sink, laundry tub, in a wet basement,
or near a swimming pool.
6. Clean only with dry cloth – The appliance should be cleaned only as recommended
by the manufacturer.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions. The appliance should be situated so that its location or position does not
interfere with its proper ventilation. For example, the appliance should not be
situated on a bed, sofa, rug, or similar surface that may block the ventilation
openings; or placed in a built-in installation, such as a bookcase or cabinet that may
impede the flow of air through the ventilation openings.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. Apolarized
plug has two blades and a third grounding prong. The wide or the third prong are
-- Reorient or relocate the receiving antenna.
3
IMPORTANT SAFETY INSTRUCTIONS

provided for your safety. If the provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments / accessories specified by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination to avoid injury
from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of
time.
14. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
15. This appliance should not be exposed to dripping or splashing water and no object
filled with liquids such as vases should be placed on the apparatus.
16. Power Sources – The appliance should be connected to a power supply only of the
type described in the operating instructions or as marked on the appliance. Do not
overload wall outlet.
17. Battery should not be exposed to excessive heat such as sunshine, fire, etc.
18. Replace remote control battery only with the same or equivalent type.
19. Do not attempt to dismantle, open or repair this product yourself. If a problem occurs,
seek advice from your local qualified service technician or contact the distributor at
the telephone number at the back of this instruction manual.
20. Caution marking and nameplate are located on back or bottom of product.
4
CANICES-3(*)/NMB-3(*)
Industry Canada Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device
2.Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Avis d’lndustrie Canada
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux
RSS (RSS)d'Innovation, Sciences et Développement économique Canada. Le
fonctionnement est soumis aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de
provoquer un fonctionnement indésirable de l'appareil.
2.Cet appareil numérique ne dépasse pas les Rélements sur I'interférence radio par un
appareil numérique de classe B stipulées dans les Réglement sur I'lnterférence redio
d'industrie Canada.

1. Placing the device on table - Ventilation
When placing the Sound Bar and Subwoofer on an entertainment center, bookshelf, or any
type of enclosed space, be sure to allow at least 2-3 inches of space around the Sound
Bar for ventilation. If the Sound Bar is enclosed in a tight space, without ventilation, heat
generated from the Sound Bar could produce a potential heat hazard.
5
2-3 inches
2-3 inches
2. The Installation Distance
634mm (24.9 inches)
PLACEMENT AND MOUNTING
2-3 inches
2-3 inches

Mounting to a wall
2.1 Mountingto a wooden wall
2.2 Mountingto a brick wall
24.9 inches
24.9 inches
6
sound bar.
A. Mark the position of the mounting screws on the wall using a pencil(not supplied).
B. Drill the screws direc tly into the marks that you made on the wall and
leave approx. 0.3 inch length to hook the sound bar.
C. Put the sound bar onto the mounting screws. Make sure they are firm and stable.
A. Mark the position of the mounting screws on the wall using a pencil(not supplied).
B. Drill 2 holes on mounting positions with powerful electric drill(not supplied).
C. Insert the fixing plugs and hammer into the holes.
xing x. 0.3 inch length to hook the plugs and leave appro
E. Put the sound bar onto the mounting screws. Make sure they are firm and stable.
D. Secure the screws into the fi
(screws not supplied)
(screws and fixing plugs not supplied)

Front View
Top View
1.
Indicator
2.
Remote sensor
3. Speaker 3. Speaker
4. USB Port 8. DC IN jack
9. Standby/Source button
10. 11. Volume down button
12. Volume up/REC. button
7
PRODUCT OVERVIEW
SB Pair button
(subwoofer pairing button)
Rear View
AUX IN
LINE IN
L R
OPTICAL
DC 16V,1.5A
USB
6. AUX IN Jack
7. LINE IN Jacks
5. OPTICAL Jack
Vol+/REC.Vol-
SB Pair
Standby
/Source

1. Speaker
PRODUCT OVERVIEW
INDICATOR
POWER
INDICATOR
STANDBY
DC 1
2. DC IN Jack
3. STANDBY Button
4. POWER INDICATOR
5. Pairing Indicator
8
6V
Side View of Subwoofer
Rear View of Subwoofer

Fig.1
Fig.2 Fig.3
Remove and discard the insulation film as Fig.1.
1
2
3
4
5
7
8
9
10
11
12
1. (Power On/Off) Button
2. AUX Button
3. LINE IN Button
4. (Previous) Button
7. (Mute) Button
11. (Next) Button
12. Play/Pause Button
13. (Volume Up/Down) Button
10. (Mode Switch) Button
OP EN
OPE N
3V CR 2025
3V C R202 5
with the polarity markings facing upward as Fig.3.
Fig.4
13
8. BT Button (Bluetooth mode)
9. OPTICAL Button
5. Sound Mode (MUSIC,
TALK, MOVIE, STANDARD)
REMOTE CONTROL
BATTERY INSTALLATION OF REMOTE CONTROL
BATTERY REPLACING:
USING AT FIRST TIME:
Pull out the battery holder as Fig.2.
Replace the old button cell with a new CR2025 button cell
Push back the battery holder as Fig.4.
9
6. REC. (USB Recording) Button
6

9
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the battery
compartment, a reserved battery may cause damage to the device.
3. Do not mix different types of batteries together ( e.g: Alkaline and Carbon-zinc )
or old batteries with fresh ones.
4. If the batteries in the device are consumed or the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from possible leakage.
5. Do not try to recharge the battery as it is not intended to be recharged; it can overheat and rupture.
(Follow the battery manufacturer’s instructions.)
6. The batteries shall not be exposed to excessive heat such as sunshine or fire.
7. Clean the battery contacts and also those of the device prior to battery installation.
8. The remote control is supplied with a coin/button
cell battery. If the coin button cell battery is
swallowed, it can cause severe internal burns in
just 2 hours and can lead to death. Keep new
and used battery away from children. If the
Battery compartment does not close securely,
stop using the product and keep it away from
children. If you think batteries might have been
swallowed or placed any part of the body, seek
immediate medical attention.
CR2025
CAUTION
16 Feet (5M)
BETTERY PRECAUTIONS:
OPERATION RANGE:
10
Replace only with the same or equivalent type.
When there is an obstacle between the transmitter and the unit, the unit may not operate.
When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light
shines on the REMOTE SENSOR of the unit, the operation of the remote may be unstable.
Danger of explosion if the battery is incorrectly replaced.
Inhaltsverzeichnis
Sprachen:
Beliebte Lautsprechersystem Handbücher anderer Marken

Sondpex
Sondpex Active Speaker System and Digital Music... Bedienungsanleitung

JVC
JVC NX-PN7 Bedienungsanleitung

Marshall Amplification
Marshall Amplification AR-DM61-BT Bedienungsanleitung

Yamaha
Yamaha NX-A01 - Speaker Sys Bedienungsanleitung

SE Audiotechnik
SE Audiotechnik I-LINE Bedienungsanleitung

Gemini
Gemini WRX-843 Series Bedienungsanleitung











