Paradox PRK-315 Bedienungsanleitung
Arm / Disarm Wireless Module
433MHz V1.3 (PRK-315)
WITH KEELOQ HIGH-SECURITY CODE ENCRYPTION
Reference & Installation Manual
TABLE OF CONTENTS
INTRODUCTION ...................................... 1
Features.................................................... 1
Technical Specifications ........................... 2
INSTALLATION........................................ 3
Location & Mounting................................. 3
Power & Communication .......................... 4
Keypad...................................................... 5
Antennas................................................... 6
Programmable Outputs (PGMs) ............... 6
Hand-Held Remote Control....................... 7
Remote Control Button Identification........ 8
System Reset.......................................... 10
HOW TO PROGRAM ............................. 13
SYSTEM PROGRAMMING.................... 16
Access Code Length............................... 16
Installer Code (Default: 757575)............. 16
User Parameters..................................... 16
Panic Output Programming..................... 21
Panic Lockout Timer............................... 22
PGM Output Timing................................ 23
Button PGM Options............................... 24
Panic Option ........................................... 25
Parakey 1
1.0 INTRODUCTION
The PARAKEY (PRK-315) is a wireless remote
control system that consists of a receiving module
and up to eight 4-button remote controls
(transmitters). When used in conjunction with any
Paradox Esprit Series Control Panel, remote
controls can perform actions such as remote
arming and disarming, communicating panic
alarms and/or activating programmable outputs
(PGMs). Each remote control is assigned to a
specific user and therefore, identifies the user to
the control panel when used. If desired, it can be
used as a stand-alone system where the remote
controls will only activate the on-board PGM
outputs. When a button on the remote control is
pressed, it will transmit an RF signal. When the
PARAKEY receives this signal, it then processes
the request and performs the programmed
action(s).
1.1 FEATURES
•Simple, user-friendly programming.
•Supports 8 User Codes, each linked to a unique
RF Code (4-button remote control).
•Encrypted RF codes for additional security. Does
not use DIP switch programming.
•4 programmable outputs (PGMs).
2 Reference & Installation Manual
•Stand-alone operation (trigger PGMs only) or in
conjunction with a Paradox Esprit Series Control
Panel (arm/disarm, panic & PGM activation).
•Programming keypad connects directly to the
Parakey Receiving Module.
•Programmable Installer Code.
•Software reset.
1.2 TECHNICAL SPECIFICATIONS
1.2.1 Receiver:
Compatible Programming
Keypads:
(616 V4.2A &
up)
(626 V4.1A &
up)
(636)
DC input: 12VDC
PGM outputs: 4
PGM Output 1-3 Current Rating: 30mA max.
PGM Output 4 Current Rating: 5A relay
Operating Conditions: 0°C to 50°C
Operating Humidity: 85%
Operating Frequency: 433.92MHz
Sensitivity: -110dbm
Parakey 3
1.2.2 Remote Control:
2.0 INSTALLATION
2.1 LOCATION &MOUNTING
We recommend installing the receiver in a
centralized location on the main floor. Avoid
installing the receiver in the basement. Although,
if desired, it can be installed in proximity of the
control panel. When selecting an installation site
please take into consideration that the maximum
reception distance of the receiver is
approximately 54 meters (175 feet) line of sight.
The circuit is static sensitive, thus take great care
during handling.
Model # 344:
Model # OMN-RCT1: 433MHz Remote Control
433MHz Remote Control
Water Resistant
Batteries: 2 Lithium 3V (CR2016)
Power Transmission: 28mW
Current Consumption: 21mA (transmission)
Max. Transmission
Range: 300 ft. (95m)
4 Reference & Installation Manual
Avoid installing the receiving module near
or in the path of strong RF fields, such as
neon lights or computers. Also avoid
installing the receiver on or near metal
objects, circuit breaker boxes, air
conditioners and heater ducts. These
devices may cause interference, reducing
the receiver's sensitivity.
If installing the Parakey away from the control
panel, mount the Parakey Receiver Module on a
wall, leaving at least 2 inches around the panel
box to permit adequate ventilation/heat
dissipation. Selecting a site that is not susceptible
to drastic changes in temperature and humidity.
