9
GUARD INSTALLATION
CONTINUED
• Place the cable tray corners in the back to
corners and fasten to the cable tray.
• Then x the control panel in the control box
recess by removing the boom of the control
box, xing the Panel to the Box and replacing the
boom of the box. Lay the cable in the cable tray
but do not cable e unl the guards are bolted to
the oor.
• Fix the light barrier brackets to both front guards
using M8 x 55 bolts, make sure the bracket are the correct way up and the with the ‘T’ at
the top. The light barriers need be on the central posion on they brackets. The light
barrier cables are rolled up on both side
of the machine at the boom of the
‘A’ frame legs. From the front of the
machine on the le hand side there is
two cables (one extra for the control
panel) and on the right hand side there is
one cable. Lay them loosely in the cable
tray and connect then to the boom of
light barriers.
• Once the machine is connected to the
power supply, check the alignment of the
light barriers, adjust guards if needed.
• Check the guard are in the correct
posions lock o the power to the
machine. Tighten all the guards, mark out
the guard oor holes to be drilled. And
remove the light barrier and but in a safe
place.
• Once the guards and light barriers are in
the correct posion drill the oor for
each aachment posion of the guard
feet (8mm x 100mm in depth). Locate
the M8 oor bolts for the xed guarding
securely into the ground. Once the
guards are aligned, ghten all guard
panel fasteners (once the holes are marked the cable tray can be removed to help with
access and replaced when guards are bolted to the oor).
Control
Panel
Box
Light
barrier
on
Bracket
Light
barrier
Bracket
Cable
tray
