OZtrail DTC-BU6-B Bedienungsanleitung

Owners Manual

Classic Bungalow 6 Dome

www.oztrail.com.au

DTC-BU6-B

PLEASE READ BEFORE SETTING UP YOUR TENT/SHELTER

At the me of purchase we guarantee that this product is supplied without fault in

construcon, materials or funcon. We recommend that you assemble it as a trial before

going away. If problems are discovered in the brand new product, they will be dealt with

under our warranty.

• This product is designed as a portable and temporary structure; it is not designed to be a

permanent structure or dwelling.

• Intermient use only. Although our polyester fabrics are treated for extra UV resistance,

connuous exposure to sun light will break the fabric down. Fading of colour is an

early warning sign. These tents/shelters are not designed as permanent dwellings or

structures.

• Do not leave this product unaended if bad weather is expected. If assembly instrucons

are followed correctly, this product will withstand mild winds and rain. In gusty winds and

storms you must collapse the tent/shelter.

• We recommend that you discuss adding this investment to your household Insurance

Policy with your Insurance Agent.

CAMP SAFE - SAFETY HABITS

The fabric may burn if le in connuous contact with a ame from any source. Also, the

applicaon of any foreign substance to the tent fabric may render the ame resistant

properes ineecve.

To prevent injury caused by gas poisoning or suocaon -

•Do not use fuel burning, oxygen consuming devices inside the tent. This includes candles,

gas lanterns, kerosene lamps, stoves, cooking and heang appliances

•Do not use gas appliances of any kind inside the tent/shelter

IMPORTANT SAFETY AND CARE INFORMATION

EXTREME CAUTION - Gas or fumes or lack of oxygen within the

tent/shelter could result in unconsciousness, brain damage and

even death

• Do not leave your

tent/shelter erected

in strong winds -

collapse the tent

onto the ground and

seek refuge in your

vehicle

• Do not pitch the tent/shelter near a camp re or any other ame source

• Do not use candles, matches or any other ame source in or near the tent

(this includes stoves, cooking equipment, lighng and heang appliances)

• Only use recommended water repellent compounds on the tent/shelter

y

• Do not spray tent fabrics with inseccides

To prevent injury caused by electricity -

• Always exercise care when using electricity and electric lighng in and

near tents/shelters. Only use 12 volt lighng.

• Do not pitch your

tent/shelter near

clis in case of

collapse or rock fall

• Do not pitch your

tent/shelter on an

area that could get

ooded

• Do not pitch your

tent/shelter under

trees with dead

branches or under

trees known to drop

branches

To prevent injury caused by re -

To prevent injury caused by your camping environment -

Product Code ~ DTC-BU6-B

PLEASE NOTE - Due to our policy of connual product development, specicaons

and features of the product may vary from details within this Owners Manual.

Thank you for purchasing a superior OZtrail product.

Please keep this Owners Manual in a safe and dry place, it

contains important and helpful informaon.

IMPORTANT

We recommend that you set up this product before you leave for your

trip. Check that all parts are present and that you familiarise yourself

with the assembly and disassembly of the product. If you have any

problems, your OZtrail dealer will be able to sort it out for you.

You should have the following parts: -

Product Code - DTC-BU6-B

Part Description

2 x Main Dome Pole

2 x Porco Pole Sets

2 x Halo Awning Poles

1 x Pole Bag

8 x Guy Ropes

28 x Pegs

1 x Peg Bag

1 x Tent Inner

1 x Fly Cover

PRODUCT AND PARTSPRODUCT AND PARTS

Part Description Cont.

1 x Gear Lo

1 x Cup Holder

2 x Awning Poles

ASSEMBLY INSTRUCTIONS

Step 1

Select a sheltered camp site protected from the wind that will not allow water to pond under the tent oor.

Clear a level area of all stones, twigs, etc.

