Philips ID9370 Bedienungsanleitung

ID9370_IFU_EN_US.book Page 6 Tuesday, February 13, 2007 12:48 PM

3 Safety information

8ImportantInformation

8Foryoursafety

8NeedHelp?

9 Configure your ID9370

9 Install battery

10 Language

10 Registration

11 What’s in the box?

12 Your ID9370

12 Overview of the handset

14 Install

15 Call

17 Personal Settings

22 Advanced Settings

23 Games

25 Troubleshooting

27 Information

29 Index

Contents

ID9370_IFU_EN_US.book Page 7 Tuesday, February 13, 2007 12:48 PM

EN Important Information

For your safety

This equipment is not designed to make emergency calls in the event of a power failure.

Alternative arrangements should be made for access to emergency calls.

To avoid damage or malfunction:

- Do not allow the product to come into contact with liquid.

- Do not open it as you could be exposed to high voltages.

- Never use any battery type other than the one supplied.

- Do not hold the handset too close to your ear when the phone is ringing or when

activating the loudspeaker as it may damage your hearing.

- Do not expose the phone to excessive heat caused by heating equipment or direct

sunlight.

- Do not drop your phone or allow objects to fall on your phone.

- Do not use any cleaning agents containing alcohol, ammonia, benzene, or abrasives as these

may harm the set.

- Active mobile phones in the vicinity may cause interference.

About operating and storage temperatures:

- Operate in a place where temperature is always between 0 and 35º C (32 to 95º F).

- Store in a place where temperature is always between -20 and 45º C (-4 to 113º F).

- Battery life may be shortened in low temperature conditions.

Need Help?

For more information on troubleshooting:

Troubleshooting: page 25

Please refer to the following website for more information on Philips web support:

Online Support

www.philips.com/support

ID9370_IFU_EN_US.book Page 8 Tuesday, February 13, 2007 12:48 PM

Configure your ID9370

Install battery

Your ID9370 is supplied with 2 rechargeable batteries allowing approximately up to 12 hours of

talk-time and up to 150 hours stand-by time. Before using the handset, the batteries have to be

installed and fully charged.

1. Use the coin or screwdriver to unlock the battery cover.

2. Place the batteries as indicated and replace the cover.

3. Lock the battery cover.

screw

charger contact plate

Bottom View

Unlock

anticlockwise

charger contact plate

screw

Lock

clockwise

Bottom View

Please use a coin or screwdriver that is the right shape and size for the screw that is used.

Otherwise you may damage the screw when tightening it.

ID9370_IFU_EN_US.book Page 9 Tuesday, February 13, 2007 12:48 PM

EN Configure your ID9370

Language

Your ID9370 can support different display languages.

To change the language

1. Press mMENU, scroll : to Personal Set and press mSELECT, scroll : to Lan-

guage and press mSELECT.

2. Scroll : to your desired language and press mSELECT to confirm.

A validation tone is emitted and the screen returns to previous menu.

Registration

The procedures described below are the procedures that you will find in your ID9370 handset.

The procedures may vary according to the handset you want to register. In this case, please

refer to the manufacturer of the additional handset.

Additional handsets must be registered to the base unit before you can use them. Up to 6

handsets can be registered to one base station.

After charging it for a few minutes, the word WELCOME appears on a blue screen. Next, the

idle screen appears. Follow these steps to register your handset:

1. In idle mode, the message “Press Base page key for 3 secs. Press and hold m” will be

prompted on the screen. Follow the screen instructions to start registration.

2. Enter PIN will be displayed on your screen. Enter the default Master PIN number - 0000.

3. Press mOK to confirm your registration.

The Master PIN is required before you can register or unregister handsets. The default

PIN is 0000.

All the handset keys (except the mkey) are deactivated until the above registration

process is completed.

ID9370_IFU_EN_US.book Page 10 Tuesday, February 13, 2007 12:48 PM

What’s in the box?

