Panasonic AU-VREC1 Gebrauchs- und Pflegehandbuch

Firmware update procedure

Recording module: AU-VREC1,

Camera module: AU-V23HS1, AU-V35C1

NOTE:

Ver. 2.03: After AU-V35C1 is updated, please perform ABB with the lens cap

fitted on according to the procedure stated in this update manual.

This is for the sensor adjustment needed after 120p mode is newly equipped.

Only the first ABB adjustment after the update is definitive. It cannot be

done over again.

Please be careful because, if it is not successfully completed, the product

will not work correctly when you use it.

1. How to check firmware version

1. Connect Camera module to Recording module. Switch ON the power of the camera recorder.

2. Press MENU button. Select “> SYSTEM SETTINGS >INFORMATION >VERSION” to display the current

version with the Jog Dial button.

Camera module

Recording module

Version display

example

NOTE: The firmware versions of the camera module and the recording module must match to operate this unit.

Firmware of the camera module can be updated only when the recording module is connected.

CAMERA

: AU

V23HS1

SERIAL NO : H4TAA0003

PRODUCT VERSION : 0.35-06-9.18

RECORDER : AU-VREC1

SERIAL NO : L4TAA0004

PRODUCT VERSION : 0.35-06-9.18

Jog Dial button

button

Firmware update procedure for Varicam series

January 2015

Page2/5

2. Preparation

Prepare following equipment and a firmware package prior to update.

Name Qty Remark

SD memory card 1

MAX 64GB MIN 256MB

Note: microP2 card can also be used as substitution for SD cards but the

card has to be formatted as SD CARD in the SD card slot in advance.

Firmware package

(VSI****.zip) 1 Can be downloaded at: http://panasonic.biz/sav/pass_e

AC adaptor 1

Computer (PC/Mac) 1 Needed for downloading, unzipping, copying firmware package

! Important: Please read before performing update:

For updating, it is necessary to connect Camera module to Recording module.

Update work may take approximately 60 minutes, use secure power supply (AC

adaptor), unexpected shutdown while in update may cause an

unrecoverable failure.

Do NOT eject SD memory card while update is in progress (while access

LED blinks), interrupting communication between SD card and equipment

may cause unrecoverable failure.

3. Updating firmware

[Preparation]

1. Insert an SD memory card into the SD card slot ( NOT microP2 card slot ) on the unit.

2. Format the SD card (MENU : SYSTEM SETTINGS > CARDS/MEDIA > FORMAT CARD > SD CARD)

Visit Panasonic professional video support website <http://panasonic.biz/sav/pass_e> and download

"vsi*****.zip" firmware package.

3. Extract the ZIP package (you will see "PRIVATE" folder).

4. Mount the formatted SD card to the computer then copy the "PRIVATE" folder to the SD card.

Extract

Copy to

ROOT

directory

SD card slot

Access LED

Firmware update procedure for Varicam series

January 2015

Page3/5

[Perform update]

5. Insert the SD card into the SD card slot (NOT microP2 card slot) on the unit.

6. Disconnect the cable between the viewfinder and the camera body.

7. Press INFO button to display INFO screen. Press the operation button of VERSION and press the Jog Dial..

8. When “UPDATE” menu item appears, press the

operation button of UPDATE > OK

9. Wait until the “Version update successful” dialog is

displayed. It may take approximately 60 minutes

(Maximum).

10.Remove the SD card.

11.Switch OFF the power, and disconnect and connect

DC power > switch ON the power to complete.

12.Make sure the firmware version.

MENU:

SYSTEM SETTINGS >INFORMATION >VERSION

Please refer to the next page

SD card slot

Access LED

UPDATE

EXIT

Jog Dial button

INFO button

VERSION operation button

Firmware update procedure for Varicam series

January 2015

Page4/5

Never fail to perform this after the update

After AU-V35C1 is updated, please perform ABB with the lens cap fitted on

according to the procedure. This is for the sensor adjustment needed after

120p mode is newly equipped.

Only the first ABB adjustment after the update is definitive. It cannot be

done over again.

Please be careful because, if it is not successfully completed, the product

will not work correctly when you use it.

MENU ：SYSTEM SETTINGS > SYSTEM MODE

FREQUENCY 59.94p

PIXCEL 4096 x 2160

MAIN CODEC AVC-Intra4K-LT

HIGH SPEED ON (60-120fps)

Reboot the camera and wait for 15 minutes or longer with the power on.

Check SENSOR TEMP and, if it is not between 38℃and 43℃, wait for a further 15 minutes or so.

