Philips HQC281/60 Bedienungsanleitung

ENGLISH 4

POLSKI 14

РУССКИЙ 24

EESTI 34

LATVISKI 43

LIETUVIŠKAI 53

HQ C281

Important

◗Check if the voltage indicated on the mains

plug corresponds to the mains voltage in your

home before you connect the appliance.

◗Make sure that the appliance does not get

wet.

◗Charge and store the appliance at a

temperature between 15cand 35cC.

Charging

Charge the appliance fully before you use it for

the first time.

Make sure the appliance is switched off while

charging.

C1Insert the appliance plug into the

appliance.

2Insert the mains plug into the wall socket.

BThe pilot light will go on to indicate that the

appliance is charging.

It will take approx.12 hours to fully charge the

battery.

Do not charge the appliance for more than 24

hours.

A fully charged appliance has a cordless clipping

time of up to 35 minutes.

ENGLISH4

Corded clipping

◗To clip with the hair clipper connected to the

mains:

Switch the hair clipper off,connect it to the mains

and wait a few seconds before switching it back

on.If the battery is completely empty:wait a few

minutes before switching the appliance on.

Do not run the appliance from the mains when

the battery is fully charged.

Preparing for clipping

Clipping with comb attachment:

C1Slide the arms and the adjustment button

of the comb attachment into the guiding

grooves of the appliance.

C2Press the adjustment button on the back

of the appliance and slide the comb

attachment to the desired position (see

table).

3Release the adjustment button to lock the

comb.

4Switch the appliance on.

If a lot of hair has accumulated in the comb,

remove the comb attachment and blow and/or

shake the hair out of the comb.

ENGLISH 5

Cutting length settings

comb setting hair length

14mm

27mm

3 10 mm

4 13 mm

5 15 mm

6 18 mm

7 21 mm

Clipping without comb attachment

C1To remove the comb attachment,press the

adjustment button on the back of the

appliance and slide the comb attachment

to its final position.

C2Pull the comb attachment off the appliance

with your other hand.

Clean and recharge the appliance every time you

have used it.

Clipping techniques

Always comb the hair in the direction of growth

before clipping.

ENGLISH6

Clipping with comb attachment

The comb attachment can be used to obtain hair

lengths up to 21 mm.

◗Start at the setting for maximum hair length

(i.e.position 7) to familiarise yourself with the

clipper.

Always move against the direction of hair growth.

C◗Hold the clipper so that the flat side of the

comb attachment is parallel to the head.Move

it slowly through the hair and then away from

the head,cutting only a small amount at a

time.

◗Change the length setting (see table) to obtain

different lengths on different parts of the

head.

Cutting over styling comb or fingers

This technique can be used to obtain hair lengths

over 21 mm.

◗Remove the comb attachment.

C◗Lift a small section of hair with a styling comb

or grasp it between two fingers.

C◗Lift the hair with the comb or fingers hair so

that only the length that needs to be cut

sticks out.

◗Trim the hair protruding from the comb or

fingers.

◗Continue this procedure working against the

growth direction of the hair.

ENGLISH 7

◗Comb frequently to remove cut hair and

check for unevenly cut sections.

Outlining

◗Remove the comb attachment.

C◗Hold the clipper with the cutter pointing

downwards.

C◗Make overlapping strokes for clear outlining of

the neck and sideburns.

C◗For cutting the hair around the ears,put one

edge of the cutter on the skin.Make sure the

teeth are kept at a safe distance from the

ears.

C◗Shape the desired outline slowly and carefully.

ENGLISH8

Creating different haircuts

Crew cut

C◗Select the desired hair length for the neck

area.

C◗Clip the neck area using the "Clipping with

comb attachment" technique.

◗Adjust the length setting to the desired hair

length for the back and sides of the head.

C◗Clip the sides and back of the head leaving the

hair on top of the head uncut.

C◗For a flat top look,cut the hair on top of the

head using the "Cutting over styling comb or

fingers" technique.

◗Finish the haircut by outlining the neckline,

sideburns and the area around the ears using

the "Outlining" technique.

Short cut

C◗Select the desired hair length for the back and

the sides of the head.

ENGLISH 9

C◗Clip the back and the sides of the head using

the "Clipping with comb attachment"

technique.

◗Leave the hair on top of the head uncut.

◗Select the desired hair length for the top of

the head.