The following accessories are included:

Power supply for

base station

User Guide Warranty card

Handset 2 AAA rechargeable

NiMH batteries

Splitter

ID9370_IFU_EN_US.book Page 11 Tuesday, February 13, 2007 12:48 PM

EN Your ID9370

Overview of the handset

LCD Screen

Talk key

Keypad lock key /

Format key

Up/Down Navigation

keys

Earpiece

Right Soft

key

Hang-up key

Alphanumeric keypad

Case key / Pause

key /

Intercom key

Loudspeaker key

Event LED

(top of the handset)

Left Soft key

Microphone

ID9370_IFU_EN_US.book Page 12 Tuesday, February 13, 2007 12:48 PM

Your ID9370

Handset keys

Press To

mEnter the main menu from stand-by mode.

Select the function displayed on the handset screen directly above it.

Activate mute function during a call.

Switch on the backlight.

>Go to redial list from stand-by mode.

Select the function displayed on the handset screen directly above it.

Initiate a second call, consult phonebook, call transfer or activate/deactivate

HD Sound mode during a call.

Switch on the backlight.

rAnswer an incoming external or internal call.

Insert R for operator services when on the line.

eHang up a call.

Return to stand-by mode.

Long press in stand-by mode to switch off the handset, short press to switch

on the handset again.

uAccess call log from stand-by mode.

Scroll up a menu list or go to the previous phonebook or call log record.

Increase earpiece volume during a call.

Go to the previous character in editing mode.

dAccess phonebook from stand-by mode.

Scroll down a menu list or go to the next phonebook or call log record.

Decrease earpiece volume during a call.

Go to the next character in editing mode.

cInitiate an internal call in idle mode.

Short press to initiate an internal call during a call or switch call between an

internal and external call.

Long press to initiate a conference call with an external call and another

internal call.

vAnswer an incoming call in handsfree mode.

Activate and deactivate the loudspeaker* during a call.

#Dial # in stand-by mode.

Long press to mute the ringer in stand-by mode.

Long press to insert a pause in dialling mode.

Long press to switch between upper and lower case in editing mode.

FDial * in stand-by mode.

Long press to activate and deactivate keypad lock.

Change the display format when viewing a 7-, 10- or 11-digit call log record

(with numbers starting with the digit 1).

*WARNING Handsfree activation can suddenly increase the volume in the earpiece to a

very high level. Make sure the handset is not too close to your ear.

ID9370_IFU_EN_US.book Page 13 Tuesday, February 13, 2007 12:48 PM

EN Install

Install battery

See page 9.

Charge battery

1. Place the handset on the charging cradle of the base station. A beep tone is emitted if the

handset is placed correctly.

2. A charging animation on the handset indicates that the battery is charging.

3. Leave it there until the batteries are fully charged (at least 24 hours).

4. The handset is fully charged when the charging animation stops and is displayed.

Low battery warning

The battery level is shown at the top left of the handset screen. When the battery level

becomes low, an empty battery icon is displayed on the screen.

If the battery level becomes exceedingly low, the phone automatically switches off and any

function in progress will not be saved.

Out of range warning

The indoor and outdoor range of the phone is up to 50 metres and 300 metres respectively.

When the handset moves beyond operation range, the antenna icon will blink.

Philips 1

08-08

06:00pm

REDIAL

The handset must be charged for at least 24 hours before using it for the first time.

ID9370_IFU_EN_US.book Page 14 Tuesday, February 13, 2007 12:48 PM

Call

Intercom

This feature is only available when there are at least 2 registered handsets. It allows you to make

free internal calls, transfer external calls from one handset to another and use the conference

option.

Intercom another handset

To be able to use intercommunication feature, you must have at least 2 handsets registered to

your base station (see page 10 "Registration").

