Partner SP-1000 Bedienungsanleitung
POS Terminal
SP-1000
User Manual
i
Copyright
This publication, including all photographs, illustrations and software, is protected under international
copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be
reproduced without written consent of the author.
Disclaimer
The information in this document is subject to change without notice. The manufacturer makes no
representations or warranties with respect to the contents hereof and specifically disclaims any implied
warranties of merchantability or fitness for any particular purpose. The manufacturer reserves the right to
revise this publication and to make changes from time to time in the content hereof without obligation of the
manufacturer to notify any person of such revision or changes.
Trademark recognition
All product names used in this manual are the properties of their respective owners and are acknowledged.
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment onto an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interconnect cables and a shielded AC power cable must be employed with this equipment to
ensure compliance with the pertinent RF emission limits governing this device. Changes or modifications not
expressly approved by the system’s manufacturer could void the user’s authority to operate the equipment.
Declaration of conformity
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
ii
About this manual
This manual is intended for system administrators who are familiar with setting up a new system and
installing an operating system.
The manual consists of the following sections:
Chapter 1 Getting Started: This section covers unpacking and checking the
package contents, and identifying components.
Information on connecting peripheral devices, and
powering on is also provided.
Chapter 2 BIOS Setup Utility: The BIOS chapter provides information on navigating
and changing settings in the BIOS Setup Utility.
Chapter 3 Upgrading Components: This section provides information on upgrading
components.
Appendix: The appendix covers troubleshooting, information
on having the SP-1000 serviced, and technical
specications.
Safety information
Before installing and using the SP-1000, take note of the following precautions:
• Read all instructions carefully.
• Do not place the unit on an unstable surface, cart, or stand.
• Do not block the slots and opening on the unit, which are provided for ventilation.
• Do not push objects in the ventilation slots as they may touch high voltage components and result in
shock and damage to the components.
• Only use the power source indicated on the marking label. If you are not sure, contact your dealer or the
Power Company.
• The unit uses a three-wire ground cable, which is equipped with a third pin to ground the unit and
prevent electric shock. Do not defeat the purpose of this pin. If your outlet does not support this kind of
plug, contact your electrician to replace your obsolete outlet.
• Do not place anything on the power cord. Place the power cord where it will not be in the way of foot
traffic.
• Follow all warnings and cautions in this manual and on the unit case.
• When replacing parts, ensure that your service technician uses parts specified by the manufacturer.
• Avoid using the system near water, in direct sunlight, or near a heating device.
WARNING
The system uses a 3V CR2032 battery mounted on the mainboard to
keep time. There is a risk of explosion if the wrong battery type is used
when replacing. Dispose of used batteries according to local ordinance
regulations.
CAUTION
The USB ports can be damaged if care is not taken when connecting
devices. Ensure USB devices are correctly inserted.
Plugging a phone line into the LAN port (RJ-45 connector) can damage
the connector. Take care only plug an RJ-45 connector into the LAN port.
Revision history
Version 1.0, October 2010
iii
TABLE OF CONTENTS
CHAPTER 1 GETTING STARTED................................................ 1
Unpacking the machine .................................................................................1
Checking the package contents ....................................................................2
Identifying components .................................................................................3
Connecting peripheral devices.......................................................................6
Connecting a cash drawer .............................................................................7
Powering the machine on and off...................................................................8
Mounting the SP-1000 on the wall .................................................................9
CHAPTER 2 BIOS SETUP...........................................................11
About the Setup Utility .................................................................................11
Entering the Setup Utility ........................................................................12
BIOS navigation keys ..............................................................................12
Using BIOS .............................................................................................13
Main Screen.................................................................................................14
Advanced Settings .......................................................................................15
IDE Conguration.........................................................................................16
Primary/ Secondary IDE Master...................................................................17
USB Conguration .......................................................................................18
USB Mass Storage Device Conguration ....................................................19
ACPI Conguration ......................................................................................20
MPS Conguration.......................................................................................21
SuperIO Conguration .................................................................................22
Hardware Health Conguration....................................................................23
Hardware Health Conguration....................................................................24
CHAPTER 3 UPGRADING COMPONENTS............................... 37
Safety and precautions ...............................................................................37
Before you begin .........................................................................................38
Upgrading the hard drive..............................................................................39
APPENDIX .................................................................................. 41
Troubleshooting ...........................................................................................41
Tips for Troubleshooting...............................................................................41
The Power-On Self Test ...............................................................................41
iv
Beep Errors at POST ...................................................................................41
Beep Message Errors at POST ...................................................................42
General Problems .......................................................................................43
Having the SP-1000 Serviced .....................................................................44
Specications...............................................................................................45
1
CHAPTER 1
GETTING STARTED
This chapter describes the procedures from unpacking the SP-1000, to powering it on. The following topics
are described.