Step 2

Lay out the tent inner and posion it so the doors face the desired direcon. There are 8 peg down points. Start

with the front 4 rst, peg them down through the Ring of the Ring & Pin ng pulling the oor rmly as you

work from on end to the other. Then peg out the back 4 also pulling rmly against the adjacent front peg and

the peg beside it as you work down the tent. You will get a chance to check out that the oor is pegged out

square and plumb aer you install the poles. See Figure 1

Step 3 Assembling the poles

2 x Dome poles (Yellow p bre glass)

2 x Porco Pole Sets

(1 set consists of 2 x anodised steel poles and 2 x breglass (Green p roof poles)

2 x Halo Awning Poles

2 x Steel Awning Poles (they have the spigot points)

Do not stand or sit on the poles or drive over them!

Step 4 Standing up the tent

a) The Central Dome

Open the doors of the tent to prevent sucon when raising the tent. Feed the yellow p poles through the

sleeves that run diagonally over the roof of the dome. Insert the Pin of the Ring & Pin ng into one end of

the poles. Go to the other side of the tent and insert the Pin into the other end of the poles. They should

bow upward liing the tent with them. Hook the J-Hooks onto the poles. If the ferrule edge gets caught on the

sleeve do not force the pole through, take care and unhook the ferrule.

Always allow the poles to bow into their natural curve.

IMPORTANT

1. Aer unpacking the tent, use the check list on page 4 to make sure you have all

the parts.

2. You need to condion your Canvas tent/shelter before use.

See page 12 - CONDITIONING YOUR NEW CANVAS TENT/SHELTER

ASSEMBLY INSTRUCTIONS

b) The End Rooms

Fing the porco poles – Select the Green p breglass roof pole and slide through the sleeve running

over the end room, and then slot each end of the pole into the plasc elbow located at the end of each pole

sleeve. Once the breglass pole is inserted correctly select one of the anodised steel poles and place one

end into the plasc elbow, then place the other end onto the Pin of the Ring and Pin located along the side of

the tent See Figure 2. Repeat this step for the other steel poles and aach all the J hooks.

Step 5 Attaching the Fly and Halo awning poles

Lie the y over the tent. Select one of the Halo poles then unzip the front awning and locate the Halo

awning pole sleeve, begin by sliding the pole through the sleeve, once the pole it through the sleeve place

the end of the pole into the eyelet located about half way up the side of the inner tent. See Figure 2. Once

complete repeat this step for the rear of the tent. You will nd the PosiBrace aachments on the inside of

the guy line points on the y. Wrap the Touch Tape around the poles and fasten. This secures the y to the

pole structure. Hook the J-Hooks located on each aachment point around the boom perimeter of the y

to the Rings of the Ring & Pin ngs. See Figure 3

Step 6

If required, 2 awning poles are provided for the awning at the rear of the tent. Insert the spigot (the point)

into the eyelets located on the corners of the awning. Slip the guy lines over the spigots and peg out at 45

degrees to the alignment of the awning. During rain, do not leave the awning up.

FIGURES AND ILLUSTRATIONS

Figure 2

Figure 1

Porco Elbow

Tie Point

J Hook

Ring & Pin

Eyelets for Halo

Pole

Peg Points

FIGURES AND ILLUSTRATIONS

Figure 3

Halo Sleeve Inside

DISASSEMBLY INSTRUCTIONS

Do not remove pegs from the ground by pulling on peg loops.

This may cause the peg loops to tear out of the seam.

Step 1

Release guy ropes. Release velcro that aaches the y to the poles. Remove roof vent pole. Remove y from tent.

Lay y at on ground and fold the y in half, third or quarters. (folding depends on the length of the pole carry

bag.)

Step 2

Unzip doors and windows, collapse the tent by removing and disassembling the poles. Place the poles in the pole

carry bag and e shut.

Step 3

Remove pegs. Do not remove pegs from the ground by pulling on peg loops. This may cause the peg loops to tear

out of the seam.

Step 4

Spread the tent out at with all loose fabric within the edges of the tent base. Try to aen the tent as much as

possible.

Step 5

Fold the tent in half, third or quarters. (folding depends on the length of the tent pole secons.) Place the folded y

in tent as you make the last fold.

