Pearl ETHAN Robe Hook Bedienungsanleitung
Ethan
Vanity Accessories
“Robe Hook”
Pearlsinks.com
Introduction Contents
Thank you for purchasing an authentic Pearl
Sinks® vanity accessory. The xture you have
purchased is crafted out of the highest
quality chrome-plated brass. Each and every
xture is carefully inspected by hand before
leaving the production line.
Please read the instructions carefully to
prevent any malfunction and damages.
This xture kit contains the following:
Mounting Plates
x2 x2 x2 x1
Hex Wrench
Plastic Anchors Wood/Anchor Screws
Tools
Philips Screwdriver
Hammer Masking Tape Level
Power Drill 1/4” Drill Bit
WALL
WALL
FACE THIS SIDE TOWARDS YOU
TemplateInstallation
1
Position the template where you would like to mount the xture.
2
Level the template, then attach it to the wall with masking tape.
3
Drill two 5/16” holes on each corresponding mounting plate location.
4
Remove the template from the wall.
5
Insert the plastic anchors into the hole until it is ush with the wall.
6
Install mounting plates onto the wall using the screws provided.
7
Install the the xture and tighten the hex screw.
ACTUAL SIZE
Inhaltsverzeichnis
Andere Pearl Badezimmerarmatur Handbücher
Pearl
Pearl MADISON Robe Hook Referenzhandbuch
Pearl
Pearl ella GLA600-W Bedienungsanleitung
Pearl
Pearl ella GLS320F-W Bedienungsanleitung
Pearl
Pearl NuGranite VERTU Installationsanleitung
Pearl
Pearl ella GLB625A-W Bedienungsanleitung
Pearl
Pearl Lynden Bedienungsanleitung
Pearl
Pearl ella GLS320A-W Bedienungsanleitung
Pearl
Pearl ETHAN Bedienungsanleitung
