Panasonic PT AE1000E Bedienungsanleitung

TQDJ19046

CEILING MOUNT BRACKET SAFEGUARDS

The projector and the ceiling mount bracket are designed sufficiently safety though, make sure the safety cable provided

with the projector is installed and attached to the bottom of the projector when mounting in the ceiling for safety and security.

JInstalling the safety cable

1. Install the ceiling mount bracket according to the Installation Instructions.

2. Loop the security cable around the ceiling mount bracket with less slack.

• Lace the cable of the end with a latch through the loop on the other end of the cable.

3. Attach the latch on to the bottom of the projector with a provided screw.

• Torque: 125±20 N·cm

NOTE:

• Even if it is guarantee period, the manufacturer is not responsible for any hazard or damage caused by using a ceiling mount

bracket which is not purchased from an authorised distributors, or environmental conditions.

• Make sure to use a torque driver and do not use an electrical screwdriver or an impact screwdriver.

• Installation work of the ceiling mount bracket should only be carried by a qualified technician.

• Remove an unused ceiling mount bracket promptly.

AE1000_Leaflet_Wire&Lamp.fm Page 1 Wednesday, October 25, 2006 10:48 AM

S1006-0A

ERRATA

JOpening the top cover

(Operating Instructions

page 42)

1. Turn off the MAIN POWER switch

according to the procedure “Switching

the projector on/off” on page 19 and

disconnect the mains plug from the mains

socket.

• Make sure the Lamp unit and the

surroundings are cooled enough.

2. Open the top cover of the projector and

remove aside. See “Back and bottom

view” on page 13.

• Hold the top cover up and press one of the

buttons of the hinge parts each to remove.

JOpening the top cover (Operating

Instructions page 42)

1. Turn off the MAIN POWER switch according to the

procedure “Switching the projector on/off” on page 19

and disconnect the mains plug from the mains socket.

• Make sure the Lamp unit and the surroundings are

cooled enough.

2. Hold at the back corner of the Top cover and slightly

push up to open.

3. Unhook the top cover safety hook from the projector.

4. Hold the top cover up and press one of the buttons of

the hinge parts each to remove.

• When the projector is mounted in the ceiling, removing

the hinge parts is not required.

5. Remove the top cover aside.

NOTE: When the projector is mounted in the ceiling;

• Place yourself at back side of the projector, then open and

close the top cover.

• Do not work directly under the projector or put your face closer

to the projector.

Press here

Top cover safety hook Hinge parts

Press here

Top cover

JAttaching the top cover

(Operating Instructions

page 43)

1. Attach the hinge parts of the top cover to

the projector and press slightly until it

clicks

2. Hook the tabs of the top cover to the

projector and lift down slowly.

3. Press the back corner of the top cover

gently until it clicks.

JAttaching the top cover (Operating

Instructions page 43)

1. Attach the hinge parts of the top cover to the

projector and press slightly until it clicks.

• When the projector is mounted in the ceiling, attaching

the hinge parts is not required.

2. Hook the top cover safety hook to the projector.

3. Hooking the tabs of the top cover to the front of the

projector and lift down slowly.

4. Press the back corner of the top cover gently until it

clicks.

NOTE:

• Ensure to hook the top cover safety hook to the body.

Top cover safety hook Tab

Top cover

AE1000_Leaflet_Wire&Lamp.fm Page 2 Wednesday, October 25, 2006 10:48 AM

TQDJ19046

CEILING MOUNT BRACKET SAFEGUARDS

The projector and the ceiling mount bracket are designed sufficiently safety though, make sure the safety cable provided

with the projector is installed and attached to the bottom of the projector when mounting in the ceiling for safety and security.

JInstalling the safety cable

1. Install the ceiling mount bracket according to the Installation Instructions.

2. Loop the security cable around the ceiling mount bracket with less slack.

• Lace the cable of the end with a latch through the loop on the other end of the cable.

3. Attach the latch on to the bottom of the projector with a provided screw.

• Torque: 125±20 N·cm

NOTE:

• Even if it is guarantee period, the manufacturer is not responsible for any hazard or damage caused by using a ceiling mount

bracket which is not purchased from an authorised distributors, or environmental conditions.

• Make sure to use a torque driver and do not use an electrical screwdriver or an impact screwdriver.

• Installation work of the ceiling mount bracket should only be carried by a qualified technician.

• Remove an unused ceiling mount bracket promptly.

AE1000_Leaflet_Wire&Lamp.fm Page 1 Wednesday, October 25, 2006 10:48 AM

S1006-0A

ERRATA

JOpening the top cover

(Operating Instructions

page 42)

1. Turn off the MAIN POWER switch

according to the procedure “Switching

the projector on/off” on page 19 and

disconnect the mains plug from the mains

socket.

