Philips CD2950B Bedienungsanleitung

www.philips.com/welcome

CD2950

User manual

English

EN 1

1 Important safety instructions 2

2 Your phone 3

What is in the box 3

Overview of the phone 4

Display icons 5

3 Get started 6

Connect the charger 6

Install the handset 6

Congure your phone (country

dependent) 7

Charge the handset 7

Check the battery level 8

What is standby mode? 8

Check the signal strength 8

Switch the handset on or off 8

4 Calls 9

Make a call 9

End a call 9

Answer a call 9

Adjust the earpiece/speaker volume 10

Mute the microphone 10

Turn the speaker on or off 10

Make a second call 10

Answer a second call 10

Switch between two calls 10

Make a conference call with the

external callers 10

5 Intercom and conference calls 11

Make a call to another handset 11

Transfer a call 11

Make a conference call 11

6 Text and numbers 13

Enter text and numbers 13

Switch between uppercase and

lowercase 13

7 Phone settings 14

Sound settings 14

ECO mode 15

Name the handset 15

Set the date and time 15

Set the display language 15

8 Alarm clock 16

Set the alarm 16

Turn off the alarm 16

9 Services 17

Call list type 17

Auto conference 17

Network type 17

Auto prex 17

Select the recall duration 18

Dial mode 18

Unregister the handsets 19

Restore default settings 19

10 Technical data 20

11 Notice 21

Declaration of conformity 21

Use GAP standard compliance 21

Compliance with EMF 21

Disposal of your old product and

batteries 21

12 Frequently asked questions 23

13 Appendix 24

Text and number input tables 24

14 Index 25

Contents

2 EN

•Do not use any cleaning agents containing alcohol,

ammonia, benzene, or abrasives as these may harm

the set.

•Do not expose the phone to excessive heat caused by

heating equipment or direct sunlight.

•Do not drop your phone or allow objects to fall on

your phone.

•Active mobile phones in the vicinity may cause

interference.

About operating and storage temperatures

• Operate in a place where temperature is

always between 0°C to +40°C (up to 90%

relative humidity).

• Store in a place where temperature is

always between -20°C and +45°C (up to

95% relative humidity).

• Battery life may be shorter in low

temperature conditions.

1 Important safety

instructions

Power requirements

• This product requires an electrical supply of

100-240 volts AC. In case of power failure,

the communication can be lost.

• The voltage on the network is classied

as TNV-3 (Telecommunication Network

Voltages), as dened in the standard EN

60950.

Warning

•The Electrical network is classied as hazardous. The

only way to power down the charger is to unplug the

power supply from the electrical outlet. Ensure that the

electrical outlet is always easily accessible.

To avoid damage or malfunction

Caution

•Use only the power supply listed in the user instructions.

•Use only the batteries listed in the user instructions.

•Risk of explosion if battery is replaced by an incorrect

type.

•Dispose of used batteries according to the instructions.

•Always use the cables provided with the product.

•Do not allow the charging contacts or the battery to

come into contact with metal objects.

•Do not let small metal objects come into contact with

the product.This can deteriorate audio quality and

damage the product.

•Metallic objects may be retained if placed near or on

the handset receiver.

•Do not use the product in places where there are

explosive hazards.

•Do not open the handset, base station or charger as

you could be exposed to high voltages.

•For pluggable equipment, the socket-outlet shall be

installed near the equipment and shall be easily accessible.

•Handsfree activation could suddenly increase the

volume in the earpiece to a very high level: make sure

the handset is not too close to your ear.

•This equipment is not designed to make emergency

calls when the power fails. An alternative has to be

made available to allow emergency calls.

•Do not allow the product to come into contact with

liquids.

English

EN 3

User manual

Quick start guide

Note

•* In some countries, you have to connect the line

adapter to the line cord, then plug the line cord to the

telephone socket.

4XLFNVWDUWJXLGH

2 Your phone

Congratulations on your purchase and welcome

to Philips!

To fully benet from the support that Philips

offers, register your product at www.philips.com/

welcome.

What is in the box

Handset

Charger

Power adapter

Guarantee

4 EN

Mute or unmute the microphone.

j Microphone

• Turn the speaker phone on/off.

• Make and receive calls through the

speaker.