1. Press ckey in stand-by mode.

2. Intercom is established immediately if there are only 2 registered handsets. If there are

more than 2 registered handsets, the handset numbers which are available for intercom

will be displayed. Scroll : to All Handsets and press mSELECT to call all the handsets

or scroll to the specific handset you want to call and press mSELECT.

Transfer an external call to another handset

1. During the call, make a long press on ckey to put the external call on hold (the caller

can no longer hear you).

2. Intercom is established immediately if there are only 2 registered handsets. If there are more

than 2 registered handsets, the handset numbers which are available for intercom will be

displayed. Scroll : to All Handsets and press mSELECT to call all the handsets or

scroll to the specific handset you want to call and press mSELECT. The called handset

rings.

3. Press rkey on the called handset to answer the internal call, where both internal call-

ers can talk.

4. Press ekey on the first handset to transfer the external call to the called handset.

Switch between an internal and external call

1. Press ckey once to switch between an internal call and external call.

If the handset does not belong to ID9370 range, this function may not be available.

If there is no answer from the called handset, press ckey to resume the external call.

ID9370_IFU_EN_US.book Page 15 Tuesday, February 13, 2007 12:48 PM

Inhaltsverzeichnis

Andere Philips Schnurloses Telefon Handbücher

Philips

Philips SE1711B/90 Bedienungsanleitung

Philips

Philips XL6651C/22 Bedienungsanleitung

Philips

Philips CD6451B Bedienungsanleitung

Philips

Philips Linea V M350 Produktinformationsblatt

Philips

Philips ID9651B/51 Bedienungsanleitung

Philips

Philips DCTG1500B/93 Bedienungsanleitung

Philips

Philips B150 Produktinformationsblatt

Philips

Philips ONIS 6510 Bedienungsanleitung

Philips

Philips CD1503B/17 Bedienungsanleitung

Philips

Philips ONIS 6816 Bedienungsanleitung

Philips

Philips D405 Bedienerhandbuch

Philips

Philips SE765 Bedienungsanleitung

Philips

Philips D235 Produktinformationsblatt

Philips

Philips CD360 Bedienungsanleitung

Philips

Philips SE1711B/DE Bedienungsanleitung

Philips

Philips CD2451S/51 Bedienungsanleitung

Philips

Philips M660 Bedienerhandbuch

Philips

Philips DECT1232S Bedienungsanleitung

Philips

Philips CD2754S/05 Bedienungsanleitung

Philips

Philips XL3401B/05 Bedienungsanleitung

Philips

Philips TD 6831 Bedienungsanleitung

Philips

Philips CD2503S/05 Bedienungsanleitung

Philips

Philips CD 690 - Bedienungsanleitung

Philips

Philips B140 Bedienerhandbuch

Beliebte Schnurloses Telefon Handbücher anderer Marken

3Com

3Com NBX Bedienungsanleitung

Panasonic

Panasonic KX-TGK210HK Bedienungsanleitung

Panasonic

Panasonic KX-TCA181EX Bedienungsanleitung

BT FREESTYLE 3200 Bedienungsanleitung

AT&T

AT&T CL84102 Bedienungsanleitung

BREZZICNI

BREZZICNI CL-3622 Bedienungsanleitung

Panasonic

Panasonic KX-TG1831NZ Bedienungsanleitung

Panasonic

Panasonic KX-TG7301E Bedienungsanleitung

Furuno

Furuno FM-4721 Bedienungsanleitung

Sanyo

Sanyo CLT-J70 Bedienungsanleitung

Amplicomms

Amplicomms BigTel 201 Bedienungsanleitung

GE 26992 Bedienungsanleitung

AT&T

AT&T E1812B Bedienungsanleitung

Sanyo

Sanyo CLT-670 Bedienungsanleitung

GE 15432970 Bedienungsanleitung

Curtis

Curtis TC595 Bedienungsanleitung

Gigaset

Gigaset Gigaset 3000 Micro Bedienungsanleitung

Poly

Poly VVX D230 Einrichtungshandbuch