Personal Chiller K4024SS Bedienungsanleitung
USER GUIDE
Model K4024SS
SOFT NUGGET
ICE MAKER
READ ALL INSTRUCTIONS BEFORE USE
For your safety and continued enjoyment of this product,
please read the instruction manual before using.
1
INTRODUCTION
Congratulations on your purchase of a restaurant-style soft,
chewable ice maker for your home with no installation or water
hookup required. Unlike hard ice cubes and shapes, soft
chewable ice is made by scraping the ice akes off the inside of a
chilled stainless-steel cylinder, then compacted into light, airy
nuggets. It is not crushed ice or shaved ice, it the perfect small
pellet ice for crunching and munching!
Your Personal Chiller Soft Nugget Ice Maker is desired by soft
ice lovers everywhere with ice made fast and ready anytime for
personal enjoyment or entertaining guests. The low-prole
stainless-steel design complements any kitchen or bar area and
ts under most standard sized cabinets. Simply ll the water
reservoir and press the button to make magical ice within ten
minutes! Ice is always fresh and consistently soft without any
refrigerator or freezer odors. Soft nugget ice enhances the
exquisite taste of cocktails, soft drinks, iced coffees and teas,
or just plain water. Cheers to Soft Nugget Ice!
SOFT NUGGET ICE MAKER
2
LET THE UNIT REST AND REMAIN UNPLUGGED FOR 24 HOURS BEFORE USE.
IMPORTANT:
2 People Recommended
for lifting
Indoor Use Only
Extension cord
NOT recommended
Ensure 4”” clearance from rear
of unit when placed against wall
Distilled, or Purified water
recommended
Use a grounded
3-prong outlet only
No Sharp Knife
to Unpack
No location near
heat/sunlight
4"
WARNING! To reduce the risk of re, explosion, electric shock, exposure to UV
radiation, or injury when using your machine, follow these basic safety precautions.
SAFETY PRECAUTIONS
• This appliance is not a toy. Exercise caution and supervision when
this appliance is used near children.
• Do not allow children to operate the unit.
• Keep ngers away from ice dispenser and bin area while operating.
• Do not use with tap water or water that is not distilled or is unsafe
or of unknown quality.
•Place power cord in such a way it cannot be pulled on by children
or cause a tripping hazard.
•Place power cord in such a way that it is not in contact with hot surfaces.
•Do not operate if any component, including the cord or plug, is damaged.
•Unplug the product before cleaning and when not in use.
•Do not immerse any part of the product in water.
•Do not plug or unplug product with wet hands.
•Do not attempt to disassemble, repair, modify, or replace any part of
your product.
•Use this product only for its intended purpose as described in this user
manual.
•Do not use any accessories not recommended by the manufacturer.
3
ATTENTION! Some types of under-cabinet lamps can be
hot enough to cause damage to your machine top’s appearance.
SAFETY INSTRUCTIONS
• Do not, under any circumstances, alter or remove the third (ground) prong from
the power cord. For personal safety, this product must be properly grounded.
•Do not exceed power outlet ratings. It is recommended that the ice maker is
connected to its own circuit. Use only a 115 V, 60 Hz standard electrical supply
that is properly grounded in accordance with the National Electric Code and
local codes and ordinances.
•Due to potential safety hazards under certain conditions, we strongly advise
against the use of an adapter or an extension cord.
•Do not under any circumstances cut or remove the third ground prong from the
power cord.
• Do not unplug the appliance by pulling the power cord. To properly disconnect
the unit, grip the plug rmly and pull it straight out from the wall outlet.
•To protect against electrical shock do not immerse appliance plug or
cord into water or other liquids.
•This product must be properly installed and located in accordance with the
installation instructions before it is used. Product is for indoor household use only.
•Do not use outdoors. Do not store or use ammable vapors or liquids near
this product.
Circuit grounding
conductor properly
connected.
• When disposing of refrigeration appliances, special handling is required.
