PCchips M583 Series Bedienungsanleitung
Mainboard User’s Manual
This publication, including all photographs, illustrations and
software, is protected under international copyright laws, with all
rights reserved. Neither this manual, nor any of the material
contained herein, may be reproduced without the express written
consent of the manufacturer.
The information in this document is subject to change without
notice. The manufacturer makes no representations or warranties
with respect to the contents hereof and specifically disclaims any
implied warranties of merchantability or fitness for any particular
purpose. Further, the manufacturer reserves the right to revise this
publication and to make changes from time to time in the content
hereof without obligation of the manufacturer to notify any person
of such revision or changes.
Trademarks
I M, VGA, and PS/2 are registered trademarks of International
usiness Machines.
Intel, Pentium, Pentium-II, Pentium-III, MMX, and Celeron are
registered trademarks of Intel Corporation.
Microsoft, MS-DOS and Windows NT/95/98/2000 are registered
trademarks of Microsoft Corporation.
Sound laster is a trademark of Creative Technology Ltd.
PC-cillin and ChipAwayVirus are trademarks of Trend Micro Inc.
AMI is a trademark of American Megatrends Inc.
A3D is a registered trademark of Aureal Inc.
SuperVoice is a registered trademark of Pacific Image
Communications Inc.
MediaRing Talk is a registered trademark of MediaRing Inc.
3Deep is a registered trademark of E-Color Inc.
Other names used in this publication may be trademarks and are
acknowledged.
Copyright © 2001
All Rights Reserved
M583 Series, V1.3B
A156 /April 2001
M583LMR Mainboard User’s Manual
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a
Class digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment onto an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interconnect cables and shielded AC power cable must be
employed with this equipment to insure compliance with the pertinent RF
emission limits governing this device. Changes or modifications not
expressly approved by the system’s manufacturer could void the user’s
authority to operate the equipment.
Declaration of Conformity
This device complies with part 15 of the FCC rules. Operation is subject
to the following conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including
interference that may cause undesired operation.
Canadian Department of Communications
This class digital apparatus meets all requirements of the Canadian
Interference-causing Equipment Regulations.
Cet appareil numérique de la classe respecte toutes les exigences du
Réglement sur le matériel brouilieur du Canada.
II
M583LMR Mainboard User’s Manual
Table of Contents
Chapter 1: Introduction...................................................................1
Key Features...........................................................................2
Package Contents....................................................................5
Static Electricity Precautions..................................................6
Pre-Installation Inspection......................................................6
Chapter 2: Mainboard Installation..................................................7
Mainboard Components..........................................................8
I/O Ports..................................................................................9
Install A CPU..........................................................................9
Install Memory......................................................................11
Setting Jumper Switches.......................................................12
Install the Mainboard............................................................14
Install the Extension rackets...............................................16
Install Other Devices............................................................17
Expansion Slots....................................................................19
Chapter 3: IOS Setup Utility......................................................21
Introduction..........................................................................21
Running the Setup Utility.....................................................22
Standard CMOS Setup Page.................................................23
Advanced Setup Page...........................................................24
Power Management Setup Page............................................26
PCI / Plug and Play Setup Page............................................28
Load Optimal Settings..........................................................29
Load est Performance Settings...........................................29
Features Setup Page..............................................................29
CPU PnP Setup Page............................................................31
Hardware Monitor Page........................................................32
Change Password..................................................................32
Exit.......................................................................................33
Chapter 4: Software & Applications.............................................35
Introduction..........................................................................35
Installing Support Software..................................................35
Auto-installing under Windows 98.......................................37
Using the PCI Audio Software..............................................39
The Four Speakers System....................................................40
III
M583LMR Mainboard User’s Manual
IV
1: Introduction
Chapter 1
Introduction
This mainboard supports all Socket 7 processors including newer
designs which feature a 100 MHz system bus. The mainboard
firmware supports CPU Plug and Play so that the system will
automatically adopt the correct configuration for the Socket-7
processor that you install.
