Panasonic VDR-D210P Bedienungsanleitung
©2007 Panasonic Shikoku Electronics Co., Ltd. All
rights reserved. Unauthorized copying and
distribution is a violation of law.
VDR-D210P
VDR-D220P
VDR-D230P
VDR-D210PC
VDR-D220PC
VDR-D230PC
Vol. 1
Colours
(S)...................Silver Type
Digital Video Camcorder
ORDER NO. MKE0701450CE
B17
1 Safety Precautions 3
1.1. General Guidelines 3
2 Warning 4
2.1. Prevention of Electro Static Discharge (ESD) to
Electrostatically Sensitive (ES) Devices 4
2.2. How to Recycle the Lithium Battery 4
2.3. How to Replace the Lithium Battery 5
3 Service Navigation 6
3.1. Introduction 6
3.2. About Lead Free Solder (PbF) 6
4 Specifications 7
5 Service Mode 8
5.1. Error Display 8
5.2. Service Menu 8
6 Service Fixture & Tools 10
6.1. Service Fixture and Tools 10
6.2. Service Position 11
6.3. Removal/Installation of F.P.C. From Non ZIF (Zero
Insertion Force) Connector 13
6.4. Method for Ejecting the DVD Tray Manually 14
6.5. EEPROM Data 14
6.6. Special Note 15
6.7. Model No. Identification Mark 15
7 Disassembly and Assembly Instructions 16
7.1. Cabinet Section 16
8 Measurements and Adjustments 35
8.1. Electrical Adjustment 35
9 Maintenance 37
9.1. Cleaning Lens, Viewfinder and LCD Panel 37
9.2. Cleaning disc and optical pickup 37
10 Troubleshooting 39
11 Voltage Chart of Connectors on Main P.C.B. 48
12 Block Diagrams 49
13 Schematic Diagrams 51
13.1. SCHEMATIC DIAGRAM & CIRCUIT BOARD LAYOUT
NOTES 51
13.2. FRONT SCHEMATIC DIAGRAM 52
13.3. BOTTOM SCHEMATIC DIAGRAM 53
13.4. LCD BACKLIGHT SCHEMATIC DIAGRAM 54
13.5. SIDE R / EVF FPC / EVF BACKLIGHT / LED LIGHT
SCHEMATIC DIAGRAMS 55
13.6. CCD / REAR CASE / LCD SW SCHEMATIC DIAGRAMS
56
13.7. SIDE L/OPERATION / DISK COVER LOCK SCHEMATIC
DIAGRAMS 57
13.8. INTERCONNECTION SCHEMATIC DIAGRAM 58
14 Printed Circuit Board 59
14.1. FRONT P.C.B. 59
14.2. BOTTOM P.C.B. 60
14.3. LCD BACKLIGHT P.C.B. 61
14.4. SIDE R P.C.B. 62
15 Exploded View 63
15.1. MAIN PARTS SECTION 63
15.2. FRONT HOOD AND FRONT P.C.B. SECTION 64
15.3. SIDE R OPERATION AND LCD SECTION 65
15.4. CCD AND LENS SECTION 66
15.5. GRIP COVER AND EVF SECTION 67
15.6. PACKING PARTS AND ACCESSORIES SECTION 68
16 Replacement Parts Lists 69
16.1. REPLACEMENT NOTES 69
16.2. MECHANICAL REPLACEMENT PARTS LIST 70
16.3. ELECTRICAL REPLACEMENT PARTS LIST 71
CONTENTS
Page Page
2
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
1 Safety Precautions
1.1. General Guidelines
1. IMPORTANT SAFETY NOTICE
There are special components used in this equipment
which are important for safety. These parts are marked by
in the Schematic Diagrams, Circuit Board Layout,
Exploded Views and Replacement Parts List. It is essential
that these critical parts should be replaced with
manufacturer’s specified parts to prevent shock, fire, or
other hazards. Do not modify the original design without
permission of manufacturer.
2.An Isolation Transformer should always be used during the
servicing of AC Adaptor whose chassis is not isolated from
the AC power line. Use a transformer of adequate power
rating as this protects the technician from accidents
resulting in personal injury from electrical shocks. It will also
protect AC Adaptor from being damaged by accidental
shorting that may occur during servicing.
3.When servicing, observe the original lead dress. If a short
circuit is found, replace all parts which have been
overheated or damaged by the short circuit.
4.After servicing, see to it that all the protective devices such
as insulation barriers, insulation papers shields are properly
installed.
5.After servicing, make the following leakage current checks
to prevent the customer from being exposed to shock
hazards.
3
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
2 Warning
2.1. Prevention of Electro Static Discharge (ESD) to Electrostatically
Sensitive (ES) Devices
Some semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are called
Electrostatically Sensitive (ES) Devices. Examples of typical ES devices are integrated circuits and some field-effect transistors and
semiconductor "chip" components. The following techniques should be used to help reduce the incidence of component damage
caused by electro static discharge (ESD).
1.Immediately before handling any semiconductor component or semiconductor-equipped assembly, drain off any ESD on your
body by touching a known earth ground. Alternatively, obtain and wear a commercially available discharging ESD wrist strap,
which should be removed for potential shock reasons prior to applying power to the unit under test.
2.After removing an electrical assembly equipped with ES devices, place the assembly on a conductive surface such as
aluminum foil, to prevent electrostatic charge buildup or exposure of the assembly.
3.Use only a grounded-tip soldering iron to solder or unsolder ES devices.