Check federal and local regulations before disposing this product.
• Do not operate the appliance with wet hands or
while standing on wet surface or in standing water.
• The Chemical Hazard when cleaning with bleach.
Use bleach in a well-ventilated area and avoid mixing bleach
with other household cleaners.
• Unplug the appliance before cleaning by hand and when not in use.
•To clean the ice bin, remove the bin from the ice maker
and clean inside and outside with a soft cloth.
•Use a dampened cloth with mild soapy water to wipe the drip tray.
4
• To reduce the risk of injury when using machine, follow the basic safety
precautions:
• Do not remove any safety, warning, or product information labels from
your ice maker.
• Lifting Hazard: It is recommended to have two people move and install
the ice maker in order to prevent injury.
• Before cleaning, unplug the appliance before any cleaning or maintenance.
•Do not clean the appliance with ammable uids or solvent-based
cleaning agents.
•Do not use abrasive cleansers on the interior or exterior surfaces as they
could damage or scratch the unit.
• Proper Disposal
CAUTION
Child Entrapment Warning: DANGER or WARNING: Risk of child entrapment. The
appliance is not intended for use by young children or inrm persons without supervision.
Young children should be supervised to ensure that they do not play with the appliance.
What’s Inside
Personal Chiller Soft Nugget Ice Maker, Ice Bin,
Ice Scoop, Water Fill Funnel, Water Drain Hose (1), Quick
Start Guide, User Guide and Customer Review Card
LOCATION OF CONTROLS
Power Button: Press the Power Button once
to turn on the appliance.
Soft Ice Button: Press button once to start making ice.
Clean Button: Press and hold for 3 seconds
for Clean Cycle
Indicator Lights (Power • Add Water • Ice Full)
Water Fill Funnel
Water Reservoir Fill Port
Removable Ice Bin
Water Fill Level Indicator
Magnetized Holder & Water Drain Hose
Water Drip Tray
Water Drain Outlet Port
Ice Scoop
Control Panel
16”
(406mm)
13.4”
(340mm)
9.65”
(245mm)
NOTE: Water Line-in port (outlet on right)
is not applicable to this model, DO NOT USE.
6
CLEANING & MAINTENANCE
Press & hold Clean Cycle button for 3 seconds
LED light turns off when cycle is complete
Unplug unit and release drain hose from clip on side of
unit. Unplug drain hose from holder and empty water
into a sink, or bucket placed lower than the ice maker.
Drain the hose and reattach hose to clip holder and clip
hose to the side of the unit using the magnetic holder.
Plug the unit in and repeat Step 2 with clean, fresh water
3-4 times with draining in between each cycle. Always
unplug the unit before and during the draining process.
Fill water resevoir
with 5 cups of water
+ 1 teaspoon of
bleach to run a
Cleaning Cycle
CUPS Teaspoon
Bleach
Water
5
1
2
Step
TIP: Cleaning is recommended 1X per week if using ice maker daily,
or in between uses. Some noises are common during ice making and
cleaning cycles.
FIRST USE
3
Step
4
Step
5
Step
1
Step
OPERATING INSTRUCTIONS
Making Ice
After cleaning and ushing for initial use, locate the appliance on a
stable counter top or at surface with a minimum of 4” of space all
around the unit, including the back of the unit for proper ventilation.
Remove the water reservoir plug and use the water funnel to ll
with potable water. Keep water to the Max Fill line on the water
level indicator. DO NOT OVERFILL. DO NOT use any liquid except
water as it will nullify the warranty. Due to water hardness in some
areas, it is recommended to use Distilled or Puried Water.
Press the POWER button to turn on the appliance.
Press the SOFT ICE button to start making ice. Ice will be
produced within 10 minutes and continue until the bin is full
or the reservoir requires more water.
Ice will be made continuously from the recirculation of melted ice
water, but it is recommended to power off the appliance and
drain the reservoir when not in use, or relocating it.
• Use potable water only.