MENU: SYSTEM SETTINGS > INFORMATION > SENSOR TEMP between 38℃and 43℃

(Temperature readings can be updated by pushing the jog dial button two times.)

Be sure to put the lens cap or mount cap to block out the light completely.

(If you proceed to the next step without blocking the light, you cannot perform

ABB again by MENU even after it is not completed.)

MENU: SYSTEM SETTINGS > COLOR SETTING

MAIN V-709

MENU: CAMERA SETTINGS > Enhanced > Enhanced SW > ON

MENU: CAMERA SETTINGS > BLACK > ABB

[EXECUTE]

After about a minute, “ABB ACTIVE” is displayed on the panel.

When “ABB OK” is displayed, ABB is completed.

However software cannot be updated, please contact Panasonic Service Engineering.

Firmware update procedure for Varicam series

January 2015

Page5/5

4. Troubleshoot

1. “UPDATE” menu item does not appear.

It may happen in following cases;

- When package file or copied location are NOT correct (“PRIVATE” folder was not copied to the upper directory

of the SD card).

2. VERSION UPDATE ERROR! Screen is displayed!

This error will be happened in following case;

- When firmware package used is for other products. Check if the package is for the right product.

- When firmware package is corrupted. Download the firmware package and try again.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Panasonic Digitalkamera Handbücher

Panasonic

Panasonic OneHome BB-HCM581A Kurzanleitung

Panasonic

Panasonic Lumix DMC-FX100 Kurzanleitung

Panasonic

Panasonic Lumix G6 Bedienungsanleitung

Panasonic

Panasonic Lumix DMC-LX5 Bedienungsanleitung

Panasonic

Panasonic Lumix DMC-ZS7 Bedienungsanleitung

Panasonic

Panasonic DMC-FH7K Montage- und Serviceanleitung

Panasonic

Panasonic Lumix DMC-FZ10GN Bedienungsanleitung

Panasonic

Panasonic Lumix DMC-LX1EG-K Bedienungsanleitung

Panasonic

Panasonic DMC-GF6K Bedienungsanleitung

Panasonic

Panasonic Lumix DMC-FZ1000 Bedienungsanleitung

Panasonic

Panasonic DMCLX1PP - DIGITAL STILL CAMERA Bedienungsanleitung

Panasonic

Panasonic Lumix DMC-GH2K Bedienungsanleitung

Panasonic

Panasonic Lumix DMC-GH3A Technische Daten

Panasonic

Panasonic Lumix DMC-F2PC Bedienungsanleitung

Panasonic

Panasonic Lumix DMC-FH22 Technische Daten

Panasonic

Panasonic DMC-TZ101 Technische Daten

Panasonic

Panasonic Lumix DMC-TS20R Bedienungsanleitung

Panasonic

Panasonic Lumix DMC-LX100 Technische Daten

Panasonic

Panasonic LUMIX DC-ZS200D Bedienungsanleitung

Panasonic

Panasonic Lumix DMC-FS35 Technische Daten

Panasonic

Panasonic DMC-SZ1A Bedienungsanleitung

Panasonic

Panasonic Lumix DMC-FH22 Bedienungsanleitung

Panasonic

Panasonic DMC-ZS10S Montage- und Serviceanleitung

Panasonic

Panasonic Lumix DMC-FS5 Bedienungsanleitung

Beliebte Digitalkamera Handbücher anderer Marken

Mercury

Mercury 350K Bedienungsanleitung

Pentax

Pentax Optio LS 465 Bedienungsanleitung

Sanyo

Sanyo VPC-S1085 Bedienungsanleitung

GE SMART A1255 Bedienungsanleitung

Point Grey

Point Grey Gazelle Bedienungsanleitung

Nikon

Nikon COOLPIX A Bedienungsanleitung

Pentax

Pentax P-5 Bedienungsanleitung

BlazeVideo

BlazeVideo A280 Bedienungsanleitung

Sony

Sony MCA-20 Bedienungsanleitung

Sony

Sony Alpha DSLR-A290 Bedienungsanleitung

ATIK Cameras

ATIK Cameras One Bedienungsanleitung

CohuHD Costar

CohuHD Costar 3930 Series Bedienungsanleitung

Leica

Leica M10-R Bedienungsanleitung

FujiFilm

FujiFilm FinePix A700 Bedienungsanleitung

Lorex

Lorex LNZ81P25 Series Bedienungsanleitung

GE J1470S Bedienungsanleitung

Sony

Sony A6700 Benutzerhandbuch

Canon

Canon EOS ELAN7 Bedienungsanleitung