This mainboard uses the ALi Art chipset which integrates a 3D
128-bit AGP Graphics Accelerator with Hardware Geometry
Engine and has an embedded 10BaseT/100BaseT Ethernet
Network Interface. The mainboard has a built-in PCI 3D Sound
System and a V.90 Fax/Modem DAA module is shipped with the
mainboard. In addition, the mainboard has a full set of AT I/O
Ports including PS/2 keyboard and mouse ports, two US ports, a
parallel port, a serial port and a VGA port.
This mainboard has all the features you need to develop a powerful
multimedia workstation that is network ready, and has built-in
communications. The board is Flex-AT size and has power
connectors for an AT power supply.
1
M583LMR Mainboard User’s Manual
Key Features
The key features of this mainboard include:
Socket-7 Processor Support
Supports all recent socket-7 processors including the Intel
P55C (Pentium MMX), the Cyrix/I M 6x86L/6x86M
/MII, the AMD K6/K6-2/K6-III, IDT C6, and WinChip
2/2A CPUs
Supports socket-7 processors with system bus frequencies
of 66/100 MHz
CPU Plug and Play support lets the firmware
automatically configure the CPU
Me ory Support
Two DIMM slots for 168-pin SDRAM memory modules
Support for 66MHz, 100MHz memory bus
Maximum installed memory is 2 x 512M = 1 G
Support Symmetric (128-bit) architecture
Note: For the best performance, please use the same memory
size with the same single/double side on the both two
DIMM slots
Expansion Slots
Two 32-bit PCI slots
Onboard IDE channels
Primary and Secondary PCI IDE channels
Support for PIO (programmable input/output) modes
Support for Multiword DMA modes
Support for us Mastering and Ultra DMA 33/66 modes
Power Supply and Power Manage ent
ATX power supply connector
ACPI and previous PMU support, suspend switch,
keyboard power on/off
Supports Wake on Modem and Wake on Alarm
2
1: Introduction
Built-in Graphics Syste
Onboard advanced 128-bit 2D/3D AGP Graphics
Accelerator
Supports Hardware Geometry Engine
Shared SDRAM memory architecture allows a maximum of
32 M main memory to act as frame buffer
Supports high resolutions up to 1600x1200 and 32-bit color
pipeline, up to 2048x2048 Texture size and Virtual screen
up to 4096x4096
High performance 128-bit 2D GUI/DirectDraw acceleration
Video Acceleration for Direct7, DirectShow, MPEG-1,
MPEG-2 and Indeo
Sound Syste
Complies with the PC98 audio specification
16-bit CODEC for full-duplex playback and recording
HRTF 3D professional audio supports both Direct Sound
3D® and A3D®-compatible interfaces plus support for 4-
channel speakers
Driver support for MS-DOS, Microsoft Windows
95/98/2000/NT 4.0
uilt-in 32ohm earphone buffer and 3D surround sound
Provides MPU-401 Game/MIDI port and legacy Sound
laster 16 support
Downloadable Wave-table Synthesizer supports Direct
Music®
Stereo Mixer supports analog mixing from CD-Audio and
Line In
Onboard I/O Ports
Provides PC99 Color Connectors for easy peripheral device
connections
Floppy disk drive connector with 1Mb/s transfer rate
3
M583LMR Mainboard User’s Manual
One serial port with 16550-compatible fast UART
One parallel port with ECP and EPP support
Two US ports
Two PS/2 ports for keyboard and mouse
One infrared port header for optional module
Built-in Ethernet LAN
10BaseT/100BaseT Ethernet LAN
LAN controller integrates Fast Ethernet MAC and PHY
compliant with IEEE802.3u 100 ASE-TX, 10 ASE-T and
ANSI X3.263 TP-PMD standards
Compliant with ACPI 1.0 and the Network Device Class
Power Management 1.0
High Performance provided by 100Mbps clock generator and
data recovery circuit for 100Mbps receiver
Fax/Mode DAA Module
56 Kbps Fax/Modem DAA module
Supports V.90, V.34, V.32bis, V.32, V.22bis, V.22
Supports Auto Fallback and MNP 5, V.42bis data compression
with 115,200-compatible Virtual UART
Requires 16M RAM and Microsoft Windows 95/98/NT
Onboard Flash ROM
Automatic CPU and board configuration
Supports Plug and Play configuration of peripheral devices
and expansion cards
uilt-in virus protection using Trend’s ChipAwayVirus
provides boot process virus protection.