• Make sure the Lamp unit and the

surroundings are cooled enough.

2. Open the top cover of the projector and

remove aside. See “Back and bottom

view” on page 13.

• Hold the top cover up and press one of the

buttons of the hinge parts each to remove.

JOpening the top cover (Operating

Instructions page 42)

1. Turn off the MAIN POWER switch according to the

procedure “Switching the projector on/off” on page 19

and disconnect the mains plug from the mains socket.

• Make sure the Lamp unit and the surroundings are

cooled enough.

2. Hold at the back corner of the Top cover and slightly

push up to open.

3. Unhook the top cover safety hook from the projector.

4. Hold the top cover up and press one of the buttons of

the hinge parts each to remove.

• When the projector is mounted in the ceiling, removing

the hinge parts is not required.

5. Remove the top cover aside.

NOTE: When the projector is mounted in the ceiling;

• Place yourself at back side of the projector, then open and

close the top cover.

• Do not work directly under the projector or put your face closer

to the projector.

Press here

Top cover safety hook Hinge parts

Press here

Top cover

JAttaching the top cover

(Operating Instructions

page 43)

1. Attach the hinge parts of the top cover to

the projector and press slightly until it

clicks

2. Hook the tabs of the top cover to the

projector and lift down slowly.

3. Press the back corner of the top cover

gently until it clicks.

JAttaching the top cover (Operating

Instructions page 43)

1. Attach the hinge parts of the top cover to the

projector and press slightly until it clicks.

• When the projector is mounted in the ceiling, attaching

the hinge parts is not required.

2. Hook the top cover safety hook to the projector.

3. Hooking the tabs of the top cover to the front of the

projector and lift down slowly.

4. Press the back corner of the top cover gently until it

clicks.

NOTE:

• Ensure to hook the top cover safety hook to the body.

Top cover safety hook Tab

Top cover

AE1000_Leaflet_Wire&Lamp.fm Page 2 Wednesday, October 25, 2006 10:48 AM

Dieses Handbuch passt für folgende Modelle

Andere Panasonic Projektor Handbücher

Panasonic

Panasonic PT-MZ10K Bedienungsanleitung

Panasonic

Panasonic PTL759U - LCD PROJECTOR Bedienungsanleitung

Panasonic

Panasonic PT-D9510E Bedienungsanleitung

Panasonic

Panasonic PT-DW5100L Systemhandbuch

Panasonic

Panasonic PT-LB75EA Bedienungsanleitung

Panasonic

Panasonic PTL785U - LCD PROJECTOR UNIT Bedienungsanleitung

Panasonic

Panasonic PT-AE500 Bedienungsanleitung

Panasonic

Panasonic PT-LW321 Bedienungsanleitung

Panasonic

Panasonic PT-VX400NTU Bedienungsanleitung

Panasonic

Panasonic PTLB20VU - LCD PROJECTOR - MULTI-LANG Bedienungsanleitung

Panasonic

Panasonic PT-D5600U Bedienungsanleitung

Panasonic

Panasonic PT-L735 Systemhandbuch

Panasonic

Panasonic PT-AE200 Stücklistenhandbuch

Panasonic

Panasonic PT-LX26H Systemhandbuch

Panasonic

Panasonic PT-LW373 Betriebsanleitung

Panasonic

Panasonic PT-LB10U - Mobile Projector XGA 2000 Lumens Bedienungsanleitung

Panasonic

Panasonic PTL592U - LCD PROJECTOR Bedienungsanleitung

Panasonic

Panasonic PT-LB78 Bedienungsanleitung

Panasonic

Panasonic PT-D6000K Bedienungsanleitung

Panasonic

Panasonic L711U - XGA LCD Projector Bedienungsanleitung

Panasonic

Panasonic PT-LB51NT Bedienungsanleitung

Panasonic

Panasonic PT-LB75 Stücklistenhandbuch

Panasonic

Panasonic PT-LX300 Bedienungsanleitung

Panasonic

Panasonic PTL795U - LCD PROJECTION Bedienungsanleitung

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Epson

Epson VS400 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Toshiba

Toshiba TLP-791U Bedienungsanleitung

Philips

Philips LC1341 Referenzhandbuch

NEC

NEC NP600S EDU Bedienungsanleitung

BenQ

BenQ SH753P Bedienungsanleitung

Eiki

Eiki EK-623U series Bedienungsanleitung

Epson

Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Christie

Christie LHD700 Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Acer

Acer C20 Series Bedienungsanleitung

Asus

Asus ZenBeam Latte Bedienungsanleitung