•Use PURIFIED WATER to improve ice making performance.
• Water TDS level must be 5~100 mg/L (PPM).
•Water hardness must be no greater than
50mg/L (3 grains/gal).
2
Step
3
Step
4
Step
5
Step
1
Step
NOTE:
NOTE:
UV sanitizing light illuminates ice bin when unit is in
Cleaning Cycle, making ice, or in power standby mode.
Power off unit when not in use.
Water Drain Outlet Port
Water Drain Hose
Magnetic
Hose Holder
7
FLUSHING THE UNIT
Draining Water from Ice Maker
Before ushing and draining, unplug unit.
Remove water drain hose from the holder located on the
side of the unit on the magnetic holder.
Make sure other end of hose is secure on the water drain port
(left port on rear of unit).
Detach hose from the holder and position hose below the level
of the ice maker ready to empty into a sink, or bucket.
Allow the water to completely drain before re-attaching the drain hose to
the magnetized holder and positioning on the side of the unit for future use.
When complete, plug unit back in and add fresh water for ice-making.
1
Step
2
Step
3
Step
4
Step
5
Step
6
Step
2
3
8
Use PURIFIED WATER to improve ice making performance.
TIP:
CARE & CLEANING
For initial use and to keep ice tasting fresh, unplug this unit and
follow these cleaning instructions at least once per week.
Wipe exterior of the ice maker and the interior of the ice bin and
drip tray with a soft damp cloth and wipe dry to avoid any deposits.
Do not use cleaning solvents or abrasive cleansers.
DO NOT USE SOAP IN THE WATER RESERVOIR.
Create a sanitizing solution of (5) cups of water with
(1) teaspoon of household bleach Sodium Hypochlorite (NaCIO).
Carefully pour the solution into the water reservoir using the
supplied funnel.
Plug the unit back in and Press & Hold the Clean Cycle button
for 3 seconds
After the display ring lights yellow, the interior UV light will be
activated with the motor circulating for approximately 3 minutes.
When nished, the Clean Cycle will automatically stop and the display
button will no longer be illuminated.
Unplug the unit and remove the drain hose from magnetic holder to
empty into a sink, or bucket, placed below the level of the ice maker.
Allow the water to completely drain before re-inserting the drain hose
to the magnetized holder and positioning on the side of the unit.
Flush the unit with (5) cups of fresh water 3-4 times, unplugging
and draining the unit for each rinse.
When complete, plug unit back in and add fresh water for ice-making.
Description of product
Model
Voltage/Frequency
Current
Color
Ice storage capacity
Ice making rate
Dimensions (WDH)
(Width x Depth x Height)
Installation clearance
(sides and back)
Operating environment
Weight (when empty)
Soft Nugget Ice Maker
K4024SS (Style D)
120V AC / 60Hz
2.0 A
Stainless/Gray
4.0 lbs
40 lbs per day
9.6 in x 13.4 in x 16 in
4 inch
55°F - 90°F
27.5 lbs
9
Model K4024SS
SPECIFICATIONS
ICE MAKER SOUNDS
Your Personal Chiller Soft Nugget Ice Maker is not like an ordinary
hard ice machine. There are several processes required to create
light, airy soft-textured ice. As a result, there are sounds that
normal to this ice maker:
WHIR - When it is rst turned on, you may notice the sound of the
condenser fan spinning.
BUZZ - When the water pump rst turns on, it may be dry and create
a buzzing sound, which will dissipate when lled with water.
RATTLE - May occur from the ow of the refrigerant and will subside
signicantly once the system has stabilized.
GURGLE - When the refrigerant system shuts off, there may be a brief
gurgle sound as the refrigerant stops owing.
HUM - The compressor is a motor. It produces a low toned humming
sound during operation
CLICK - The rst nuggets produced are the loudest as they are released
into the bottom of the ice bin. As the bin lls, the sound of ice
dropping reduces.
Inhaltsverzeichnis