Press and hold to make an intercom call

(for multi handset version only).

• Scroll down on the menu.

• Decrease the earpiece/speaker volume.

• Access the call log.

• Make and receive calls.

• Recall key

• Access the main menu.

• Conrm selection.

• Enter the options menu.

• Select the function displayed on the

handset screen directly above the key.

Overview of the phone

a Earpiece

b Loudspeaker

c Battery door

• Scroll up on the menu.

• Increase the earpiece/speaker volume.

• Access the phonebook.

• Delete text or digits.

• Cancel operation.

• End the call.

• Exit the menu/operation.

• Press and hold to switch the handset

on or off.

• Press to enter a space during text

editing.

• Press and hold to lock the keypad.

• Make a predial call.

• Press and hold to enter a pause when

making a call.

• Switch to upper/lower case during

editing.

English

EN 5

Display icons

In standby mode, the icons shown on the main

screen tell you what features are available on

your handset.

Icon Descriptions

When the handset is off the base

station/charger, the bars indicate the

battery level (from full to low).

When the handset is on the base

station/charger, the bars keep scrolling

until charging completes.

The empty battery icon ashes and you

hear an alert tone.

The battery is low and needs recharging.

It displays the link status between the

handset and base station.The more bars

are shown, the better the signal strength

is.

It remains steadily on when browsing

incoming calls in the call log.

It indicates an outgoing call in the

redial list.

It ashes when there is a new missed call

or when browsing new missed calls.

It remains steadily on when browsing the

missed calls in call log.

It ashes when receiving an incoming call.

It remains steadily on when you are in

a call.

The speaker is on.

The alarm clock is activated.

The ringer is off.

It ashes when there is a new voice

message.

It remains steadily on when the voice

messages are already viewed in the call

log.

The icon is not shown when there is no

voice message.

The silent mode is activated.

The mode is activated.

6 EN

Connect each end of the power adapter to (for

multi handset version only):

• the DC input jack at the bottom of the

extra handset charger.

• the power socket on the wall.

Install the handset

The batteries are pre-installed in the handset.

Pull the battery tape off from the battery door

before charging.

Caution

•Risk of explosion! Keep batteries away from heat,

sunshine or re. Never discard batteries in re.

•Use only the supplied batteries.

•Risk of decreased battery life! Never mix different

brands or types of batteries.

3 Get started

Caution

•Make sure that you have read the safety instructions in

the 'Important safety instruction' section before you

connect and install your handset.

Connect the charger

Warning

•Risk of product damage! Ensure that the power supply

voltage corresponds to the voltage printed on the back

or the underside of the phone.

•Use only the supplied power adapter to charge the

batteries.

Note

•If you subscribe to the digital subscriber line (DSL) high

speed internet service through your telephone line,

ensure you install a DSL lter between the telephone

line cord and the power socket.. The lter prevents

noise and caller ID problems caused by the DSL

interference. For more information on the DSL lters,

contact your DSL service provider.

•The type plate is located on the bottom of the base

station.

English

EN 7

Set the date and time

Tip

•To set the date and time later, press [Back] to skip this

setting.

1 Select [Menu] > [Phone setup] > [Date &

time], then press [OK] to conrm.

2 Press the numeric buttons to enter the

date, then press [OK] to conrm.

3 Press the numeric buttons to enter the

time.

Note

•If the time is in 12-hour format, press / to select

[AM] or [PM].

4 Press [OK] to conrm.

Charge the handset

Place the handset on the charger to charge the

handset.When the handset is placed correctly

on the charger, you hear a docking sound.

» The handset starts charging.

Note

•Charge the batteries for 8 hours before rst use.

•If the handset becomes warm when the batteries are

being charged, it is normal.

You can activate or deactivate the docking tone

(see 'Set the docking tone' on page 14).

Your phone is now ready to use.

Note

•Charge the batteries for 8 hours before rst use.

•If the handset becomes warm when the batteries are

being charged, it is normal.

Warning

•Check the battery polarity when inserting in the

battery compartment. Incorrect polarity may damage

the product.

Congure your phone

(country dependent)

1 When using your phone for the rst time,

you see a welcome message.

2 Press [OK].

Set the language

Select your language, then press [OK] to

conrm.

» The language setting is saved.

To re-set the language, see the following steps.

1 Select [Menu] > [Phone setup] >

[Language], then press [OK] to conrm.

2 Select a language, then press [OK] to

conrm.

» The setting is saved.

8 EN

Check the signal strength

The number of bars indicates the link

status between the handset and base

station.The more bars are shown, the

better the connection is.

• Make sure the handset is linked to the base

station before you make or receive calls

and carry out the functions and features.

• If you hear warning tones when you are

on the phone, the handset is almost out

of battery or the handset is out of range.

Charge the battery or move the handset

closer to the base station.

Switch the handset on or off

Press and hold to switch the handset on or

off.

Check the battery level

The battery icon displays the current battery

level.

When the handset is off the base

station/charger, the bars indicate the

battery level (full, medium and low).

When the handset is on the base

station/charger, the bars ash until

charging is complete.

The empty battery icon ashes. The

battery is low and needs recharging.

The handset turns off if the batteries are empty.

If you are on the phone, you hear warning tones

when the batteries are almost empty.The call

gets disconnected after the warning.

What is standby mode?

Your phone is in standby mode when it is idle.

The standby screen displays the handset name,

handset number, date and time.

Andere Handbücher für CD2950B

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Philips Handy Handbücher

Philips

Philips CD4911B Bedienungsanleitung

Philips

Philips W337 Bedienungsanleitung

Philips

Philips S10H/12 Bedienungsanleitung

Philips

Philips CTD612BLK/40 Bedienungsanleitung

Philips

Philips S10 Bedienungsanleitung

Philips

Philips S358 Bedienungsanleitung

Philips

Philips CT0390BLK/00 Bedienungsanleitung

Philips

Philips CD6950B Bedienungsanleitung

Philips

Philips CT9A9MSLV Bedienungsanleitung

Philips

Philips CT0580BLK/00 Bedienungsanleitung

Philips

Philips CTE100SLV/00 Handbuch

Philips

Philips SAVVY VOGUE Bedienungsanleitung

Philips

Philips TCD238/AUABAA2P Bedienungsanleitung

Philips

Philips CT9A9KBRN Bedienungsanleitung

Philips

Philips CTX510BLK/40 Bedienungsanleitung

Philips

Philips CT0392BLK/40 Bedienungsanleitung

Philips

Philips CTE162BK/94 Bedienungsanleitung

Philips

Philips CT5688/000000EU Bedienungsanleitung

Philips

Philips CD191 Bedienungsanleitung

Philips

Philips Xenium CTX620BLK/40 Bedienungsanleitung

Philips

Philips CT9889/EBUS10II Bedienungsanleitung

Philips

Philips Xenium CT9A9ZBLK/00 Bedienungsanleitung

Philips

Philips Xenium X501 Bedienungsanleitung

Philips

Philips Pronto TSU9300 Sicherheitsleitfaden

Beliebte Handy Handbücher anderer Marken

Zte

Zte BLADE A520 Bedienungsanleitung

Nokia

Nokia Lumia 620 Bedienungsanleitung

Blackbe;rry

Blackbe;rry KEYone Bedienungsanleitung

Bea-fon

Bea-fon X5 Premium Bedienungsanleitung

Blackbe;rry

Blackbe;rry 8707 Series Bedienungsanleitung

Blackbe;rry

Blackbe;rry Storm Betriebsanleitung

LG LM-X420QN Bedienungsanleitung

LifeWatch

LifeWatch V Bedienungsanleitung

Bea-fon

Bea-fon SILVER LINE SL860 Bedienungsanleitung

IKI Mobile

IKI Mobile KF4.5i Bedienungsanleitung

Hitech

Hitech HT-850 Bedienungsanleitung

Yezz

Yezz Fashion F10 Bedienungsanleitung

Point Mobile

Point Mobile PM60 Bedienungsanleitung

Blackbe;rry

Blackbe;rry Q10 Bedienungsanleitung

Blackbe;rry

Blackbe;rry Bold 9900 Bedienungsanleitung

Blackbe;rry

Blackbe;rry STORM 9500 - VERSION 5.0 Bedienungsanleitung

LG LM-K420EMW Bedienungsanleitung

ISAFE MOBILE

ISAFE MOBILE IS655.2 Bedienungsanleitung