2.2 POWER &COMMUNICATION
2.2.1 With Esprit Control Panel
When used in conjunction with any Paradox
Esprit Series Control Panel, the auxiliary
terminals (12VDC) of the control panel may power
the Parakey Receiving Module as shown in
Figure 4 (page 11). If using an external power
source please ensure that the "GND"ofthe
receiver and the power source are connected to
the "AUX-" terminal of the control panel (see
Figure 4 on page 11).
The "GRN" and "YEL" terminals of the control panel
Parakey 5
must be connected to the "GRN" and "YEL"
terminals of the Parakey Receiving Module in
order to provide communication between the
modules. Alternatively, you can use a 4-pin serial
connector between the control panel's "SERVICE
KEYPAD" connector and the Parakey Module's
"PANEL" connector (see Figure 4 on page 11).
2.2.2 Stand-Alone
When used as a stand-alone system, you will
need a Paradox 12VDC Power Supply and a
12VDC backup battery. Connect the power supply
and the backup battery as shown in Figure 5
(page 12).
2.3 KEYPAD
The Parakey Receiving Module is programmed
using a 616 or 626 Esprit LED Keypad. Connect
the keypad as shown in Figure 5 (page 12).
Alternatively, you can connect the keypad to the
Parakey Module's "PROGRAM" connector using a
4-pin serial connector.
The Parakey can only be programmed
using:
616 keypad version 4.2A and up or
626 keypad version 4.1A and up.
6 Reference & Installation Manual
2.4 ANTENNAS
Firmly screw the vertical and horizontal antennas
to the corresponding "ANT" connections on the
Receiving Module as shown in Figure 4 (page 11)
or Figure 5 (page 12). Use of the horizontal
antenna is optional, but is recommended for best
results.
Do not cut, bend or alter the antennas in
any way, as this may reduce the
receiver's sensitivity (range).
2.5 PROGRAMMABLE OUTPUTS (PGMS)
The Parakey provides four programmable outputs
(OUT1toOUT4)eachofwhichcanbe
programmed for a variety of home/office
automation applications, such as opening a
garage door when a button is pressed on the
remote control. Please refer to Figure 1 (page 7)
and section 4 (page 16) for more information.
Inhaltsverzeichnis
Andere Paradox Fernbedienung Handbücher
Paradox
Paradox Magellan REM15 Bedienungsanleitung
Paradox
Paradox Magellan REM2 Bedienungsanleitung
Paradox
Paradox Magellan REM101 Bedienungsanleitung
Paradox
Paradox Magellan MG-RAC1 Bedienungsanleitung
Paradox
Paradox Magellan REM2 Service-Handbuch
Paradox
Paradox Two-Way Remote Control V2.1 Bedienungsanleitung
Paradox
Paradox PARAKEY Montageanleitung
Paradox
Paradox Magellan REM15 Bedienungsanleitung
Paradox
Paradox REM25 Bedienungsanleitung
Paradox
Paradox REM3 Bedienungsanleitung
Paradox
Paradox Magellan REM101 Bedienungsanleitung
Paradox
Paradox Magellan REM2 Bedienungsanleitung
Paradox
Paradox REM3 Bedienungsanleitung
Paradox
Paradox Magellan MG-REM2 Bedienungsanleitung
Paradox
Paradox Magellan REM101 Bedienungsanleitung
Paradox
Paradox MAGELLAN REM1 Bedienungsanleitung
Paradox
Paradox Magellan REM1 Bedienungsanleitung
Paradox
Paradox Magellan REM15 Bedienungsanleitung
Paradox
Paradox Magellan MG-REM1 Bedienungsanleitung
Paradox
Paradox Magellan RAC1 Bedienungsanleitung
Beliebte Fernbedienung Handbücher anderer Marken
Panasonic
Panasonic EUR7622KB0 Bedienungsanleitung
Bang & Olufsen
Bang & Olufsen Beo4 Bedienungsanleitung
Sunwave Tech.
Sunwave Tech. RemoteComm SRC-7000 Bedienungsanleitung
Multiplex
Multiplex PROFI TX 9 Bedienungsanleitung
One Remote
One Remote RMB4 Bedienungsanleitung
FUTABA
FUTABA 9ZAP - PART2 Bedienungsanleitung