Step 6

Place the pole bag on back end of tent (trapped air is more easily forced out of the open door when you are rolling

up the tent.) The folded tent should be the width of the pole bag.

Step 7

Beginning at the back end, roll your tent ghtly around the pole bag, forcing out excess air as you roll. Keep tent

edges straight and pole bag centred as you roll.

Step 8

When tent is rolled up, e straps around it and place into tent carry bag with peg bag, instrucon sheet, and other

miscellaneous parts. If tent won’t t into bag, unroll and reroll more ghtly.

Important

Do not store your tent away wet, damp or dirty. If you have no choice but to return

home from your camping trip with a wet, damp or dirty tent, make sure you

lay it out to air in a cool, dry and shaded place and only pack it away when it is

completely dry and clean.

Inhaltsverzeichnis

Andere OZtrail Zelt Handbücher

OZtrail

OZtrail BlockOut 10000718 Bedienungsanleitung

OZtrail

OZtrail FAST FRAME Bedienungsanleitung

OZtrail

OZtrail Camper Trailer CCT-06-D Bedienungsanleitung

OZtrail

OZtrail palm club BEACH TENT Bedienungsanleitung

OZtrail

OZtrail DTS-HIG-B Bedienungsanleitung

OZtrail

OZtrail MP-SDF Bedienungsanleitung

OZtrail

OZtrail PEAK TWIN DOME Bedienungsanleitung

OZtrail

OZtrail Sportiva Lodge Family Bedienungsanleitung

OZtrail

OZtrail CAMPER TRAILER 6 Bedienungsanleitung

OZtrail

OZtrail palm club BEACH CABANA Bedienungsanleitung

OZtrail

OZtrail FAST FRAME BLOCKOUT Bedienungsanleitung

OZtrail

OZtrail FAST FRAME Bedienungsanleitung

OZtrail

OZtrail CTC-1008-D Bedienungsanleitung

OZtrail

OZtrail Villa Dome Bedienungsanleitung

OZtrail

OZtrail LUMOS Bedienungsanleitung

OZtrail

OZtrail Backpacker 2 Bedienungsanleitung

OZtrail

OZtrail CTC-1215-D Bedienungsanleitung

OZtrail

OZtrail Switch Back 2 Camo Bedienungsanleitung

OZtrail

OZtrail Blitz 3 Pop Up Bedienungsanleitung

OZtrail

OZtrail CTC-1209-D Bedienungsanleitung

OZtrail

OZtrail CT-1008 Bedienungsanleitung

OZtrail

OZtrail DTO6VP Bedienungsanleitung

OZtrail

OZtrail SEAVIEW 9+3 Bedienungsanleitung

OZtrail

OZtrail FAST FRAME LUMOS Bedienungsanleitung

Beliebte Zelt Handbücher anderer Marken

OZTENT

OZTENT JV SIGNATURE EDITION Bedienungsanleitung

GigaTent

GigaTent Summer Chalet Mini Tent Bedienungsanleitung

Coleman

Coleman 2000007827 Handbuch

ShelterLogic

ShelterLogic 107153 Bedienungsanleitung

Outsunny

Outsunny 84C-230 Bedienungsanleitung

Napier

Napier SPORTZ COVE 61 Series Bedienungsanleitung

EuroTrail

EuroTrail ATLANTIS PRO Bedienungsanleitung

Reimo

Reimo Marina Bedienungsanleitung

TiiTENT

TiiTENT TB300 Bedienungsanleitung

Coleman

Coleman 2000033134 Installationsanleitung

Ozark Trail

Ozark Trail W784.1 Kurzanleitung

SlingFin

SlingFin CrossBow 2 Bedienungsanleitung

Coleman

Coleman 9600-141 Bedienungsanleitung

Palram

Palram Arizona 5000 Wave - WINGS Bedienungsanleitung

COVERPRO

COVERPRO 56184 Montageanleitung

Vango

Vango Zenith 100 Bedienungsanleitung

Costway

Costway PATIOJOY OP70818 Bedienungsanleitung

Clarke

Clarke PUC 88 Bedienungsanleitung