• Unpacking the machine on page 1
• Checking the package contents on page 2
• Identifying components on page 3
• Connecting peripheral devices on page 6
• Connecting a cash drawer on page 7
• Powering the machine on and off on page 8
• Mounting the SP-1000 on the wall on page 9
Unpacking the machine
The machine and cable accessories are packed in a cardboard carton with foam padding for protection during
shipping.
Figure 1.1 Unpacking the
machine
Carefully unpack the machine and keep the packing materials. If you need to ship it in the future, repack it as
shown in Figure 1.1.
2 CHAPTER 1 GETTING STARTED
Checking the package contents
After you unpack the device check that the following items are included.
If any item is missing or appears damaged, contact your dealer immediately.
SP-1000
Adapter Power Cable
Driver CD with drivers and
the user manual PDF le.
3
Identifying components
This section describes the parts and connectors on the machine.
1 2
Figure 1.2 Front-right view
Component Description
1 15-inch TFT LCD
2 LED Power Indicator
3 IO Panel
4 HDD Compartment
5 Power Button
3 54
Front-right view
4 CHAPTER 1 GETTING STARTED
Rear view
1 2 3 4
Figure 1.3 Rear view
Component Description
1 MSR (optional) Slot
2 HDD Compartment (for wall mounting)
3 VFD Customer Display (optional) Slot
4 Cable Compartment
Andere Handbücher für SP-1000
1
Inhaltsverzeichnis
Andere Partner Touch-Terminal Handbücher
Partner
Partner MF-2352 Bedienungsanleitung
Partner
Partner E5-1-K Bedienungsanleitung
Partner
Partner PAT-215 Bedienungsanleitung
Partner
Partner PT-4000i Bedienungsanleitung
Partner
Partner SP-3511 Bedienungsanleitung
Partner
Partner Themis TI-890 Bedienungsanleitung
Partner
Partner PT-9000 Bedienungsanleitung
Partner
Partner SP-650-Q Bedienungsanleitung
Partner
Partner OT-310 Bedienungsanleitung
Partner
Partner PT-6910 Series Bedienungsanleitung
Partner
Partner PT-6212-EB Bedienungsanleitung
Partner
Partner PT-8800 Bedienungsanleitung
Partner
Partner SP-2500 Series Bedienungsanleitung
Partner
Partner SP-820 Bedienungsanleitung
Partner
Partner SP-650-S Bedienungsanleitung
Partner
Partner SP-650 Bedienungsanleitung
Partner
Partner SP-550 Bedienungsanleitung
Partner
Partner CD-70 Bedienungsanleitung
Partner
Partner SP-800 Bedienungsanleitung
Partner
Partner PT-5910 Bedienungsanleitung
Beliebte Touch-Terminal Handbücher anderer Marken
Wincor Nixdorf
Wincor Nixdorf iPOS plus Advanced Bedienungsanleitung
Ingenico
Ingenico AXIUM EX4000 Bedienungsanleitung
Heisei Electronics
Heisei Electronics Q-POS 815 Bedienungsanleitung
Amano
Amano MTX-15 Bedienungsanleitung
FLOWBIRD
FLOWBIRD CWT Compact Touch Bedienungsanleitung
Demco
Demco SP7 Bedienungsanleitung
YASKAWA
YASKAWA 62H-MDC0 Bedienungsanleitung
MVG industries
MVG industries NeptuLink Bedienungsanleitung
Price Industries Limited
Price Industries Limited FDC Gebrauchsanweisung
Honeywell
Honeywell TemaKey Bedienungsanleitung
EBN
EBN BPC65-B-A16G Bedienungsanleitung
Prestel
Prestel VCS-G2PRO Bedienungsanleitung