Bundled Software
PC-Cillin2000 provides automatic virus protection under
Windows NT/95/98/2000
SuperVoice is data, fax and voice communication software
MediaRing Talk provides PC to PC or PC to Phone
internet phone communication
3Deep delivers the precise imagery and displays accurate
color in your monitor
4
1: Introduction
Di ensions
Flex-ATX form factor (22.9cm x 19cm)
Package Contents
Attention: This mainboard series includes four different models.
They are M583LMR (LAN/Modem Ready), M583LR (LAN
Ready), M583MR (Modem Ready) and M583 (without LAN &
Modem).
Please contact your local supplier for your purchase model.
Each model will support different specification, list as below:
Model Specification
M583LMR Onboard LAN chip (U9), LAN (RJ45)
connector and a Fax/Modem DAA module
M583LR Onboard LAN chip (U9) and LAN (RJ45)
connector
M583MR A Fax/Modem DAA module
M583 ---
Your mainboard package ships with the following items:
The mainboard
This User’s Guide
1 UDMA/33 IDE cable
1 Floppy disk drive cable
Support software on CD-ROM disk
Optional Accessories
You can purchase the following optional accessories for this
mainboard.
UDMA/66 IDE cable
5
M583LMR Mainboard User’s Manual
Static Electricity Precautions
Components on this mainboard can be damaged by static
electricity. Take the following precautions when unpacking the
mainboard and installing it in a system.
1. Keep the mainboard and other components in their original
static-proof packaging until you are ready to install them.
2. During installation, wear a grounded wrist strap if possible. If
you don’t have a wrist strap, discharge static electricity by
touching the bare metal of the system chassis.
3. Handle the mainboard carefully by the edges. Avoid touching
the components unless it is absolutely necessary. During
installation put the mainboard on top of the static-protection
packaging it came in with the component side facing up.
Pre-Installation Inspection
1. Inspect the mainboard for damage to the components and
connectors on the board.
2. If you suspect that the mainboard has been damaged, do not
connect power to the system. Contact your mainboard vendor
and report the damage.
6
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere PCchips Hauptplatine Handbücher
PCchips
PCchips A15G Series Bedienungsanleitung
PCchips
PCchips M935ALU Bedienungsanleitung
PCchips
PCchips Tidalwave W30 Bedienungsanleitung
PCchips
PCchips M758 Plus Series Bedienungsanleitung
PCchips
PCchips M757MR Bedienungsanleitung
PCchips
PCchips M830LU Bedienungsanleitung
PCchips
PCchips M596 Bedienungsanleitung
PCchips
PCchips M930 Series Bedienungsanleitung
PCchips
PCchips M925ALU Bedienungsanleitung
PCchips
PCchips M939LU Bedienungsanleitung
PCchips
PCchips Motherboard Bedienungsanleitung
PCchips
PCchips M700 Series Bedienungsanleitung
PCchips
PCchips M922ULR Bedienungsanleitung
PCchips
PCchips M957G Bedienungsanleitung
PCchips
PCchips M755LMR V7.1 Bedienungsanleitung
PCchips
PCchips M581 Series Bedienungsanleitung
PCchips
PCchips M770LMRT Bedienungsanleitung
PCchips
PCchips M825 Series Bedienungsanleitung
PCchips
PCchips M925 Series Bedienungsanleitung
PCchips
PCchips M765VMRT Bedienungsanleitung
Beliebte Hauptplatine Handbücher anderer Marken
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Bedienungsanleitung
Gigabyte
Gigabyte GA-9IVDT Bedienungsanleitung
Texas Instruments
Texas Instruments ADS8372EVM Bedienungsanleitung
Commell
Commell MS-C73 Bedienungsanleitung
IBT Technologies
IBT Technologies MB860 Bedienungsanleitung
Nvidia
Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung
