Philips AJ100/12 Bedienungsanleitung
User manual
Clock Radio
AJ100
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 1
1
2
3
4
$
!
8
6
5
@
#
%
^
9
0
7
1
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 2
2
3
4
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 3
English
SUPPLIED ACCESSORIES
– 1XAC 7.5V adapter
(Input: 220-230V ~ 50Hz 30mA, Output: 7.5V 250mA)
TOP AND FRONT PANEL
(See 1)
1
REPEAT
ALARM /
BRIGHTNESS CONTROL
–switches off the alarm for a 9 minute period
–changes the brightness of the display illumination
–stops SLEEP function
2DISPLAY
–
shows clock/alarm times and status of the set
3ALARM RESET / SLEEP
–stops active alarm for 24 hours
–activates the radio for sleep function
–
displays/adjusts/switches off sleep timer
4
ALARM
–
switches on/off buzzer mode
–displays time
5RADIO ON/OFF
– switches the radio on/off; displays radio frequency
– switches off sleep timer
6
ALARM
–
switches on/off radio mode
–displays time
7
RESET –press if the set / display does not react to operation of any button
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 4
SIDE PANEL
(See 1)
8TUNING +/-
–
tunes to radio stations
9
Pigtail –improves FM reception
0DC 7.5V
–
socket for AC/DC 7.5V adapter
!SET AL / PRESET 1
–
sets AL
time
–stores, recalls and shows station 1
@SET AL / PRESET 2
–
sets AL
time
–stores, recalls and shows station 2
#MIN + / PRESET 3
–
adjusts the minutes for clock and alarm times
–stores, recalls and shows station 3
$SET TIME / PRESET 4
–sets the clock time
–stores, recalls and shows station 4
%HR + / PRESET 5
–adjusts the hours for the clock and alarm times
–stores, recalls and shows station 5
^VOLUME
–
adjusts the sound level
POWER SUPPLY
Mains adapter
1
Connect the mains adapter to the set's DC 7.5V socket and to the power
socket.
Helpful hints: To avoid damage to the set, use only the adapter supplied!
The type plate is located on the bottom of the set.
This product complies with the radio interference requirements of the
European Community.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 5
SELF-POWERED BACK-UP
The self-powered back-up conveniently allows your preset stations, alarm and clock
time settings to be stored for up to 3 minutes when there is a power interruption e.g.
AC power failure. The complete clock radio and backlight illumination will be switched
off.
If power supply returns after 3 minutes and the display shows:
•clock time blinking - indicates you need to re-adjust the clock time.
BASIC FEATURES
Reset
Should your set receive external interference e.g. static electricity from carpets, thun-
derstorms, etc. RESET allows you to clear all previous settings and start up again.
•Use a ballpoint pen to press the RESET hole found on the bottom of the set.
Illumination brightness
Press REPEAT
ALARM /
BRIGHTNESS CONTROL once or more.
•
The brightness of the display can be adjusted:
Bright ➟Low ➟Off ➟Bright
.
SETTING THE CLOCK
The time is displayed using the 24-hour clock.
1. Check the radio is switched off.
2. Press SET TIME to enter the clock setting mode.
3.
Hold down or press HR + or MIN + repeatedly to set and adjust the hours
and minutes respectively. Release HR + or MIN + when you have reached
the correct setting.
4. Press SET TIME
to confirm.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 6
RADIO
1
Press
RADIO ON/OFF
once to switch on the radio.
™
Display shows the radio frequency of the last selected waveband briefly
before returning to the clock time. Your preset station is also shown if you
are listening to a preset. (See 2)
2
Adjust the sound using VOLUME
.
3To select preset stations, press the respective PRESET button (1-5) once or
repeatedly.
4
Press
RADIO ON/OFF
to switch off.
TUNING TO RADIO STATONS
Automatic tuning
•Press TUNING +/- one second or more to tune to your station.
™The radio automatically tunes to a station of sufficient reception.
Manual tuning
•Press TUNING +/- briefly or repeatedly until you reach the desired frequency.
To improve reception:
For FM, extend and position the pigtail fully to obtain optimum reception.
STORING AND USING PRESET STATIONS
You can store up to a total of 5 FM radio stations in the memory.
1Tune to your desired station (see TUNING TO RADIO STATIONS).
2To store a preset, hold down briefly on a PRESET button 1-5 until you hear a double
beep.
™
Display shows the preset number of your station.
3Repeat steps 1 and 2 to store your other stations.
•You can overwrite a preset station by storing another frequency in its place.
4
Press a
PRESET button 1-5 to listen to a preset station.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 7
USING THE ALARM
GENERAL
Two different alarm times can be set. This can be useful when you need to be
woken up at a different time e.g. during the week and at the weekend:
•ALARM - radio mode
•ALARM - buzzer mode. The gentle wake buzzer alarm increases its beep tone
frequency within seconds.
SETTING THE ALARM TIME AND MODE
(See 3)
1. Check the radio is switched off.
2. Press ALARM or ALARM to on.
™
Display: OFF
disappears under the respective
AL
or
AL
icon.
3. Press and
hold SET AL or SET AL until alarm time digits flash.
4.
Hold down or press HR + or MIN + repeatedly to set and adjust the hours
and minutes respectively. Release HR + or MIN + when you have reached
the correct setting.
5. After both the hours and minutes are set, press
SET AL or SET AL
to
confirm the setting.
Helpful hints:
–
If you have selected ALARM ,make sure you have properly tuned to a
station before turning off the set.
–
If you set and activate the same time for both alarms, only the ALARM will be
activate at the set time.
–
When both ALARM and ALARM are turned on, by default the display
shows the alarm time nearest to activtion.
–
To check the alarm time setting for ALARM or ALARM , press ALARM or
ALARM button.
–
It is not possible to adjust the alarm time during an alarm call or the repeat alarm
mode.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 8
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24-hour ALARM RESET will be automatically selected after 59
minutes from the time your alarm first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain
the same alarm setting for the following day:
•
Press
ALARM RESET / SLEEP
.
™
You will hear a beep tone confirming 24 hour reset activation.
REPEAT ALARM
This repeats your alarm call at 9 minute intervals.
•
During the alarm call, press REPEAT
ALARM /
BRIGHTNESS CONTROL..
™
Display shows
(
AL
)
or
(
AL
)
flashing during a repeat alarm.
•
Repeat if desired (up to a maximum of 6 times).
CANCELING THE ALARM COMPLETELY
•
Press
ALARM
or
ALARM
button once or more until the OFF appears
under the respective
(
AL
)
or
(
AL
)
icon.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 9
SLEEP
(See 4)
About Sleep
This set has a built-in sleep timer, which enables the radio to be automatically
switched off after a set period of time. There are four sleep time options.
Setting and switching off SLEEP
1Within 1 second,
press
ALARM RESET / SLEEP
twice until the display shows
SLEEP and SL: 60
.
™
The radio is automatically switched on and tunes to the last station.
2To select other sleep time options, press ALARM RESET / SLEEP
again within 1
second before the display returns to clock time.
™
The display shows in sequence: SL : 30, SL : 15 and OFF.
3
To cancel sleep, press either:
–
RADIO ON/OFF
–REPEAT
ALARM /
BRIGHTNESS CONTROL.
–
ALARM RESET / SLEEP
once or more until
SLEEP
disappears from the
display.
ENVIROMENTAL INFORMATION
All unnecessary packaging material has been omitted. The packaging can
be easily separated into three materials: cardboard, polystyrene and plas-
tic.
Your set consists of materials which can be recycled if disas-
sembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging, dead batteries
and old equipment.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 10
Andere Handbücher für AJ100/12
1
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere Philips Radiowecker Handbücher
Philips
Philips AJ3915 Bedienungsanleitung
Philips
Philips AJ210/12 Bedienungsanleitung
Philips
Philips AJ3720/00S Bedienungsanleitung
Philips
Philips AJ 3040 Bedienungsanleitung
Philips
Philips AJ3260 Bedienungsanleitung
Philips
Philips AJ3280 - annexe 2 Service-Handbuch
Philips
Philips AJ3400 Bedienungsanleitung
Philips
Philips AJ7040D Bedienungsanleitung
Philips
Philips AJ3230 Bedienungsanleitung
Philips
Philips AJ3200 Bedienungsanleitung
Philips
Philips AJ3160 Bedienungsanleitung
Philips
Philips AJ3280 - annexe 2 Bedienungsanleitung
Philips
Philips AJ3138/05 Bedienungsanleitung
Philips
Philips AJ3600 Bedienungsanleitung
Philips
Philips AJ3190/00P Bedienungsanleitung
Philips
Philips AJ260/79 Bedienungsanleitung
Philips
Philips D3730 Bedienungsanleitung
Philips
Philips AJ3120 Bedienungsanleitung
Philips
Philips AJT5300/79 Bedienungsanleitung
Philips
Philips XP AJ 3430 Bedienungsanleitung
