Panasonic SB-HS950P Bedienungsanleitung

Type 1 way, 1 speaker system (Bass reflex)

Speaker unit(s) Impedance 4 Ω

Full range 6.5 cm (2-1/2”) cone type

Input power (IEC) 100 W* (Max)

Output sound pressure 80 dB/W (1.0 m)

Frequency range 89 Hz - 25 kHz (-16 dB)

105 Hz - 22 kHz (-10 dB)

Dimensions (W x H x D) 92 x 142 x 95 mm

1 System Combination 2

1.1. System Breakdown 2

1.2. Packaging information 2

2 Assembling and Disassembling 3

2.1. Disassembly flow chart 3

2.2. Disassembly of Rear cabinet 4

2.3. Disassembly of Woofer 5

rights reserved. Unauthorized copying and

distribution is a violation of law.

SB-HS950P

Colour

(K)... Black Type

(3-5/8” x 5-19/32” x 3-3/4”)

Mass 0.6 kg (1.32 lbs)

Notes :

1. Specifications are subject to change without notice.

Mass and dimensions are approximate.

2. Total harmonic distortion is measured by the digital spectrum

analyzer.

* : Rating with low-cut filter equipped amplifier.

2.4. Disassembly of Terminal jack 5

3 Connection of the Speaker Cables 6

4 Connection of the Wiring Diagram 9

5 Exploded view 10

5.1. Cabinet Parts Location 10

6 Replacement Parts List 11

Speaker System

Specification

CONTENTS

Page Page

ORDER NO. MD0702011CE

1 System Combination

1.1. System Breakdown

Note :

The diagrams below show the breakdown for speaker combinations used in main unit systems.

SB-PT950P-K consists of SB-HF950P-K (x2), SB-HS950P-K (x2), SB-HC950P-K (x1)

1.2. Packaging information

Note :

Please refer to service manual of SB-HF950P-K (MD0702010CE) to understand the packaging condition for SB-HS950P-K.

SB-HS950P

2 Assembling and Disassembling

“ATTENTION SERVICER”

Some chassis components may have sharp edges. Be careful when disassembling and servicing.

1. This section describes procedures for checking the operation of the major printed circuit boards and replacing the main

components.

2. For reassembly after operation checks or replacement, reverse the respective procedures.

Special reassembly procedures are described only when required.

3. Select items from the following index when checks or replacement are required.

4. Refer to the Parts No. on the page of “Parts Location and Replacement Parts List” (Section 6), if necessary.

Below is the list of disassembly sections

Disassembly of Rear cabinet

Disassembly of Woofer

Disassembly of Terminal jack

2.1. Disassembly flow chart

The following chart is the procedure for disassembling the casing and inside parts for internal inspection when carrying out the

servicing.

To assemble the unit, reverse the steps shown in the chart as below.

SB-HS950P

2.2. Disassembly of Rear cabinet

Step 1: Remove 4 screws.

Step 2: Upset the speaker unit as shown above.

Step 3: Insert steel rule at the bottom corner of the rear cabinet

as arrow shown.

Step 4: Apply light force to push out the front panel as arrow

shown.

Caution:

Do not exert strong force as it may damage the rear cabinet.

Step 5: Detach the blue (+) and gray (-) wires.

SB-HS950P

2.3. Disassembly of Woofer

Follow (step 1) to (step 4) in item 2.2.

Step 1: Detach the gray (-) and blue (+) wires.

Step 2: Remove 4 screws.

2.4. Disassembly of Terminal jack

Follow (step 1) to (step 5) in item 2.2.

Step 1: Remove 1 screw from the terminal jack.

Step 2: Remove terminal jack as arrow shown.

SB-HS950P

3 Connection of the Speaker Cables

Be sure to connect speaker cables before connecting the AC power supply cord.

The load impedance of any speaker used with this unit must be 4 Ω.

Be sure to connect the cable from the right speaker to the right terminal and the cable from the left speaker to the left terminal.

1. Twist and pull off the vinyl tip of the speaker cords. If the speaker cords do not have vinyl tips, connect them directly to the

terminals. Make sure the bare ends of the wires are not unravelled.

2. Insert the wire to the rear panel of the unit and close the lever.

Notes :

To prevent damage to circuitry, never short-circuit positive (+) and negative (-) speaker wires.

Be sure to connect only positive (white) wires to positive (+) terminals and negative (blue) wires to negative (-) terminals.

