①To save time, water and energy, can do pre-spinning before rinsing.
②Put laundries which have already been dehydrated into the wash tub.
③After filling water to the desired level, turn off the water tap to save water.
④Turn the “Wash selector” knob to the "Gentle” or “Normal”.
⑤Set the “wash timer”to the desired time (about 3-5 minutes)for rinsing.
⑥After rinsing, put the washing materials into the spin tub to spin for 1 to 5 minutes.
⑦Drain out the rinsing water in the wash tub.
⑧The above steps can be repeated.
Spin timer
B. Common rinse (rinse in the wash tub)
The appliance can not be used by children or persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
The new hose supplied with the appliance are to be used and that old hose should not be used.
When choosing the water inflowing to wash tub or spin tub , please do not move the water inlet valve
during the process of water inflowing.
If strong vibration occurs in time of spinning, open the spin cover immediately. Make sure that the washing
machine is placed on a flat and stable floor ,and then adjust washing materials, distribute them evenly.
To do spinning and draining together, please spin for 1 minute before draining.
Do not wash or spin waterproof clothes or clothes that float easily to avoid abnormal vibration or damage
to the clothes.
Spinning Method
Correct Incorrect
Spin cover
Safety cover
Spin timer
1.Shake out the laundry and put
them into the spin tub.
2.Put the inner spin cover on .
Confirm the inner spin cover is placed
horizontally.
the laundry
3.Close the safety cover and the
spin cover.
Inner
spin cover
Spin tub
4.Refer to the following table to select
spinning time.
Washing materials
Silk
Light clothes
(fiber/blended)
Knitwear (fiber)
Underwear
(cotton)
Slipover
(cotton/linen)
Toweling coverlet
(cotton)
About 50
seconds
About 1
minute
About 1～2
minutes
About 2～3
minutes
About 3～4
minutes
About 5
minutes
Spin time
-7--6-
Usage methodUsage method
B.Buzzer function (For machines having buzzer function only)
● Fold in half along
the long edge
● 1/3 fold in the
same direction
Roll up the blanket● Put into the tub with
blanket edge facing down
●
Dilute detergent with water (below 50℃), then pour the solution into
Fold the blanket as shown in the figure, and into the wash tub.
①adequate the wash tub.
②put it
This machine can wash blended blanket (less than 3 kg) marked with the "hand washing"
label.Washing method is as follows:
Wash timer
Soak
35
15
10
5
Work time
about 5 about 5 about 5
Total: 35 (mins)
about 1.5 about 1.5
about 2
Static time
For seriously stained clothes, Soak wash is useful to achieve better wash result.
15-35 minutes of the wash timer is for soak wash:(illustrate as follows)
35 15
(unit：)mins
Special Features
A.Soak function (For machines having soak function only )
Function of the buzzer is to alarm finish of washing,and it is helpful to control wash process.
● Buzzer will alarm the completion of washing.
The dual voltage washing machine can work at the voltage of 220V or 127V to meet needs of different
countries and areas.
Unplug the washing machine plug to cut off the power supply.
Remove the back cover.
Take down the nylon clip, and remove the plastic bag.
Connect the Wash127V of the terminal connector with “Wash”, “Spin127V” with “Spin” , then the voltage
can be converted to “127V60Hz”.
Put the wires in order, wrap them in the plastic bag, and refix the back cover. Then the washing machine
can be powered for operation.
If convert the voltage from 127V60Hz to 220V60Hz:
Steps - are the same as above
Connect the “Wash 220V” of the terminal connector with “Wash”, “Spin 220V” with “Spin” to convert the
voltage to .
The step is the same as above
In the step above, should connect the terminal connectors of both wash and spin, and make sure to
connect correctly.
*The factory-set voltage is 220V60Hz . Users can chose the voltage according to the regional voltage range.
● convert the voltage from 220V60Hz to 127V60Hz :
①
②
③
④“ ”
⑤
●
①② ③ ① ③
④
220V60Hz
⑤ ⑤
④
“ ”
C.The dual voltage (For machines having the dual voltage function only)
(For efficiency program only )
Efficiency Program
The tests were carrid out under program Normal. Below is the detail for test seting and steps;
1. Main wash: 30 min., H water level, wash temperature 40 ℃;
2.Spin: 3 min., 2 times; 4 kg test load for one turn;
3. Rinse: 3 min., L water level, water temperature 20 ℃;
4. Spin: 3 min., 2 times; 4 kg test load for one turn.