4.Use only an antistatic solder removal device. Some solder removal devices not classified as "antistatic (ESD protected)" can
generate electrical charge sufficient to damage ES devices.
5.Do not use freon-propelled chemicals. These can generate electrical charges sufficient to damage ES devices.
6.Do not remove a replacement ES device from its protective package until immediately before you are ready to install it. (Most
replacement ES devices are packaged with leads electrically shorted together by conductive foam, aluminum foil or comparable
conductive material).
7.Immediately before removing the protective material from the leads of a replacement ES device, touch the protective material
to the chassis or circuit assembly into which the device will be installed.
CAUTION :
Be sure no power is applied to the chassis or circuit, and observe all other safety precautions.
8.Minimize bodily motions when handling unpackaged replacement ES devices. (Otherwise harmless motion such as the
brushing together of your clothes fabric or the lifting of your foot from a carpeted floor can generate static electricity (ESD)
sufficient to damage an ES device).
2.2. How to Recycle the Lithium Battery
4
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
2.3. How to Replace the Lithium Battery
The lithium battery (CGR-F/202AW) is not supplied as a service part and must be replaced as part of the Bottom P.C.B. (Refer to
“Disassembly and Assembly Instructions.")
NOTE:
This Lithium battery is a critical component. (Type No.: CGR-F/202AW Manufactured by Panasonic.) (Not supplied)
It must never be subjected to excessive heat or discharge.
It must therefore only be fitted in equipment designed specifically for its use.
Replacement batteries must be of the same type and manufacture.
They must be fitted in the same manner and location as the original battery, with the correct polarity contacts observed.
Do not attempt to re-charge the old battery or re-use it for any other purpose.
It should be disposed of in waste products destined for burial rather than incineration.
5
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
3 Service Navigation
3.1. Introduction
This service manual contains technical information which will allow service personnel´s to understand and service this model.
Please place orders using the parts list and not the drawing reference numbers.
If the circuit is changed or modified, this information will be followed by supplement service manual to be filed with original service
manual.
Note 1:
AC Adaptor used on these movie camera is PV-DAC14D. However, DE-974FB is supplied as a replacement part for PV-
DAC14D. This AC Adaptor is supplied only as a unit.
3.2. About Lead Free Solder (PbF)
6
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
4 Specifications
7
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
5 Service Mode
5.1. Error Display
"PUSH THE RESET SWITCH" is displayed automatically on the EVF or the LCD Monitor when an undesirable condition has
occurred.
Fig. 1
Note:
When "PUSH THE RESET SWITCH" is displayed repeatedly, service is required. Check the Error Code which is listed in the
Service Menu.
5.2. Service Menu
When abnormal detection contents are confirmed, do the following operation. Automatic diagnosis code will bedisplayed. (Service
Menu)
To enter the Service Menu
Push the [DELETE], [JOYSTICK CONTROL LEFT] and [RECORDING START/STOP] simultaneously for 3 seconds (with no
SD Card inserted).
Note:
If a Disc or SD Card is inserted, the above operation will not work.
Fig. 2-1
8
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
Note:
Only perform items 1, 3, and 4 in the Service Menu.
To select the Item
1.Set to Service Menu.
2.Press [JOYSTICK CONTROL UP/DOWN] to select item [1], [3], or [4].
3.Press [JOYSTICK CONTROL RIGHT] to display [YES/NO] screen.
4.Press [JOYSTICK CONTROL UP/DOWN] to select [YES].
5.Press [JOYSTICK CONTROL CENTER] to end.
Fig. 2-2
To exit the Service Menu
Unplug the AC Cord.
9
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
6 Service Fixture & Tools
6.1. Service Fixture and Tools
10
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC
Dieses Handbuch passt für folgende Modelle
5
Inhaltsverzeichnis
Andere Panasonic Camcorder Handbücher
Panasonic
Panasonic NV-A3E Bedienungsanleitung
Panasonic
Panasonic NV-MS5A Bedienungsanleitung
Panasonic
Panasonic PV-L550 - VHS-C Camcorder Bedienungsanleitung
Panasonic
Panasonic PV-800 Bedienungsanleitung
Panasonic
Panasonic MEMORY CARD CAMERA-RECORDER AG-AF100P Bedienungsanleitung
Panasonic
Panasonic AJSDX900P - 24P DVCPRO 50 Bedienungsanleitung
Panasonic
Panasonic AJ-PX270 Bedienungsanleitung
Panasonic
Panasonic HDC-SD700 Bedienungsanleitung
Panasonic
Panasonic Viera HX-DC1 Bedienungsanleitung
Panasonic
Panasonic NV-S500EN Bedienungs- und Wartungsanleitung
Panasonic
Panasonic AJ-HPX2100E Bedienungsanleitung
Panasonic
Panasonic AVCHD AG-AC7 Bedienungsanleitung
Panasonic
Panasonic NV-GS70EG Bedienungsanleitung
Panasonic
Panasonic POVCAM AG-MDC10G Bedienungsanleitung
Panasonic
Panasonic AJHDC20A - CAMERA VTR Bedienungsanleitung
Panasonic
Panasonic KX-THA16 - Cordless Video Camera Station Bedienungsanleitung
Panasonic
Panasonic AVCCAM AG-AC90P Bedienungsanleitung
Panasonic
Panasonic SDR-S100 Bedienungsanleitung
Panasonic
Panasonic SDR-S70P Bedienungsanleitung
Panasonic
Panasonic HC-V760EE Bedienungsanleitung