SB-HS950P

Positioning the speakers

SB-HS950P

Note on speaker use

Use only supplied speakers.

Using other speakers can damage the unit, and sound quality will be negatively affected.

You can damage your speakers and shorten their useful life if you play sound at high levels over extended periods.

Reduce the volume in the following cases to avoid damage.

−

− −

− When playing distorted sound.

−

− −

− When the speakers are reverberating due to a record player, noise from FM broadcasts, or continuous signals from an

oscillator, test disc, or electronic instrument.

−

− −

− When adjusting the sound quality.

−

− −

− When turning the unit on or off.

If irregular coloring occurs on your television

The front and center speakers are designed to be used close to a television, but the picture may be affected with some

televisions and setup combinations.

If this occurs, turn the television off for about 30 minutes.

The demagnetizing function of the television should correct the problem.

If it persists, move the speakers further away from the television.

Caution

Do not touch the front netted area of the speakers. Hold by the sides.

e.g. Center speaker

SB-HS950P

4 Connection of the Wiring Diagram

SB-HS950P

5 Exploded view

5.1. Cabinet Parts Location

SB-HS950P

Inhaltsverzeichnis

Andere Panasonic Lautsprechersystem Handbücher

Panasonic

Panasonic RP-SP1000 Bedienungsanleitung

Panasonic

Panasonic SB-AK450PL Bedienungsanleitung

Panasonic

Panasonic SC-MT1 Bedienungsanleitung

Panasonic

Panasonic TY-SP65P10WK Bedienungsanleitung

Panasonic

Panasonic HTB4152B/12 Bedienungsanleitung

Panasonic

Panasonic SC-NE5DB Bedienungsanleitung

Panasonic

Panasonic SB-AFC800E Bedienungsanleitung

Panasonic

Panasonic SB-PF500 Bedienungsanleitung

Panasonic

Panasonic SA-HT833VP Bedienungsanleitung

Panasonic

Panasonic SBTP1000 - SYSTEM -MULTI LANG Bedienungsanleitung

Panasonic

Panasonic SB-HF950P Bedienungsanleitung

Panasonic

Panasonic SBLV500 Bedienungsanleitung

Panasonic

Panasonic SBZT1 - SPEAKER SYSTEM Bedienungsanleitung

Panasonic

Panasonic sb-hep20 Bedienungsanleitung

Panasonic

Panasonic SC-ALL2 Bedienungsanleitung

Panasonic

Panasonic Sound Slayer SC-GN01 Bedienungsanleitung

Panasonic

Panasonic SC-NE5DB Bedienungsanleitung

Panasonic

Panasonic SC-ALL2GN Bedienungsanleitung

Panasonic

Panasonic SC-TMAX40 Bedienungsanleitung

Panasonic

Panasonic SCHDX2 - AMPLIFIER SPEAKER SYSTEM Bedienungsanleitung

Panasonic

Panasonic SC-SB1 Bedienungsanleitung

Panasonic

Panasonic RXDS515 - RADIO CASSETTE W/CD Bedienungsanleitung

Panasonic

Panasonic SB-HEP20 Bedienungsanleitung

Panasonic

Panasonic SC-BTT190 Gebrauchsanweisung

Beliebte Lautsprechersystem Handbücher anderer Marken

JVC

JVC CA-MXK5R Bedienungsanleitung

LG NB4532B Bedienungsanleitung

JVC

JVC CA-FSH100 Bedienungsanleitung

5Core

5Core Pro Series Bedienungsanleitung

EAW

EAW MQV1394e Bedienungsanleitung

Lynx

Lynx GXR-LA10A Bedienungsanleitung

iLive

iLive ITB066B Bedienungsanleitung

RDX

RDX QuickStation 4 Bedienungsanleitung

Electro-Voice

Electro-Voice S-122 Bedienungsanleitung

Sven

Sven SPS-619 GOLD Bedienungsanleitung

Pioneer

Pioneer CS-7070 Bedienungsanleitung

EAW

EAW UB82e Bedienungsanleitung

Sondpex

Sondpex Active Speaker System and Digital Music... Bedienungsanleitung

JVC

JVC NX-PN7 Bedienungsanleitung

Marshall Amplification

Marshall Amplification AR-DM61-BT Bedienungsanleitung

Yamaha

Yamaha NX-A01 - Speaker Sys Bedienungsanleitung

SE Audiotechnik

SE Audiotechnik I-LINE Bedienungsanleitung

Gemini

Gemini WRX-843 Series Bedienungsanleitung