C◗Clip the top of the head using the "Clipping

with comb attachment" technique.

◗Finish the haircut by outlining the neck,

sideburns and area around the ears.

Cleaning

Do not use abrasives,scourers or liquids such as

alcohol,petrol or acetone to clean the appliance.

1Make sure the appliance is switched off

and disconnected from the mains before

you start cleaning it.

C2Remove the comb attachment.

C3Remove the cutting unit.

C4Clean the cutting unit and the inside of the

appliance with the brush supplied.

ENGLISH10

C5To reassemble the clipper,insert the hook

of the cutting unit into the housing.

6Push it back until you hear a click.

Replacement

A worn or damaged cutting unit should only be

replaced with an original Philips cutting unit.

Environment

The built-in rechargeable battery contains

substances which may pollute the environment.

Remove the rechargeable battery when you

discard the appliance.

Do not throw the battery away with the normal

household waste but dispose of it at an official

collection point.

You can also take the appliance to a Philips

Service Centre,where staff will be happy to help

you remove the battery and dispose of it in an

environmentally safe way.

1Disconnect the appliance from the mains

and let the appliance run until the motor

stops.

C2Remove the cutting unit.

ENGLISH 11

C3Remove the metal clip by means of a

screwdriver.

C4Open the housing.

C5Pull the battery holder out of the

appliance.

C6Insert a screwdriver into the small slot in

the printed circuit board marked with an

arrow.Push the screwdriver down until

part of the printed circuit board breaks

off.

C7Separate the battery from the plastic part

by means of a screwdriver.

8Dispose of the battery and the other

components in an environmentally safe

way.

Do not connect the appliance to the mains again

after it has been opened!

ENGLISH12

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Philips Haarschneider Handbücher

Philips

Philips HS015/03 Bedienungsanleitung

Philips

Philips Beolink 1000 Bedienungsanleitung

Philips

Philips QC5580/13 Bedienungsanleitung

Philips

Philips HC3409/15 Bedienungsanleitung

Philips

Philips HC3402/15 Bedienungsanleitung

Philips

Philips NORELCO CCS060 Bedienungsanleitung

Philips

Philips QC5045 Bedienungsanleitung

Philips

Philips BT1216 Bedienungsanleitung

Philips

Philips MG3710 Bedienungsanleitung

Philips

Philips QC5090 Bedienungsanleitung

Philips

Philips Norelco 7100 series Bedienungsanleitung

Philips

Philips HC5450 Bedienungsanleitung

Philips

Philips Norelco QC5130 Bedienungsanleitung

Philips

Philips HC3410 Bedienungsanleitung

Philips

Philips QC5070 Bedienungsanleitung

Philips

Philips QC5055/40 Bedienungsanleitung

Philips

Philips HC1066 Bedienungsanleitung

Philips

Philips HC5410/15 Bedienungsanleitung

Philips

Philips QC5580/15 Bedienungsanleitung

Philips

Philips QC5390 Bedienungsanleitung

Philips

Philips QC5770 Bedienungsanleitung

Philips

Philips QC5380 Bedienungsanleitung

Philips

Philips QC5015 Bedienungsanleitung

Philips

Philips QC5170 Bedienungsanleitung

Beliebte Haarschneider Handbücher anderer Marken

Clatronic

Clatronic HSM 800 Bedienungsanleitung

Mellerware

Mellerware MACRO ALDANY MA20001 Bedienungsanleitung

VALERA

VALERA X-Master 652 Bedienungsanleitung

Wahl

Wahl 1870Li Bedienungsanleitung

Remington

Remington HC5780 Bedienungsanleitung

Lister

Lister Legend Bedienungsanleitung

Andis

Andis MBA 23125 Bedienungsanleitung

Shear Magic

Shear Magic Nifty 1800 Bedienungsanleitung

Andis

Andis US-1 Kurzanleitung

Panasonic

Panasonic EH-KA81 Bedienungsanleitung

Andis

Andis US-1 Montageanleitung

Remington

Remington Classic HC450 Bedienungsanleitung

Andis

Andis ML Montageanleitung

O'Barber

O'Barber MINI SLIDE Bedienungsanleitung

Oster

Oster 76110 Bedienungsanleitung

Hyundai

Hyundai HC 420 Bedienungsanleitung

Panasonic

Panasonic ER-GP80 Bedienungsanleitung

Eldom

Eldom MG8 Bedienungsanleitung